加热

By using its own grease gun, it can flexibly apply any part that needed heating. It can apply quick heating and drying for large area, hot process of organ, firing in furnace and hot melt which is equipped a fan to produce enough hot gas from the tail-end for heating demand.

利用它可单独使用的油枪，可灵活应用在，任何所须加热加温的部位，它主要用来快速大面积加热烘干，机件热处理，炉内烧制，热熔化的应用并配有风机，使尾部输出足够的热燃气，来满足较大的用热要求。

To the flask and Condenser Horizontal and water, and ground magnetic float coat the mouth, steaming water connector and catheter installed, tightened their set screws tight, the rubber hose and gasket sets of quartz heating tube inserted mode of distillation, the fastening nut, the heating tube sign power supply cord into the outlet in the apparatus.

把各横式烧瓶和冷凝管及水位器、磨口外套磁性浮子，蒸水接头和导管安装好，拧紧各自的紧定螺丝，把橡胶管及垫片套在石英加热管分别插入模式蒸馏中，拧紧螺母，把加热管电源线插入仪器标志的插座中。

The originality of this design is that the hair drier and the electric iron have the same heating up system.

本设计基于电吹风和电熨斗的加热原理相通，加热功率相近的特点进行创新。

The effect of piston heating temperature on the piston assembling of 4125 diesel engine has been studied.

试验研究4125柴油机活塞加热温度对装配性的影响，从而降低了装配活塞的加热温度，节约了电能，改善了装配性。

Thermal heating systems and components using German HOTSET, long life, heating effect is good.

加热系统及感温元件采用德国HOTSET，使用寿命长，加热效果好。

The soluble effect of microwave heating was far superior to traditional heating, and the most suitable temperature was 90℃.

微波加热法的溶解效果远远优于传统加热法，且最佳溶解温度为90℃左右。

The experiment indicated that the impact toughness is 2. 25 times as higher as MoSi〓 heating element.

测试结果表明，复合高温加热元件的冲击韧度是MoSi〓加热元件材料的2.25倍，提高了125%。

Temperature range 40℃~100℃±1℃. Heating element in contact to device bottom side.

温度范围40℃~100℃±1℃。样品承载台上的加热装置与元件背面接触加热。

The transition zone heating device may also be a second heating element.

过渡区加热器也可以是第二加热元件。

By modulating the input powers of the two heating parts, a homogeneous temperature distribution over ?

3双轴旋转基片的均匀加热，加热器的面内温度差小于±5℃。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。