加热

Two kinds of representative CC-Repowering (feed water heating repowering,full firing repowering) were analyzed and compared in this paper. Aremarkable phenomenon was observed: Efficiency monotonouslychanges with work-ratio in FF-Repowering system; but in FWH-Repoweringsystem, there exists an optimal ratio at which point the efficiency isthe highest. Another phenomenon to be paid attention is that under somework-ratio, the efficiency of FWH-Repowering is higher than that ofFF-Repowering, giving rise to correcting the conventional concept.

本文对两种典型的联合循环系统(排气助燃型FF-Repowering和给水加热型FWH- Repowering)进行了热力学系统模拟研究，得到了随燃机汽机功比变化排气助燃型系统效率单调变化以及给水加热型系统效率存在极值点的现象，并发现了一定燃机汽机功比下给水加热型效率大于排气助燃型的特殊规律。

Using microwave-heated ceramic chips instead of standard gas flame or electric coil, the system heats pans with near-perfect balance and lets you control the heat level with incredible precision.

取代通常用的天然气火苗或者电炉丝而用微波来加热陶瓷片，这个系统近乎完美地均衡加热平底锅并且使我们能以难以置信的精确度来控制加热水平。

Air for combustion is drawn into the battery heating system,where it is heated by passing through flues in which gas was earlier burnt, then the preheated air is introduced into individual heating flues to support combustion of gas provided through jets.

燃烧所需的空气被引入焦化设备的加热系统，并使其通过其中已有燃烧着的煤气的烟道而被加热。然后，预热过的空气被导入各个加热烟道以维持由入口喷出的煤气的燃烧。

The aircraft form the structure of plate frame, of 4-and-E, heating the form of electric heating and steam heating two.

该机外型结构有框板式，鄂式和四柱式，加热形式分电加热和蒸汽加热两种。

The appropriate structural sizes of the integral induction heater for preparing glass-coated Fe-based alloy microwires are the cone angle of the induction heater 120 to 130℃, height of the induction heater 12 to 14 mm, bottom hole height 2 to 4 mm, and bottom hole radius 3 to 4 mm.

在本文研究条件下，整体感应加热器的合理结构尺寸为：感应加热器锥角120~130°，感应加热器高度12~14mm，下锥孔高度2~4mm，下锥孔半径3~4mm。

The results show that the rate of heating decreases due to the growth of oxidation layer in soaking process when the thermal resistance between gas and slab increases. The quantity of loss of iron scale increases with the increase of the coefficient of air consumption under the condition of certain soaking temperature. When the coefficient of air consumption is certain, the quantity of loss of iron scale increases with the increase of soaking temperature rapidly. The results of numerical simulation is consistent with experimental ones, and the error is very small within the range of soaking temperature in CSP line.

研究结果表明：在加热过程中生成的氧化层增大了换热热阻，使钢坯的加热速度减小；钢坯氧化烧损量随加热速度的增大而减小；当达到同一特定的均热温度时，钢坯氧化烧损量随空气消耗系数的增大近似呈线性递增；当空气消耗系数一定时，钢坯氧化烧损量随均热温度的提高而急剧增加；数值计算结果与实验结果变化趋势一致，并在CSP均热温度范围内较吻合。

The hot compress bag placed in the microwave oven, with microwave heating 3 - 5 minutes (according to various different parts of the salt packet) will be added to the hot salt bag temperature, such as the reheating temperature is too low when the heating time should not exceed 1 minutes followed by analogy (medicine bag and outer bag into the microwave oven do not heat), after the hot compress bag of microwave into the outer bag and then put hot compress parts of medicine packets according to the disease may be a long-term wear, essential oils can be with the hot compress bag or medicine bag according to the disease situation in combination.

将暖敷袋放置微波炉中，用微波加热3--5分钟（根据各种不同部位的盐包）将盐袋加至烫手的温度，如温度过低二次加热时每次加热不得超过1分钟依次类推（中药包和外袋请勿放渗透微波炉加暖），将微波后的暖敷袋放渗入渗出外袋中然后放置暖敷部位。中药包根据病情情况可长期佩带。精油可配合热敷袋或中药包根腿部吸脂减肥 168据病情情况结合使用。

Using the method of current heating in the course of creep, there are many excellences as following: Complexity of creep test device can be minished. Labor intension is weakening, speed of heating is easy to control. Period of test is reduced. Current heating method is economic than traditional heating method about 59%.

蠕变试验过程中采用电流加热的方式，不仅降低了试验设备的结构复杂性和劳动强度，而且加热速度容易控制，热能利用率高，大大缩短试验周期，较电炉加热方式节省能量消耗约为59％，具有很高的经济价值。

NBI is one of the most important methods to heating the plasma on tokamaks. It has many advantages, such as the most explicit physical mechanism, the highest heating efficiency.

中文摘要中性束注入加热是托卡马克装置上最主要的加热手段之一，其具有加热效率最高、物理机制最清楚等优点。

It is pointed out that the solidifying and stoving furnace using far IR heating provides a heating process of radiation, conduction and convection.

简介了三种适用于自行车涂装工艺中的远红外加热元件，指出由远红外加热元件所组成的固化烘道是一种辐射、传导和对流的耦合加热方式。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了