功率表

On the base of the power MIS database in the oilfield,the database of distribution line loss is constructed.Long-distance reading is applied for calculating the equation power,and the equation square root method of current is applied for the distribution line loss calculation.

在胜利油田现有的电力管理信息系统数据库的基础上，建立配电网线损计算数据库，利用胜利油田配电网广泛采用的远程抄表技术来计量各负荷点的平均有功功率、无功功率，并应用均方根电流法计算配电网线损。

In fact, power factor from loading side to power room with capacitor bank or reasonably high power factor and penalty of higher KWH price shall make the actual power bill lower than LOW power factor.

下表的计算好象是提高功率因素，降低电流及电压，理论上是节电，但是数据显示不单不节电反而用多了电，但如不算功率因素的话，节电率是27.3%。

Independent research and development company products include: fiber optic test instruments (power meter, light source, optical multimeter), video and audio Optical, fiber optic transceiver, PDH Optical Multiplexer, Protocol Converter, fiber optic network to monitor the alarm system (Master Station Software , rack light source, optical power monitoring alarm rack Miriam), optical fiber protection equipment, etc. At the same time, agents have imported products: NOYES, FOD optical test instruments, OTDR, Optical Fiber Fusion Splicer, etc..

公司自主研发生产的产品包括：光纤测试仪表（光功率计、光源、光万用表）、视音频光端机、光纤收发器、PDH光端机、协议转换器、光纤网监测告警系统（主站软件、机架光源、机架光功率监测告警仪）、光纤保护设备等，同时代理的进口产品有：NOYES、FOD光测试仪表，OTDR、光纤熔接机等。

This product include many kinds of measurement,monitoring,warining,diaplay,communication function,it can measure four quadrant reactive whole fundamental wave and time-sharing fundamental waveelectric quantity;can measure forward and reverse of the active and reactive'smaximal demand and time-sharing demand;can measure each kind of power submultiple,active power,reactive power,apparent power,and so on;can measure and record each kind of pressure loss,current loss and

本产品集各种计量、监控、报警、显示、通讯功能于一身，能计量四象限无功总基波电量及分时基波电量；能计量正反向有功和无功总最大需量及分时最大需量；能测量各相功率因数、有功功率、无功功率、视在功率等；能检测并记录各相失压、失流及三相全失压等事件；能实现远程和红外抄表、编程、监测和校准；也是电力负荷管理系统的配套终端产品。

With the measured frequency and time constant, the phase shift angle of CTs and PTs can be estimated.

提出了电能表中补偿电流互感器和电压互感器角差的有功功率和无功功率计算方法。

The instrument simultaneously sample for three phase voltage and current. Rotary photoelectric coding switch and LCD are used for human-computer interaction. it makes the interface compact and efficient. Utilizing the function of positive and negative edge trigger of the programmable counter array unit in MPU, signal zero-cross is captured for the phase detected based on double way. The software synchronism sampling method based on real-time parameter self-optimizing minishes period truncation error, and the measurement accuracy is improved. The digitization power measure imports traditional two-unit and three-unit methods and expands application range of the instrument. The capacity is discriminated by soft ware table-look-up on the load loss. The value of a quantity is converted to the value when reference temperature (75 ℃) from test temperature.

该仪器具有以下特点：仪器对三相电压电流同时采样；基于旋转式光电编码器和液晶显示屏的人机交互界面简洁而高效；可编程计数器阵列PCA"捕获"信号的过零点用于双向过零平均鉴相，得到准确的相位差和周期；基于实时参数自寻优的软件同步采样，有效地减小了周期截断误差，提高了测量准确度；数字化功率测量引入了传统的二表法和三表法，扩展了仪器的使用范围；实际容量根据负载损耗用软件查表的方法来判别；测量值已从试验温度折算到了参考温度(75℃)时的值。

In the field of measurement and display, it ranges from ampere meter, Voltage Meter and fault current state directives to power factor, wattful power, wattless power, frequency, and even harmonics, the fault condition wave acquisition, and so on.

在测量、显示这块，如电流表、电压表、故障电流及状态指示，以及功率因数、有功功率、无功功率、频率，甚至谐波，故障状态的波形捕捉等等。

This paper advances the idea of measuring power of three-phase load,by using one Wattmeter,and draws circuit.

系统研究、总结了通过使用一只瓦特表测量得出三相负载的总有功功率和无功功率的思路，并给出接线电路图。

The effects of various optical coefficients(such as scattering and absorption coefficients, anisotropy parameter, etc.) and thermophysical properties(such as surface convective coefficient, etc.) and physiological coefficients(such as blood perfusion rate and metabolic heat generation, etc.) on the thermal behavior of the LILC method wet-c discussed in detail. The results show that the size and location of cauterized tissue under the skin can be bontrolled by properly adjusting the absorption and scattering coefficients and irradiation power and so on.

在此基础上，详细讨论了散射系数、吸收系数、各向异性系数等光学参数，激光加热功率、照射半径、表而对流换热系数等热学参数，以及血液灌注率和新陈代谢等生理参数对这种低损伤加热疗法的影响，结果发现，只要通过适当调节吸收系数、散射系数和照射功率等参数就可实现对加热区域位置和范围的控制。

This thesis proposed the design and implementation of an ASIC for the motor control with DTC technology. Note that this ASIC is implemented by cell-based Design style with Verilog language.The basic principle of the Direct Torque Control is to select the switch sequence of the inverter. Those switches will control the magnetism and torque of the stator, to induce a fast response of the induction motor. Furthermore, the d-q axle's static coordinate, which is transferred from both the three-phase current and voltage, is used to compute the stator's magnetism and torque. By comparing with original values, those magnetism and torque will be calculated and set to new data. Then the switching table and the hysteresis controller are decided with the new data to generate a voltage vector and to control the stator magnetism and torque.

直接转矩控制的基本原理为经由侦测马达定子磁通与转子转速，来适当的选择变频器功率电晶体的切换状态，以获得快速且不易受外在环境影响的马达控制响应；首先，根据量测三相电流与利用变频器的切换状态取得马达的三相电压，将其转换至d-q轴静止座标，然后藉此估测马达的磁通量与转矩量，再分别与侦测的定子磁通量和转矩量比较后，得到定子磁通量与转矩量比较的结果，再利用DTC电压向量切换表(DTC Voltage Vector Switching table)，依定子磁通与转矩的比较值及马达所在的角度位置，来选择一个适当的电压向量，进而依切换顺序来激发功率电晶体，达到控制感应马达的目的。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。