功率放大器

In experiments, pressure ratio and acoustic power have been enhanced by increasing heating power and the length of acoustic pressure amplifier.

在实验研究中，通过增加声压放大器长度和加热功率，提高压比和声功。

At present, high power fiber amplifier is one of the most attractive research directions in laser fields.

中文摘要高功率光纤放大器的研究是目前激光领域比较活跃的研究方向之一。

It is very important to develop a qualified anode power supply for the operation of ICRH system.

高性能的高功率射频放大器阳极电源对整个加热系统的稳定运行起重要作用。

Silicon-germanium amplifiers can only produce about one watt of radio frequency power, versus 10 watts from a typical gallium arsenide device.

硅锗放大器只能生产约1瓦特的射频功率，与10瓦的一个典型的砷化镓器件。

A large uumber of numerical calculations using the analytic formula and the dispersion equation have been candied out on the relations of the attenuation and phase constant with wave frequency, thickness and conductivity of the lossy layer.

此式适用于截止频率附近，通过解析表达式和波导模式色散方程，对衰减常数和相位常数进行了大量数值计算，得到了它们随损耗层厚度、频率以及损耗层电导率的变化规律，两种方法所获得的结果有较好的一致性，研究表明，损耗强度和损耗层厚度的变化会改变波导中电磁模式的色散和简并特性，对于改善高功率回旋行波放大器中注波互作用带宽和模式竞争非常有益。

It locks the frequency of the carrier-wave at 35MHz.The stabilization of the carrier-wave can be 4×10-5,the accuracy can be 3×10-5.The frequency modulation and the confection of the carrier-wave are realized by the capacity-changing diode V149 and the integration voltage-control oscillator MC1648 chip.The end power amplifier uses the audion 2SC1970 to make it work in the third magnifying state,it improves the efficiency of the magnifier and the power of the output reaches the design demand.

发射部分采用锁相环式频率合成器技术， MC145152和MC12022芯片组成锁相环，将载波频率精确锁定在35MHz，输出载波的稳定度达到4×10-5，准确度达到3×10-5，由变容二极管V149和集成压控振荡器芯片MC1648实现对载波的调频调制；末级功放选用三极管2SC1970，使其工作在丙类放大状态，提高了放大器的效率，输出功率达到设计要求。

The transmit part adopts the phase-locked loop pattern of frequency synthesizing technology and uses the MC145152 and MC12022 chips to compose the phase-locked loop.It locks the frequency of the carrier-wave at 35MHz.The stabilization of the carrier-wave can be 4×10-5,the accuracy can be 3×10-5.The frequency modulation and the confection of the carrier-wave are realized by the capacity-changing diode V149 and the integration voltage-control oscillator MC1648 chip.The end power amplifier uses the audion 2SC1970 to make it work in the third magnifying state,it improves the efficiency of the magnifier and the power of the output reaches the design demand.

发射部分采用锁相环式频率合成器技术， MC145152和MC12022芯片组成锁相环，将载波频率精确锁定在35MHz，输出载波的稳定度达到4×10-5，准确度达到3×10-5，由变容二极管V149和集成压控振荡器芯片MC1648实现对载波的调频调制；末级功放选用三极管2SC1970，使其工作在丙类放大状态，提高了放大器的效率，输出功率达到设计要求。

This topic returns in view of the cut type switch spreads the type switch "to return for the predecessor design spreads the type electric power switch utilization in the LED lamps and lanterns" is the research direction, to achieve take reduces the power loss to replace the tradition operational amplifier pulse wave width accent as the goal using IC UC3842 changes part, the actuation returns spreads the type electric power switch's switch of Power MOSFET, so as to controls instead spreads the type electric power switch breakover closure's time then control voltage output size, achieves the output voltage to the load LED lamps and lanterns adjusts the LED lamps and lanterns brightness the goal.

各位大大抱歉~！因为英文底子不好！希望大家帮忙翻译一下，希望不要用翻译软体翻的最好是自己翻！拜托了！本专题针对切换式转换器的返驰式转换器为前身设计「返驰式电力转换器运用在LED灯具」为研究方向，为达到以减少功率损失为目的利用IC UC3842代替传统运算放大器脉波宽度调变部分，驱动返驰式电力转换器的Power MOSFET之开关，藉以控制反驰式电力转换器导通截止的时间进而控制电压输出的大小，输出电压至负载LED灯具达成调节LED灯具亮度的目的。

We used coupling phototube convert the voltage of reflector voltages of klystron linearly to lower voltage, and convert the lower voltages of standing wave measuring line and crystal detector inputting power linearly to higher voltages by operation amplifier. Then we inputted these voltages to computer by analog-to-digital card and plotted the graphs of working characteristics of reflecting klystron with software .

利用光电耦合器将速调管反射极高电压线性转换为低电压，同时将驻波测量线测得电场强度的电压值和晶体检波器所测得的反射式速调管输出功率的电压值通过运算放大器线性放大，然后经过模数转换卡采集到微机中，利用软件绘制出速调管的工作特性曲线。

The authors used coupling phototube convert the voltage of reflector voltages of klystron linearly to lower voltage and converted the lower voltages of standing wave measuring line and crystal detector inputting power linearly to higher voltages by operation amplifier. Then inputted these voltages to computer by analog-to-digital card and plotted the graphs of working characteristics of reflecting klystron with software.

利用光电耦合器将速调管反射极高电压线性转换为低电压，同时将驻波测量线测得电场强度的电压值和晶体检波器所测得的反射式速调管输出功率的电压值通过运算放大器线性放大，然后经过模数转换卡采集到微机中，利用软件绘制出速调管的工作特性曲线。

The reasons of iron ions content overproof in grade Ⅱ desalting water system,such as variation water quality,contamination of regenerant , operation adjustment of pretreatment system and switching operation of bed were discussed.

对二级脱盐水系统中铁离子含量超标的原因，如来水水质发生波动、再生剂受到污染、预处理系统操作调整、床体运行切换等进行了论述。

You were hired to drum up new business, so go and do it.

公司雇你招徕新业务，你就做你的事好了。