力矩的

The friction performances of carbon face were investigated with an inertia friction tester.The torque curve of carbon face was ideal,the coefficient of static friction was lower than that of dynamic in 0.28 MPa,the friction coefficient of static and dynamic decreased with the braking pressure increasing.To the fiber face,the coefficient of dynamic fric...

结果表明：碳质层的摩擦力矩在制动初期上升较快，中间过渡区平稳，尾部翘起较小；在制动压力小于0.28 MPa时静摩擦系数小于动摩擦系数，且动、静摩擦系数均随制动压力增加而减小；相对纤维层而言，采用碳质层摩擦时摩擦力矩曲线形态更好，连续制动时摩擦系数波动较小，磨损率低且能够有效保护偶件，是1种静/动摩擦系数比较低且适用于高载荷工况条件下使用的摩擦材料。

The constraint force/torque dexterousness is defined as the ratio of minimum singularity value to maximum one of the force/torque constraint matrix, by which the performance of the combinations of actuating inputs is evaluated.

将约束力/力矩矩阵的最小奇异值与最大奇异值之比定义为约束力/力矩各向同性度，并以此为指标对各驱动输入组合的优劣性进行评价。

Planet reduction shown in figure 6. Loose nut 6 "nut + washer + anti-loose nut". The explored view is Adjust torque 350~400N.m, rotate hub 13 at the same time. 5 and a radial force F=70N crease, hub can rotate free. Then fix lock washer into nut 6, fasten loose nut with torque 400N.m and make spacer control 0.05~0.15mm.

调整时，用 350~400N.m 力矩旋紧螺母 6，同时转动轮毂 13，使两轴承处于正确位置，然后，稍旋松螺母 6，在轮辋螺栓处施加一个切向力 F=55N.m，此时轮毂应能自由转动，然后装上止动垫片 5，将其卡爪折入螺母 6 的防转槽内，再用 400N.m 的力矩旋紧防松螺母，使轴向间隙控制在 0.05～0.15mm 之间。

A kind of method adopting polynomial approaches to match the nonlinear curve of looper tension moment is put forward on the base of analyses of the curve characteristic and project practice.

通过对带钢张力矩计算理论公式的分析并结合工程实际，提出了一种采用多项式逼近来拟合活套张力矩非线性曲线的方法。

Finally, simulation on the dynamic response characteristics of torque motor with magnetic fluid and without magnetic fluid is processed, and the effecting of anti-interference of torque motor with magnetic fluid is presented.

最后，对干扰信号作用下添加磁流体和不添加磁流体的力矩马达动态响应特性进行了仿真研究，给出了磁流体作用下力矩马达的抗干扰效果。

The magnetic torque is adjusted with the local geomagnetic intensity and the micro-satellite will obtain active control torque.

依据当地的地磁场强度调整磁力矩器磁矩大小，从而产生相应的磁力矩对卫星实时姿态控制。

Another controller that had moment arm information in the fuzzy control algorithm was developed.

力矩臂是肌肉的力与关节力矩之间关系的量化

The numerical results indicate that the operator splitting method effectively suppresses numerical oscillations in the cases of high air bearing number. The numerical results show that both air lift force and pitch moment increase with the ratio of the slider's rail height to the air film characteristic height and the air bearing number, and finally reaches to stable value.

比较在不同轴承数下的气浮力和纵倾力矩发现：同一轴承数下，气浮力随气膜特征厚度减小而增加；当磁头槽台高度与气膜特征厚度的比值相同时，气浮力随轴承数增大而逐渐增加直到达到某一值后保持不变；纵倾力矩随轴承数增加而增大到某个最大值后减小。

Units includes plane and solid angle units in the SI system, torque and energy are, in fact, distinguishable.

Units包含SI系统中平面和立体的角度单位，所以实际上，力矩和能量是可分辨的见力矩

Then, the friction torque to affect the ultra-low-speed tracking performance is analyzed, and a mathematical model of the servomotor with large friction torque is established.

对影响其超低速跟踪性能的摩擦力矩进行了分析，建立了大摩擦力矩条件下的中空马达数学模型。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。