英语人>网络例句>剪应变 相关的搜索结果
网络例句

剪应变

与 剪应变 相关的网络例句 [注:此内容来源于网络,仅供参考]

The main factors affecting the soil-structure interface behaviors were found experimentally and theoretically, including: 1 the thickness of the interface that is five to six times the average grain size of the soil; 2 the aeolotropy of interface, which is responsible for anisotropic response of the stress-strain response of the interface; 3 two physical states, including crashing and compression of the soil near the structure surface, which govern the stress-strain response of the interface strongly; 4 two shear deformation components due to sliding and constraint of the structure surface relative to the soil respectively, which forms the deformation of the interface; 5 the volumetric strain due to dilatancy, which is found to be composed of a reversible dilatancy component and an irreversible dilatancy component. 4. A unified constitutive model of the interface, based on new elasto-plasticity damage theory, was developed. It was confirmed to be effective for the conditions considering monotonic and cyclic shearing, coupling effect of shear and volumetric strains, evolution of physical state, micro-structure aeolotropy of the soil and the resulting aeolotropy of the interface as well as the three normal boundary conditions stated above. 5. 2D and 3D finite element formulations of the present model were derived and incorporated into the FEM codes. They were applied to the evaluation of practical engineering problems with different typical interfaces between soil and structure. The new model was shown to be reasonable and effective.

确定了粗粒土与结构接触面厚度约为5~6倍的平均粒径,首次揭示了接触面的细观结构异向性以及由此所引起的宏观剪切异向性,发现了在单调和往返剪切荷载作用下土颗粒破碎和剪切压密两种物态变化机制共同支配着接触面力学性质的变化,通过细观分析证实了接触面的变形可分解为一般同时发生的土与结构交界面上的滑移变形以及结构面位移约束范围之内土体本身的剪切变形两部分,观测到接触面受剪时表现出明显的相对法向位移,并可分解为可逆性和不可逆性两个分量;(4)建立了第一个能够统一地描述单调与往返剪切特性、剪应变与体应变耦合特性、细观结构和宏观剪切异向性以及土颗粒破碎等物态变化特性的土与结构接触面弹塑性损伤本构数学模型,并采用多种法向边界条件复杂加载路径的试验成果验证了新模型的合理性和有效性;(5)提出了新模型的二、三维有限元格式并结合实际边值问题进行了应用计算分析,比较了不同接触面本构模型对计算结果的影响,证实了新模型及其有限元格式不仅能够合理地描述土与结构接触面的主要力学特性,还能够较好地反映土体与结构物在接触面处的滑移、脱开等不连续现象。

Form the result of this study, it is found that the threshold shearing strain increases with admixed od cement.

现地土壤和水泥改良土的动态剪力模数随著剪应变的增加而减少,阻尼比随著剪应变的增加而增加。

By comparing the landslide displacement and the shearing strain increment under different water level condition, discovered that along with the rising water level, the displacement and the shearing strain increment of Taping landslide are obviously increased, it is show that the landslide has the obvious response to the storage, the water rise cause the stability of landslide present the reduction tendency.

通过不同水位状态下滑坡位移和剪应变增量的分析,发现,随着水位的上升,塔坪滑坡的位移及剪应变增量都明显增大,说明滑坡对蓄水有明显的响应,水位上升使滑坡的稳定性有降低的趋势。

In this paper, based on the triaxial test, it is discovered that the structured loess has special mechanical effect of shearing strain rate, and it is proved that the structured loess also has the phenomena of strain rate softening. The CU shear strength and cohesion c increase at first, then decrease with the increase of strain rate, and a critical rate exists; the angel of internal friction doesn't change visibly with the strain rate.

通过结构性黄土三轴试验研究,发现结构性黄土具有独特的剪应变速率力学效应,"应变速率软化"现象同样存在于结构性黄土中;其CU剪切强度和凝聚力c随剪应变率的增大而呈现先增大后减小的特征,存在临界速率现象,而内摩擦角随剪切速率的增大基本上呈线性减小的趋势。

Firstly, we collected and sorted out the GPS data, established the uniform velocity field for the Chinese mainland and the surrounding regions, and the horizontal deformation field relative to the Eurasia plate; Secondly, we established a motion model for the entire rotation and homogeneous strain of the first and second level blocks in Chinese mainland, analyzed the motion pattern and strain behavior of active blocks in Chinese mainland, as well as the motion pattern of principal fault zones in Chinese mainland; Thirdly, considering the heterogeneity of strain distribution inside a block and supposing that the strain tensor inside the block is the linear function of location, we derived and established an equation for the entire rotation and linear strain of block and a motion model for the entire rotation and linear strain of principal blocks in Chinese mainland; We also calculated the principal strain field and the maximum shear strain field in Chinese mainland and the surrounding regions, analyzed the basic characteristics of strain field in Chinese mainland, as well as the relationship between the spatial distribution of strain field and large tectonic zones; Finally, we established the 2-D geotectonic model and digital model for Chinese mainland and the surrounding regions, calculated the stress field in Chinese mainland and the surrounding regions, and analyzed the basic features of stress field in Chinese mainland and the principal driving force for the motion and deformation in Chinese mainland.

收集整理了已有GPS资料,建立了中国大陆及周边地区统一的速度场以及相对欧亚板块的水平形变场;建立了中国大陆一、二级地块整体旋转与均匀应变的运动模型;分析了中国大陆活动地块的运动状态,应变状态,以及中国大陆主要断裂带的运动状态;考虑到一个块体内部应变张量空间分布的非均匀性,假设块体内部的应变张量是位置的线性函数,推导建立了块体整体旋转与线性应变方程,建立了中国大陆主要地块整体旋转与线性应变的运动模型;计算了中国大陆及周边地区的主应变场与最大剪应变场,分析了中国大陆应变场的基本特征,以及应变场的空间分布与大型构造带的关系;建立了中国大陆及周边地区二维的地质构造模型和数值模型,计算了中国大陆及周边地区的应力场,分析了中国大陆应力场的基本特征以及中国大陆运动、形变的主要驱动力。

Maximum shear stress may be transfered into maximum shear strain by simple cyclic constitutive relation for low-cycle fatigue of controlling strain. Manson-Coffin type equation is derived by considering effect of nonproportional additional hardening.

对于应变控制的低周疲劳,最大剪应力参量通过简单的循环本构关系转换为最大剪应变参量,由此导出了Manson—Coffin型的公式,考虑了非比例循环附加强化对低周疲劳寿命的影响。

Again, I maintain that we should use the flexural-tensile strain and the vertical shearing stress of the bottom of cover of the joint as the target for the design of the cover structure of asphalt on the old cement concrete. In addition, on the basis of much theoretical analysis, I preliminarily put forward to a designing methods to anchor the old cement concrete road by using dog irons made of iron bars and then covering it using asphalt concrete structure. Finally, through selecting the plan of the cover of the road to be experimented, and making a detailed introduction to the techniques of construction according to the result of theoretical analysis, I know that after anchoring the slabs close to each other with dog irons made of iron, and then cover them using asphalt cement concrete has an obvious effect on preventing and slowing down the reflection cracks in the bituminous concrete skin coat over the old road.

在大量分析的基础上提出了马钉锚固罩面结构中相邻两块水泥混凝土板接缝处的相对水平位移、相对垂直位移、接缝处沥青层底部的弯拉应变和剪应变的计算公式;再次,提出了采用接缝处罩面层底部的弯拉应变、垂直剪应变作为旧水泥混凝土路面上沥青混凝土罩面结构的设计指标,并在大量理论分析的基础上,初步提出了马钉锚固旧水泥混凝土板后沥青混凝土罩面结构的设计方法;最后,根据理论分析的结果,选定试验路的罩面方案,并对其施工工艺进行了详细的介绍,表明采用钢筋马钉锚固相邻混凝土板后,再进行沥青混凝土罩面的方法在防止或减缓罩面层反射裂缝方面具有明显的效果。

The detachment fault zone is a low temperature shear zone with top to the E to SE extensional shearing and has typical S-L mylonites with both shearing and flattening strains.

拆离断层带是一个上盘向E到SE伸展剪切的低温剪切带,由具有剪应变和压应变的典型SL糜棱岩构成。

The developments of four strain components and the volumetric strain with number of cycles, the relationship between shear stress and shear strain and the effects of deviatoric stress and effective mean normal stress were studied.

着重分析了4个应变分量及体应变随应力主轴循环旋转周数的变化关系、剪应力剪应变关系以及所施加的剪应力水平和有效球应力在应力主轴循环旋转过程中对砂土变形特性的影响。

The fundamental feature of this procedure is the modified relationship of stress and strain by residual shear strain potential and residual volumetric strain potential in dynamic time-history analysis. In the meanwhile, the effect of the residual dynamic pore water pressure on the maximum shear modulus is considered.

该方法在动力时程分析中重点考虑了逐渐累积的残余剪应变和残余体应变对应力应变关系的软化效应,同时考虑了各时段残余振动孔压引起的最大动剪切模量的衰减效应。

第1/17页 1 2 3 4 5 6 7 8 9 ... > 尾页
推荐网络例句

However, as the name(read-only memory)implies, CD disks cannot be written onorchanged in any way.

然而,正如其名字所指出的那样,CD盘不能写,也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口,替代木托盘,免薰蒸,符合欧盟、北美各国对出口货物包装材料的法令要求;喷涂钢托盘适用于重载上货架之用,托盘表面根据需要制作成平板状、波纹状及间隔形式,满足不同的使用要求。

A single payment file can be uploaded from an ERP system to effect all pan-China RMB payments and overseas payments in all currencies.

付款指令文件可从您的 ERP 系统上传到我们的电子银行系统来只是国内及对海外各种币种付款。