英语人>网络例句>剪切强度 相关的搜索结果
网络例句

剪切强度

与 剪切强度 相关的网络例句 [注:此内容来源于网络,仅供参考]

S The effect of the recessing length on the strength and stress distribution of adhesively bonded single lap joints was discussed .

研究了在单搭接接头上,胶缝中预留的不同长度间隙对接头剪切强度和剪切应力分布的影响。

Based on the analysis of the modified surface of fiber by ESCA, the effects of treatment parameters on the properties of PET/epoxy composite are examined in terms of interlaminar shear strength and transverse tensile strength.

研究了冷等离子体处理工艺参数对 PET纤维/环氧复合材料界面剪切强度、横向拉伸强度的影响。

It was found that the adhesive tensile and shear strength of the modified epoxy resin was increased.

实验表明:预聚体的加入明显提高了环氧树脂的粘接剪切强度和拉伸强度。

In this paper, based on the triaxial test, it is discovered that the structured loess has special mechanical effect of shearing strain rate, and it is proved that the structured loess also has the phenomena of strain rate softening. The CU shear strength and cohesion c increase at first, then decrease with the increase of strain rate, and a critical rate exists; the angel of internal friction doesn't change visibly with the strain rate.

通过结构性黄土三轴试验研究,发现结构性黄土具有独特的剪应变速率力学效应,"应变速率软化"现象同样存在于结构性黄土中;其CU剪切强度和凝聚力c随剪应变率的增大而呈现先增大后减小的特征,存在临界速率现象,而内摩擦角随剪切速率的增大基本上呈线性减小的趋势。

Strength is the ability of a metal to as tensile strength,bending strength,compressive strength,torsional strength,shear strength and fatigue strength.

强度对于金属而言的能力就可以说是拉伸强度,弯曲强度,抗压强度,扭转强度,剪切强度和抗疲劳强度。

Before 24 weeks of result hydrolyze, PLGA quality change is not big, subsequently quality decreases quicken; to stick all molecular volume drops in before 12 weeks of degradation faster, 24 weeks when subsequently degradation speed decelerates; degradation inside, flexural strength and shear strength all are more than bone coriaceous intensity.

结果水解的前24周,PLGA质量变化不大,随后质量减少加速;粘均分子量在降解的前12周下降较快,随后降解速度减慢;降解的24周内,弯曲强度和剪切强度均大于骨皮质强度。

The Solidification temperature range was defined as 110-200℃ by DSC analysis. More accelerant used can increase the casing samples dynamic performance, but more than enough accelerant can induce a severe solidified reaction that result in a smaller polymeric meshwork and reducing the sample's performance. Normally the Accelerant dosage can be 2 portions; The Epoxy resin CFRP has a obvious better performances than the Vinyl-ester Resin CFRP, i.e. had a Bend Strength of 1516MPa, LSS of 85MPa, also Tg raised to 195~C~ When used the end-carboxyl polyether to reinforce the epoxy resin, the casing sample's SS, BS and Crack Elongation all increased geminately. The CFRP performance also increased a little, that is because the performance of the CFRP mainly contributed by the CF. The reinforced resin improved the interface between the CF and resin that contribute to the little increasing.

通过DSC分析确定了该环氧树脂的固化温度范围为110~200℃,促进剂增加会提高浇注体力学性能,但过多的促进剂会使固化反应剧烈,聚合网络减小,使浇注体性能下降,一般用量为2份左右;以环氧树脂为基体的复合材料性能明显比以乙烯基酯树脂的性能提高,弯曲强度达到1516MPa,层间剪切强度达到85MPa,同时Tg也上升到195℃;用端羧基聚醚增韧环氧树脂后,其浇注体的拉伸强度、弯曲强度及断裂伸长都成倍增加,复合材料的性能也有所提高,但提高幅度不大,因为复合材料的力学性能主要由碳纤维承担,树脂增韧后改善了复合材料的界面性能。

For a tank foundation with a relatively thin soft deposit and undrained shear strength increasing with depth,the edge shear failure is likely to be the critical one.

一罐基础和较薄的柔软的存款和不排水剪切强度随深度增加,边缘的剪切破坏可能是至关重要的。

Using high frequency induction brazing and TiZrNiCu filler metal, the shear strengths of the joints were low. The maximum shear strengh was only 102.1MPa, which was lower than the maximum strength of vacuum brazing. The reasons may be that excessive intermetallics, holes and oxidation existed in the joint. So TiZrNiCu filler metal isn't fit for non-vacuum brazing.The stress variation, stress distribution and crack-sensitive regions during the cooling process of brazing have been studied by Marc non-linear software.

采用气体保护高频感应加热、TiZrNiCu钎料钎焊时,接头的强度普遍偏低,最高的剪切强度只有102.1MPa,远远低于辐射加热真空钎焊的强度,其原因是接头中局部生成了过量的金属间化合物,且产生氧化,接头中含有较多的气孔等影响了接头强度,因此可以认为TiZrNiCu钎料不适合在非真空条件下的钎焊。

Effect of organic fillers added to Urea-formaldehyde resin adhesives on shear strength and water-resistance was discussed.

主要研究了有机填料对脲醛树脂胶的剪切强度、耐水剪切强度的影响。

第3/17页 首页 < 1 2 3 4 5 6 7 8 9 ... > 尾页
推荐网络例句

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸,那乌黑、忧郁的眼睛,她便会相信,他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失

But because of its youthful corporate culture—most people are hustled out of the door in their mid-40s—it had no one to send.

但是因为该公司年轻的企业文化——大多数员工在40来岁的时候都被请出公司——一时间没有好的人选。