剪切强度

By using the swirling strength method,the vortex structures excluded the effect of shear were shown clearly,and were concentrated in the coniform area of the central mixing flow field.With increasing Reynolds number,swirling strength increased and the coniform area became narrow.

利用旋涡强度法分析流场清楚地显示出排除了剪切作用的涡结构主要集中在混合层中心的锥形区域，随着Reynolds数的增大，旋涡强度的值不断增大而锥形区域不断变窄。

The paper discusses the grain compressibility,crushability,shearing and strength characteristics of coral sand and points out that it has the characteristics of high porosity ratio,high friction angle and low strength.

特殊的物质组成、结构和发育环境导致珊瑚砂具有独特的工程性质。文章综述了珊瑚砂的压缩性、破碎性、剪切特性和强度特性，指出了其显著的土力学特点：高孔隙比、高摩擦角和低强度值。

The shear moduli in two directions were assumed to vary in terms with hyperbolic function .

假设剪切模量沿着梯度方向都按双曲函数变化，采用积分变换-对偶积分方程方法，求得了裂纹尖端应力场和应力强度因子，并研究了材料不均匀参数对应力强度因子的影响。

The mixed boundary problem was reduced to a system of singular integral equations by means of Fourier transform.

利用Fourier积分变换技术将混合边值问题转化为一对奇异积分方程，通过数值求解奇异积分方程获得含裂纹功能梯度板条分别在剪切和法向载荷作用下的I型和Ⅱ型应力强度因子，并讨论了材料的非均匀性和裂纹相对尺寸对裂纹尖端应力强度因子的影响。

The apparatus for static and dynamic universal triaxial and torsional shear soil testing is employed to perform stress-controlled cyclic coupled vertical and torsional shear test by different cyclic stress paths. Through a series of tests on saturated clay, the dynamic deformation, stress-strain relationship and dynamic strength are systematically investigated under rotation of principal stress axes.

针对饱和黏土，利用土工静力－动力液压三轴－扭转多功能扭剪仪进行了均等固结下的耦合循环剪切试验，着重研究了不同循环应力路径对应力－应变关系和强度特性的影响。

Three optimal structures were gotten in this paper by the model of elastic modulus along the grain, elastic modulus in tangential direction, in-plane shearing modulus and laminate rigid:①0/90/0/90/0/90/0/90/0, the outside four veneer is modified, the along grain MOE and MOR are 8377MPa, 60.9MPa respectively; The across grain MOR is 35.1 MPa, and TS is 17.2%.

4通过应用杨木单板顺纹弹性模量、横纹弹性模量、面内剪切模量及层合板刚度模型进行杉木胶合板结构设计，经多次修正，得出较好结构有以下几组：①0/90/0/90/0/90/0/90/0，最外四层为杉木改性单板，顺纹弹性模量和静曲强度分别达到了8377MPa，60.9MPa；横纹静曲强度为35.1 MPa，吸水厚度膨胀率为17.2%。

Changes in rheological properties and structure of shark fin s(gel strength,maximum breakage strain,shearing strength and fracture stress) were studied on shark fin s heated for various periods(1h,2h,3h,and 4h)by a texture meter.

研究了鱼翅在不同加热时间(1、2、3、4 h)条件下组织构造及其物性学参数(凝胶强度、最大破断应变、剪切应力、破断强度)变化，并测定了胶原蛋白含量。

Changes in rheological properties and structure of shark fins (gel strength, maximum breakage strain, shearing strength and fracture stress) were studied on shark fins heated for various periods (1h, 2h, 3h, and 4h) by a texture meter.

研究了鱼翅在不同加热时间(1、2、3、4h)条件下组织构造及其物性学参数（凝胶强度、最大破断应变、剪切应力、破断强度）变化，并测定了胶原蛋白含量。

Static Triaxial Shear test is often used to determine soil shear strengthen.

静三轴剪切试验是工程上常用的测定土的抗剪强度的试验方法。

Results: With zinc polycarboxylic cement molecular weights and sintering temperature of powder in creasing.

结果：水门汀压缩强度和对牙釉质的剪切粘接强度随共聚物分子量增加而增加，但当共聚物分子量增加到5.2×10^4了以后，水门汀就不能使用。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失