剪下

Lower plate rocks possess high temperature structures and L or L〉〉S mylonites with left-lateral strike-slip shear sense.

下盘岩石包括具有高温构造组合，具有指示左行走滑剪切运动方向的L型糜棱岩或L〉〉S型糜棱岩。

Child scissors taipans both under the realistic graphics and image, they have to use skilled civil paper-cut technique, the tentacles of animals, the characters hair, plant growth dynamics, the more subtle cut child care more vividly.

大班幼儿剪刀下的图形既逼真又形象，他们已经能熟练地运用民间剪纸技法，动物的触角，人物的发丝，植物的生长动态，越是细微之处幼儿越是剪得惟妙惟肖。

the flat enamel surfaces treated in subarid were significantly different from other conditions.

牙釉质表面在半干燥条件下的即刻和24 h测试组的剪切强度值最大。

The flat enamel surfaces treated in subarid were significantly different from other conditions. The shear of imme????

牙釉质表面在半干燥条件下的即刻和24 h测试组的剪切强度值最大。

The results indicate that the spalling behavior of oxide scale is the result of the inner and outer stress together,during rolling,the oxide scale cracks under the growth stress and thermal stress,at the same time the oxide scale also mainly undergoes alternative shearing stress in the rolling zone,the oxide scale spalls,then the reason of stripspalling is also analyzed.

结果表明：氧化膜剥落过程是内外应力联合作用的结果，轧制过程中氧化膜在长大应力和热应力作用下开裂，在轧制区内氧化膜还因受沿轧辊圆周方向的交变剪切应力作用而剥落。

The average particle sizes of PUDs were mostly in the range of 90-150 nm and the viscosities of PUDs were mostly less than 500 mPas at the stir speed of 12r/min.

PUD的平均粒径在90~150nm，12r/min搅拌速率下的剪切黏度绝大多数在500mPas以下。

Shear strength and fracture photograms of SnAgCu/Cu and SnAgCu/Au/Ni/Cu surface mounted soldered joint s stored at high temperature were investigated.

研究了SnAgCu/Cu及SnAgCu/Au/Ni/Cu表面贴装元件焊点在高温存贮试验条件下抗剪强度的变化规律。

A series of spot welding technology and joint tensile-shear tests for uncoated low carbon, electroplated and two kinds of hot dipped zinc-coated steels were made to improve the quality of spot welding joint for zinc-coated steels. The test results were analyzed with computer regressive method. The effects of welding current or time on nugget diameter or joint tensile-shear strength and critical curves in splash generation for spot welding were obtained.

摘 要：为提高镀锌钢板点焊接头的质量，对普通冷轧钢板、电镀锌钢板和两种镀锌层厚度不同的热镀锌钢板进行了一组点焊工艺及接点强度试验，并对试验结果进行了计算机回归分析，分别得出了这几种材料在不同的焊接电流、焊接时间下的点焊熔核直径或接头拉剪强度变化曲线以及点焊飞溅临界曲线。

The paper examines the load and strain data from a series of single shear pull-off tests,in which CFRP sheet is used to strengthen the concrete with different bond surface treatments.

着重根据粘结－滑移关系曲线分析在不同应力作用下碳纤维布复合材料的应变和应力分布，以及剪应力在界面的传力机理。

Experimental investigation on water-bearing crude oil flowing in pipe is discussed in this paper.

experimental investigation ；应用细管式流变仪对含水稠油流变性进行了实验研究，得出不同温度、不同含水率以及不同剪切率下的流变规律和计算方法。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。