剪下

Injection molding feed of Fe-Ni-Cu-C alloy coarse powder with particle size of 60um was prepared, effect of rate of shear, temperature and proportion of powder and binder to rheological behavior of feed was studied, viscosity number of three kinds of feed in different temperature was measured by capillary viscosimeter strain sensitivity factor three kinds of feed with different component were compared.

制备了平均粒度为60m的Fe-Ni-Cu-C合金粗粉汁射成形喂料，研究了剪切速率、温度、粉末和粘结剂比例对喂料流变行为的影响，应用毛细管粘度计测量了三种喂料在不同温度下的粘度值，比较了三种不同成分喂料的应变敏感性因子的大小。

When the rotor is high-speed rotating as the pump shaft, the fluid in flow channel forms the pump-up-flow under the influence of the shear and viscous force.

转子随泵轴做高速旋转，流道内的流体在剪力和黏性力的作用下形成"泵送"流。

DESCRIPTION】the ingredients of the product comes from abyssopelagic fishes of special pure and clean sea areas, adopting Limited Enzymic Degraded Technology, a self-owned intellectual property, that is using compound bioenzyme preparations at a low temperature to extract active ingredients through a special low-temperature extraction process and specific sheared protein to ensure the bioactivity of Collagen.

本品原料来自纯净、无污染的特定海域中的深海鱼类，采用具有自主知识产权的限制性酶切制备多肽技术（Limited Enzymic Degraded Technology），在低温下使用复合生物酶制剂，通过特殊低温萃取工艺提取有效成分，通过特异性的剪切蛋白质，保证了胶原蛋白原有的生物活性，并将原分子量为30万左右的胶原蛋白分子降解成3500左右的胶原蛋白多肽（约含30个左右的氨基酸残基），其分子长度降至30—50nm，集中度达到99.5%以上，呈白色或淡黄色，无异味，无杂物，不添加任何激素和化学物质，没有任何毒副作用。

In order to investigate buckling mode, buckling load and failure mode of structure, shear experiments were conducted for stiffened thin-walled composite plate. Finite element method was also used to analyze the buckling behavior of that composite structure. Analysis results reveal buckling mode and buckling loading of finite element analysis are accordable with experimental results.

通过对复合材料薄壁加筋板结构进行剪切载荷下的屈曲试验研究，得到结构的屈曲模态、屈曲失稳载荷以及破坏形式，并通过有限元方法对结构的屈曲进行数值分析，分析得到的复合材料薄壁加筋板结构的屈曲模态和试验结果一致，屈曲载荷与试验结果吻合较好。

Because of the assemble-ease characteristic of oxide, the adscititious powder agglomerates added into Al melt have a bigger size and need more time to finishing the in-situ reaction in mixing melt.

搅拌设备的特殊之处在于使用了振荡筛分散加入粉末和更换组合式搅拌器来提高对混合熔体的剪切效果，工艺的特别之处在于一定温度下的保温搅拌过程，这二者均能提高强化相在纯Al基体中的均匀分布。

Modification of soy protein concentration was studied under the condition of heating , shearing and alkalescent.

本文在加热、剪切和弱碱条件下对醇法浓缩蛋白的改性进行了研究，结果表明，大豆浓缩蛋白经过改性后能拓宽大豆浓缩蛋白在食品工业中的应用及达到人们所希望的功能特性。

The anisotropical characteristics of metal rubber elements performed under loadings in different directions were researched, and physical hypothesis were provided for the analysis of inner structure of metal rubber material The main parameters for the analysis of anisotropical performance were confirmed according to the previous hypothesis and tested experimentallyThe results show that variety of the relative heights and the radius of MR elements affect the radial stiffness of MR isolator When isola...

研究了金属橡胶构件在不同方向的载荷作用下表现出来的各向异性，提出了用于分析金属橡胶材料内部结构的物理假设，并根据假设确定了各向异性研究的主要参数，然后通过实验研究进行了验证。实验结果表明，如果改变金属橡胶元件的相对高度，增加径向尺寸可以在很大范围内改变金属橡胶隔振器的径向刚度；要使金属橡胶隔振器的力学特性更近于线性，应让隔振器在径向范围内工作；如果隔振系统中含有多个承受压载荷的金属橡胶隔振器，则可以使其工作在与成型压力方向相垂直的方向。当相同结构和尺寸的钢元件和金属橡胶元件在承受剪切载荷作用时，这两种材料表现出了相同的刚度变化趋势。

The author suppose, the anisotropically undrained shear strength is applied for the first time in the analysis of resistant heave stability for deep braced excavations in the world, the safety factors of two kinds of stability failure are gained, the first kind of factor is stability against sliding, the second is losing the ultimate bearing capacity.

在国内外首次将各向异性不排水剪强度应用到深基坑抗隆起稳定分析中，推导抗滑稳定破坏（包括浅桩支护及刚性支护）和丧失极限承载力破坏两种情况下的稳定安全系数公式，对典型上海软土的模型参数进行计算分析，并对各参数对安全系数的影响进行讨论，最后以三个工程实例加以验证。

No Ⅲ° atrioventricular conduction block happened, 9 patients developed right bundle branch block, and 2 patients showed junctional rhythm. Two patients with perimembranous extending outlet were repaired because of residual shunt(0.4cm,0.3cm) on the anterosuperior rim of defect. One patient with trivial residual shunt(0.15cm) on the posteroinferior rim of defect was found closed spontaneously six months later. Tricuspid valve was incised in 10 patients of VSD sextending outlet,8 patients vertical to the valve ring,2 patients parallel to the valve ring. Moderate tricuspid valve regurgitation was found in 1 patient, mild in 5 patients, trivial in 4 patients. No one aggravated. One patient complicated with pericardial effusion.

无Ⅲ°房室传导阻滞发生，9例发生右束支传导阻滞，2例结性心律。2例膜周偏流出道型VSD患者因前上缘残余分流分别为0.4cm和0.3cm，再次手术修补；1例后下缘残留细束样分流，直径0.15cm，随访6个月后自愈；10例膜周偏流出道型VSD患者剪开三尖瓣，8例垂直瓣环，2例平行瓣环；1例三尖瓣中度反流，随访无加重；5例轻度反流，4例轻微反流，随访均无加重；1例心包积液；1例再次进入手术室止血。

The role of adiabatic shear bands within fragments of tubular steel ballistically loaded by explosive is investigated.

研究钢管在爆炸加载条件下绝热剪切带的作用。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。