剪

S The effect of the recessing length on the strength and stress distribution of adhesively bonded single lap joints was discussed .

研究了在单搭接接头上，胶缝中预留的不同长度间隙对接头剪切强度和剪切应力分布的影响。

The temperature in the shear band during the adiabatic shearing deformation is about 796℃.

绝热剪切变形过程中剪切带内的温度约为796℃。

The text is also mentioned some key technique about the integral of the chart, the selecting of the peak of chromatogram, the cutting of the peak of solvent and the afterbody of the chromatogram, the enactment and computing of compared chromatogram, the matching of chromatogram, and the synthesizing of the compared chromatogram.

详细论述了谱图的积分与色谱峰的挑选、溶剂峰剪切与尾部剪切、参比色谱峰的设定与相对计算、谱峰匹配、对照指纹图谱的生成等几项软件关键技术。

This new scheme suggests that a shear and/or bending deflection would be allowed to take place freely in the specific part of the anchor rod which lies between the structure and the rock mass.

此方案在结构与岩体间保持一段可以自由剪切和弯曲的锚杆段，该锚杆段的长度称为自由长度。通过对闸墙受渗透压力、闸墙自重和温度等荷载的分析，发现锚杆自由长度对锚杆轴力的影响较小，而对锚杆剪力的影响很大。

This paper solved the optimum installed angle anchor bar in anchored joint by considering the shear dilatatility of joint and utlizing the Mises yield criterion.

本文根据基本理论分析，考虑节理的剪胀效应并利用 Mises屈服准则求解得出了加锚节理面抗剪的最优安装角。

Base on the study about precious metal mineralization and ore-controlling structures , it is realized that ductile shear zones, especially those developed in the Archean granite-greenstone belt, are the most important ore-controlling structures .

国内外贵金属与控矿构造研究表明，韧性剪切带，特别是发育在太古宙古老陆核花岗—绿岩地体中的韧性剪切带是最重要的控矿构造。

In fact, thefriction force is created by two asliects: one is the fluid shearing stress , the second is the shearingeffect of the asperities between the surfaces.

实际上，活塞环－缸套间的摩擦力产生于两个方面，一是粘性流体的剪应力，二是摩擦界面相互接触峰元的剪切作用。

Through the results from finite-element package, real distributes of shear stresses at the bonded plate/concrete interface are found. According to this, the assumption and the formula are amended.

通过有限元分析方法，得到了外粘钢板与混凝土之间剪应力的分布规律，并据此对外粘钢板与混凝土之间剪应力的分布假定进行了修正，得到了修正的锚固长度计算公式。

An asymptotic series solution is constructed by the perturbation technique of deflection type for postbuckling behavior of the plates with four simply supported edges in biaxial compression.

基於Reissner剪切板理论和Karman型板的精化理论，导出了反对称斜交铺层剪切矩形板的广义Karman大挠度方程，并运用位移型摄动技术，构造出双向压缩四边简支矩形板的后屈曲渐近级数解。

By testing the free response of MRE, the eigenfrequency and the attenuation factor of the structure were obtained.

实验结果指出，实验结构的无阻尼固有频率和MRE的剪切模量随着磁场的增加而增加直到磁饱和；实验结构的阻尼比和MRE的损耗因子随着磁场的增加极缓慢的减小；MRE在磁场作用下，剪切模量变化最大为60％。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。