剥落

Finish:漆层 To protective material used in surfacing and finishing flake off.

用于保护表面材料的涂层或保护层因失去黏附力而剥落，脱落。

Three years guarantee against natural chip, peel, flake or colour loss.Average wear out period is eight years.

处理后之洁具表面，在正常情况下使用，使证三年内不会褪色及剥落或龟裂，适当护理之翻新洁具平均使用期约八年之久。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.08-0.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.02-0.05 and 0.2 mm^3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2立方公厘左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.080.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.020.05 and 0.2 mm3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2 mm3左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

With advanced production equipment ."Golden Flatiron King" brand welding mouths with well-coated tin enjoy long service life and satisfactory function.

公司生产的"金烙王"牌焊嘴具有使用寿命长、性能好、挂锡好、镀层不剥落、导热性好、升温快、节省电能等优点。

Original height 146.5 meters, because the year long time makes decent, the peak flakes 10 meters, present height 136.5 meters; Foundation each length of side more than 230 rice, triangle surface ascent 52 degrees, tower floor space 52,900 square meters; The tower body builds by 2,300,000 stones, each stone average weight 2.5 tons, some amount to several dozens tons again; Some scholars estimated, if ships pyramid's stone material with the train, must use 600,000 freight cars approximately; If chisels garrulously these stones, the shop becomes a foot wide path, may circle an Earth week approximately.

原高146.5米，因年久风化，顶端剥落10米，现高136.5米；底座每边长230多米，三角面斜度52度，塔底面积5.29万平方米；塔身由230万块石头砌成，每块石头平均重2.5吨，有的重达几十吨；有学者估计，如果用火车装运金字塔的石料，大约要用60万节车皮；如果把这些石头凿碎，铺成一条一尺宽的道路，大约可以绕地球一周。

Overnight beating in the years lake, Gean Petals across the water, peel off the false impression that the wind was irreversible, and air Gezhuo a dream like a scattered mind deep depression.

朝夕跳动在岁月的湖面上，隔岸的落花划过水面，假象剥落了那不可逆转的风，空搁着一棵梦一样的心错落了一场深深的抑郁。

His base was compounded out of gesso, pitch, and mastic, and has not proved durable.

颜料不久后就开始松脱剥落，西元1517年，人们注意到腐蚀的过程已经开始了。

This article studies the effects of rare-earth modification on carbides pattern,distribution,matrix graininess of high Cr cast iron roller.

本文研究了稀土变质处理对高铬铸铁轧辊的碳化物的形态、分布和基体晶粒度的影响，认为稀土元素在适量的范围内，可提高这种轧辊的冲击韧性、抗压强度、抗剥落性能。

Long-term with the Luoyang Refractory Material Research Institute, Beijing University of Science and Technology, Anshan University of Science and Technology, such as metallurgy research institutions to collaborate, has developed the metallurgy, coking industry in various grades×, silica brick, clay brick, magnesia brick, magnesia-chrome brick, MgO-C Bricks aluminum, chromium corundum brick, insulation brick light, etc.; cement industry with anti-spalling×, alkali brick, silicon brick Mo, direct combination of magnesia-chrome brick, periclase-spinel brick, phosphorus acid brick, high-phosphate soft Dutch bricks, special bricks, such as phosphate; generating boiler industry with a variety of brands wear-resistant brick, corundum brick, mullite brick, such as stereotyped products and wear resistant castable, corundum castable, high-strength low cement castable, impermeable material, gravity feed can be plastic, various grades, such as fire-resistant mud Unshaped Materials, in which silica brick and light insulation brick production line for the national output of a single one of the largest production line.

公司长期与洛阳耐火材料研究院，北京科技大学，鞍山冶金科技大学等科研院校开展协作，先后开发出冶金，焦化行业用各种牌号高铝砖，硅砖，粘土砖、镁砖，镁铬砖，铝镁碳砖，铬刚玉砖，轻质隔热砖等；水泥行业用抗剥落高铝砖，耐碱砖、硅莫砖，直接结合镁铬砖、方镁石尖晶石砖、磷酸盐砖，高荷软磷酸盐砖、特种磷酸盐砖等；发电锅炉行业用各种牌号耐磨砖，刚玉砖，莫来石砖等定型产品和耐磨浇注料、刚玉浇注料、低水泥高强浇注料、防渗料，自流料，可塑料、各种牌号耐火泥等不定型材料，其中硅砖和轻质隔热砖生产线为全国单台产量最大的生产线之一。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷