前置的

In this paper, some problems that have to be faced with in the application of SPLL to static synchronous compensator are analyzed, and two improvements of SPLL are proposed. The first one is removing the filtering function of lead-leg element into the prepositive delayed signal cancellation element to remedy the difficulty in deciding its parameters; the second one is directly taking the post-PI regulation output of q-axis voltage as error signal of phase to call off the forward integrating element.

分析了软锁相环应用于静止同步补偿器时面临的若干问题，并提出了2方面的改进方案：一是针对超前/滞后环节参数选取困难的问题，将其滤波功能转移到前置延时信号消除环节中；二是q轴电压经PI调节的输出直接作为相位的误差信号，减少了前向积分环节。

On this basis, the author holds that the preceding procedure for notice before enforcement can be cancelled, the confirmation procedure for the start of enforcement should be set up, the reasonable and running ways to realize the enforcement of the prestation by act should be regulated, and the contents for the enforcement relief should be regulated, and the contents for the enforcement relief system should be completed. As a result, the civil enforcement system of China can be improved continuously

在此基础上，笔者认为，可以取消执行通知前置程序，设立执行开始确认程序，规定合理的、可操作的行为给付的强制实现途径，充实执行救济制度的内容，从而不断完善我国的民事强制执行制度。

Power from the bus voltage terminal is transferred from the primary winding to the secondary winding of the transformer during a portion of an operational cycle of the forward converter circuit with the first and second switches being in a conductive state responsive to the first periodic gate control signal.

来自总线电压端的电能在第一和第二开关处于对第一周期性门控制信号起反应的导电状态的情况下在前置转换电路的一部分操作时间间隔期间从变压器的初级线圈输送到变压器的次级线圈。

To remedy the deficiency of intelligent electronic devices in data communication, Guangdong Power Test and Research Institute developed the PT Handshaker communication manager for substations, thus allowing real time data communication between IED and RTU or dispatching gate way, i.

针对使用的智能化电子设备在数据通信方面存在的问题，广东省电力试验研究所自行开发了PT Handshaker变电站通信管理器，来实现IED与RTU或调度端前置机的实时数据通信，即实时的通信协议的转换和数据处理。

A series of profile numerical simulation are based on the datas of core flooding experiment, including the homogeneous profile positive rhythm section, the rhythm section, interlining profile, interlayer heterogeneity section, intraformational heterogeneity of reservoir section, the actual reservoir simulation. The the section of displacement mechanism of core flow method and the datas of core flooding experiments take into account, the EOR scheme of later stage is CO2 preslug followed by the N2 slug flooding, at last is the waterflooding or depletion type of drive..

为了进一步分析注CO2／N2段塞驱对扫油效率的影响，在岩芯驱替实验的基础上对N2推进CO2段塞驱进行了均质剖面、正韵律剖面、反韵律剖面、隔层剖面、层间非均质剖面、层内非均质剖面、实际油藏剖面的数值模拟研究，通过对比研究，初步认为高11油田在开发中后期提高采收率技术上可选取在适当高的压力条件下，先注前置CO2段塞驱，后续再注N2段塞顶替驱，然后再转注水或衰竭开采的驱替方式。

Its leakage current is lower than 5nA at room temperature. The quantum efficiency in the wavelength range of 400-500nm is about 83%. The junction capacity is about 110-120pF. The noise level of PIN+PreAmp system is lower than 527e at -25C. The PIN diodes have passed the long-term stability test. All the main performances of our PIN diodes meet the requirement of ALICE/PHOS,and some of them are even better.

本工作研制的PIN硅光电二极管的灵敏区面积为16x17mm2，常温漏电流小于5nA，紫光区量子效率约为83%，结电容为110-120pF，以及由PIN光电二极管与电荷灵敏前置放大器组成的读出系统的噪声水平在-25℃下小于527个等效噪声电荷，并经过了长期性能稳定性的考验。

A new desulfurization apprach for pulverized coal combustion is introduced in this paper; pulverized coal is first burn in a precombustion furnace under oxygen deficient condition (about 30% air needed in boiler is provided for precombustion), in precombustion moust of sulfur in coal is decomposed and oxidized, and evolved, the sulfur evolved is trapped in a desulfurizing fluidized bed by calsuim, and then the char and gas are introduced to the boiler furnace for complete combustion.

本文提出了一种煤粉燃烧脱硫新方案，利用煤中硫优先氧化分解释出的原理，用少量的空气（大略为锅炉实际空气用量的30％），在一前置燃烧室中，使煤粉中硫的绝大部分被分解氧化，释放出来，释放出来的硫在脱硫流化床中被石灰脱硫剂脱除，未燃烧的炭粒与烟气再吹进锅炉膛中完全燃烧。

First, this paper lists formula of active power by analyzing the composing of instantaneous power, then discusses the effect of prefilter to electric energy metering, how to measure electric energy in transient condition, and the influence of load type to the conversion of electric energy.

本文首先分析了瞬时功率的构成，得到有功功率的公式，接着探讨了前置滤波器对电能计量的影响、暂态情况下的电能计量问题和用户类型对电能转换的影响，最后对有功计费提出了一些建议。

The logistics managers must determine the symphonious policies of purchasing, product and transportation, and through the long purchasing contract to transport the high-quality products from supplier to buyer, and shorten leading time of buyer and reduce mutual stock level at a minimum total joint cost.

供应链系统中的管理者必须规划出具有协调机制的采购、生产与运输货品策略，并且透过长期采购合约，买卖双方密切合作，约定卖方少量多频率的运送高品质产品给买方，来缩短买方的前置时间与降低彼此的存货水准，进而使得整体供应链的总联合成本最小化。

The pick_up and analyse for parts data have been made and craftwork decision has been made. Profile calculations for turning parts and islands and islets for milling parts problem in mould cavity have been especially made. Post process for turning parts and milling parts have been realized. The cutter locus file has been made.

通过对零件数据的提取、分析及工艺决策，深入研究了车削类零件的轮廓计算和铣削类零件型腔中岛屿问题的处理方法，实现了车削、铣削零件的前置处理，形成刀位文件，并生成了相应的零件工艺卡。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。