制动阀

Main production: clutch booster, spring brake chamber, air brake, brake master cylinder and other products.

主要生产：离合器助力器，弹簧制动室，气制动阀，刹车总泵等系列产品。

Caused by the brake disc brake on back wheel should not have four kinds of spaces possible: First, the foot brake 5 exhaust inlets, high pressure gas instinct Pai people the atmosphere, caused by gas-liquid master cylinder should not spring back to place, cause the system Oil will move the brake disc brake wheel cylinder piston top dead can not come back to places; are gas-liquid two disc brake master cylinder to the tubing plug, resulting in brake wheel cylinder piston can not come back to places; are three master cylinder of gas-liquid Can not spring back to their own spaces, brake fluid under high pressure gas, liquid should not return to the master cylinder reservoir chamber, resulting in brake wheel cylinder piston can not come back to places; are four wheel disc brake piston brake system because of moving fluid dirty or rusty Pistons Can not Back-bit card dead.

造成盘式制动器上的制动分泵不能回位有4种可能：一是脚制动阀5的排气口堵塞，高压气体本能排人大气，造成气液总泵的弹簧不能回位，导致制动油将盘式制动器的制动分泵活塞顶死而不能回位；二是气液总泵至盘式制动器的油管堵塞，造成制动分泵活塞不能回位；三是气液总泵的弹簧本身不能回位，制动液在高压气体作用下，不能回到气液总泵的储油室，从而造成制动分泵活塞不能回位；四是盘式制动器制动分泵活塞由于制动液太脏或活塞生锈卡死而不能回位。

Caused by disc brake on the brake Wheel Cylinder could not return to places 4 possible: First, 5 foot brake valve exhaust port blocking, high-pressure gas instinct platoon atmosphere, caused by gas-liquid master cylinder of the spring could not return to place, resulting in the system move oil, brake disc brake Wheel Cylinder Piston top dead and could not return to places; second is to the disc brake master cylinder gas-liquid pipeline blockage, resulting in brake Cylinder piston can not return to place; third master cylinder of the gas-liquid Spring itself can not return to position, brake fluid under high pressure gas can not return Axial pump to gas-liquid master cylinder reservoir chamber, resulting in brake Cylinder piston can not return to places; Fourth Wheel Cylinder piston disc brake system, due to moving fluid dirty or rusty card dead and can not return to the piston position.

造成盘式制动器上的制动分泵不能回位有4种可能：一是脚制动阀5的排气口堵塞，高压气体本能排人大气，造成气液总泵的弹簧不能回位，导致制动油将盘式制动器的制动分泵活塞顶死而不能回位；二是气液总泵至盘式制动器的油管堵塞，造成制动分泵活塞不能回位；三是气液总泵的弹簧本身不能回位，制动液在高压气体作用下，不能回到气液总泵的储油室，从而造成制动分泵活塞不能回位；四是盘式制动器制动分泵活塞由于制动液太脏或活塞生锈卡死而不能回位。

A small four-wheel tractor air BALANCING VALVES brake valve tappet is made of plastic, and its diameter and length are often vulnerable to the effects of thermal expansion and contraction changes, resulting in air brake failure.

小四轮拖拉机的气制动阀挺杆是由塑料制成的，其外径、长度往往易受热胀冷缩的影响而改变，导致气制动阀失灵。

On the basis of the structure and performance analysis of a serial hydraulic brake valve, a simulating model of responding characteristics in a full power hydraulic brake system was established, and the simulation analysis of various structure parameters of the braking valve affecting the dynamic characteristics of the system was conducted.

在对串联式液压制动阀结构与性能分析的基础上，建立了全动力液压制动系统动态数学模型，并就制动阀结构参数对系统动态性能的影响进行了仿真分析。

The steering brake and the emergent brake of the vehicle were realized by a dualpipeline brake system in which an electronichydraulic servo controlled dual brake valve is used to control the dual-chamber brake cylinder.

采用电液伺服控制的双联制动阀控制双腔制动油缸的双路制动方案，实现车辆的行车制动和紧急制动。

Exhaust brake valve is an auxiliary brake, is a necessary supplement to vehicle service brake; it is to use engine as an air compressor to generate brake torque to decelerate the vehicle; normally it is assembled inside of exhaust pipe, and close the valve to clog the exhaust duct as necessary to reach braking.

排气制动阀是一个辅助制动器，是汽车行车制动器的必要补充，是将发动机作一个空气压缩机使用而产生制动力矩从而对汽车产生减速作用，一般安装在排气管中，在需要减速时关闭阀门以阻塞排气通道而达到制动的效果。

Parking brake in accordance with the principles of analysis, failure was mainly adjust parking brake is not in place.

根据停机制动阀的原理分析，故障主要是停机制动阀调整不到位。

Zhejiang Constant Zhidong Fa Co., Ltd. is professional manufacturing, sales of gas-liquid control vehicle braking system, the protection of stored energy, the Executive Zhidong Fa, pump brake components of the joint-stock Company.

浙江恒力制动阀有限公司是专业制造、销售汽车制动系统气液控制、保护储能、执行制动阀、泵制动元件产品的股份制有限公司。

In the system, two hydraulic rams are used to control the steering and braking valves in both sides of bulldozer, one electromagnetic direction valve to select controlling side, and proportional reduced valve to control the pressure of hydraulic ram.

利用两个油缸来控制推土机左右两侧的转向制动阀，用电磁换向阀来选择控制侧，并用比例减压阀控制油缸内油液的压力。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。