初始设计

The thesis also draw several conclusions as follows:(1) Orthogonal experiment design method can be viewed as a special case of genetic algorithm, i. e. a genetic algorithm with a fixed initial population, an oriented-mutation operator and one evolution epoch.(2) In terms of running steps, genetic algorithm is more complex than orthogonal experiment design method.

论文首次对正交试验设计法和遗传算法这两种独立发展起来的方法进行比较研究，提出(1)正交试验设计法是遗传算法的一种特例，即是一种初始种群固定的、只使用定向变异算子的、只进化一代的遗传算法；(2)遗传算法产生的优化解优于正交试验设计法产生的优化解，且遗传算法处理交互作用项的效率高于正交试验设计法；(3)遗传算法的步骤比正交试验设计法复杂，所需的试验次数也要多。

The initial value of the convergence half angle in the iterative synthesis is discussed and a more logical function is given for assigning it.

对轴对称收敛型电子枪设计方法进行了整理分析，就阴极半锥角的初始值对迭代综合法的收敛性能所产生的影响进行了讨论，针对低压缩比条件下原来的Vaughan公式失效的问题进行了分析，给出了更为合理的初始值计算公式。

This method adopts data-based optimization algorithm to design the initial prediction operator and update operator at each decomposition scale, the initial prediction operator and update operator are interpolated with zero, and then the redundant prediction operator and redundant update operator are obtained.

该方法采用基于数据的优化算法，设计每层小波分解的初始预测器和更新器，然后通过对初始预测器和更新器进行插值补零运算，来获得冗余预测器和更新器。

In this paper, we performed numerical simulations to investigate the impact of initial data and initialization schemes.

本研究亦结合前两者优点而设计一系列的新方法，针对不同资料、不同初始化方法及不同初始时间进行模拟测试，以了解不同初始条件对於模拟结果的影响。

Initial solution is the sticking point of TS. The quality of initial solution restricts the convergence rate of search.

禁忌搜索算法设计的框架中初始解尤为关键，初始解的好坏制约着搜索的收敛速度。

Theinitializations both use the cost function with nominal head. Their difference is thatcontinuous function is adopted in successive linear programming while piecewiseapproximation employs the two piecewise linear segment function.

大量计算的结果表明，初始迭代点的计算采用电厂设计水头下的出力 I特性能加快整个模型的收敛性，在逐次线性规划中采用这种方式计算的初始迭代点尤其接近问题的最优点。

It has settled hidden markov model a dominant position in the area of speech acoustic and linguistic modeling that more 30 years application and development in speech recognition.

本文提出了矢量量化中初始码本设计应该遵循的准则，即训练矢量空间中初始码字的分布应该使码字聚类形成的胞腔在总畸变上而不是在空间体积上尽可能均衡。

On the base of studying application methods and relative information of the relative chips, the paper designed the system hardware ,including LCD interface designing、video gathering chip and its peripheral circuit designing、FPGA chip and other module interface designing; 3、The LCD controller module、video in controller module、configuration initialized module of the video image decode chip、FPGA and program of module interface were all compiled and debugged in the paper. 4、The whole system debugging was carried through, and the video image data storage and displaying on LCD screen was carried out in the paper. The paper first designed the system frame, then designed hardware platform according to the system frame and then analyzed it、debugged it, finally,compiled the module code and debugged the whole system to achieve system requirements.

本文具体研究工作主要体现在以下几个方面： 1分析了的嵌入式视频图像采集、处理与LCD显示系统的总体需求，设计了基于NIOSⅡ的嵌入式系统总体架构； 2在学习相关芯片的具体应用方法和相关知识的基础上，设计了系统的硬件，包括LCD接口设计、视频采集芯片及外围电路设计、FPGA芯片和其他模块接口主板设计； 3编写并调试了LCD控制器模块、视频输入控制器模块、视频解码芯片初始化配置模块、FPGA和各个模块接口程序； 4进行了整个系统的联调，完成了视频图像数据存储并通过LCD显示；本文首先建立了系统架构，然后根据系统架构进行硬件平台的设计并对硬件平台进行分析和调试，最后编写个模块代码并完成系统联合调试实现系统要求。

The sketch and specific design approaches of mid-block street crossing are generalized and three management and control modes are discussed. Based on extensive investigation and survey, the paper analysis the arriving laws in different land-use condition and the traffic characteristics of different crossing entities under different control modes. The initial characteristic, the speed and dispersion of the mobile flow are also intensive studied, as well as the effect of mid-block street crossing. Establish the linear planning models on the coordination between the signals of mid-block crossing and intersection. Finally the evaluation of the model output is carried out from time saving results, safety, economic results and social results. Set the example of Taiping north road in Nanjing, surveying the traffic situation, applying the method of signal coordination between the mid-block crossings and intersection to realize the south-to-north signal coordination design. The evaluation results show the coordination plan are more superior to the current signal plan.

本文首先阐述了行人过街物理设施的概略设计和详细设计方法，讨论了路段人行横道的三种交通管制方式的设计方法和实用条件；其次，在充分的实际调查基础上，详细分析了不同用地性质条件下的过街需求的到达特性和不同交通管制下不同过街实体的交通特性，分析了进入路段的机动车初始流特性，并对机动车在路段中的车速特征、离散性以及路段信号控制人行横道对机动车流的影响进行了研究；然后，根据以上分析的过街交通和机动车交通的交通特性，建立了路段行人过街信号与交叉口信号协调控制的线性规划模型；最后，对模型输出的协调控制方案进行了效益评价分析，从时间效益、安全性、经济效益和社会效益四个方面，定量和定性相结合地对其实施效果予以评价；以南京市太平北路路段为例，根据现状交通状况，应用行人过街信号与交叉口信号协调控制的方法，对该路段由南向北方向进行单向协调控制设计，并进行方案效益分析评价，提出了优于现状控制方案的人行过街信号与交叉口信号协调控制方案。

Specialized introduction: This specialized raise has the electronic technology and the information system elementary knowledge, can be engaged in each kind of electronic installation and the information system research, the design, the manufacture, the application and the development higher project technology talented person Main curriculum: The signal and the system, the digital signal processing, the correspondence principle, the microcomputer principle and the connection technology, the monolithic integrated circuit principle and the application technology, the DSP technology and the application, the EDA technology, the construction of data, embedded Linux using the programming, the feeling measure technical, the electric circuit theory series curriculum, the computer technology series curriculum and so on individual hobby * software and hardware research and development computer correspondence literature ping pong photography The experience and the personal experience * 2006.6.29-7.8 compile the staff management system management system using the C language, its basic service activity includes: The staff information warehousing, the revision, the inquiry, the insertion, deletes the staff information and so on * 2006.7.10-7.20 monolithic integrated circuit curriculum design period completes the stopwatch the design, namely the initialization timer is 99:99, 0 starts using the monolithic integrated circuit timer fixed time, fixed time arrives when 0s to transmit the signal to cause the buzzer bell, and may realize suspends, the continuation and the replacement function * 2007.7.2- 7.8 practises in Luoyang Big dragon Peony Communication facility Limited company, does has liquid crystal display monitor telephone one, simultaneously visited has served under somebody's banner the correspondence company, and studied has simulated the telephone the design electric circuit, had understood its basic principle * 2007.7.4- 7.18 completed the DSP curriculum in the school to design, realizes the FIR numeral filter, namely transmitted 25 from DSPThe height level, after advocates AC01 D/A to transform the simulation square-wave, then passes to again from AC01 carries on A/D to transform, produces the data signal, after the DSP numeral filter, finally produces the sine wave * 2008.8.1-8.15 to practise in the Zhejiang Jiang hua abundant power tool limited company, studies the computer software and hardware maintenance.

专业介绍：本专业培养具备电子技术和信息系统的基础知识，能从事各类电子设备和信息系统的研究、设计、制造、应用和开发的高等工程技术人才主要课程：信号与系统、数字信号处理、通信原理、微机原理与接口技术、单片机原理与应用技术、DSP技术及应用、EDA技术、数据结构、嵌入式Linux应用编程、感测技术、电路理论系列课程、计算机技术系列课程等个人爱好＊软硬件研发计算机通信文学乒乓球摄影实践经验及个人经历＊ 2006.6.29-7.8 利用C语言编写员工管理系统，其基本业务活动包括：员工信息入库，修改、查询、插入、删除员工信息等＊ 2006.7.10-7.20 单片机课程设计期间完成秒表的设计，即初始化定时器为99：99，利用单片机定时器0开始定时，定时到0s时发送信号使蜂鸣器响铃，并可实现暂停、继续和复位功能＊ 2007.7.2- 7.8 在洛阳巨龙牡丹通信设备有限公司实习，做有液晶显示屏电话机一部，同时参观了旗下通信公司，并学习了模拟电话的设计电路，懂得了其基本原理＊ 2007.7.4- 7.18 在校完成DSP课程设计，实现FIR数字滤波，即从DSP发送25个高低电平，经主AC01 D/A 转换成模拟方波，然后再传给从AC01进行A/D转换，生成数据信号，经DSP数字滤波，最后生成正弦波＊ 2008.8.1-8.15 在浙江华丰电动工具有限公司实习，学习电脑软硬件维护。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。