划分的
- 与 划分的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Efficient detector generation algorithm is the kernel of anomaly detection. Aiming at low true positive value, unhandy matching threshold value and large detector set size of existent algorithms, a novel detector generation algorithm based on multiple populations genetic algorithm is put forward in this paper. According to morphologic analysis of intrusion detection system and covering problem principle, self set is divided into several partitions on the basis of their characters.
摘要有效的检测器生成算法是异常检测的核心问题,针对现有算法存在检测率低、匹配阈值固定、检测器集合庞大等问题,本文提出了基于多种群遗传算法的检测器生成算法,根据形态学空间的分析和覆盖问题原理,自体集根据特征进行划分,各个种群根据划分独立按遗传算法进化,最后求得所有检测器种群的并集得到成熟的检测器。
-
The drama art in Xinjiang, haw a long history, Each nation created its drama with unique artistic characteristics and styles based on its traditional culture. According to form and genre, the drama is divided into opera, dance drama and local drama. If distingue by national feature and region, I key are Uighur opera, Kazak opera, Sibo opera, melody opera and other local opera from the other pants of China.
新疆的戏剧艺术具有悠久的历史,各个民族在自己传统文化的基础上创造了独具艺术特色与风格的民族戏剧,按其艺术形式和体裁划分有歌剧、舞剧和地方戏曲,以民族特点和地域划分则有维吾尔剧、哈萨克剧、锡伯剧以及从我国内地传入新疆的曲子戏和其它地方戏曲。
-
Methods A wet hip joint's sample from corpse was scaned by CT and all images of every cross-section hip joint's layer was obtained, and an hip joint's model was contructed with Unigraphics NX 2.0 and Solid Works 2006 SP 0.0 software. The models were assembled when simulated total hip arthroplasty after total hip joint prosthetic and ischiofemoral ligament model had been constructured. Analysis was done on von Mises stress distribution and amount of total hip component when simulated seated leg-crossing manuver. The bone and metal components were meshed as rigid bodies, composed of three-dimensional, all-quadrilateral rigid body elements, and hip joint capsule ligament was fully three-dimensional, hexahedral continuum elements representations. Results The current form of this ischiofemoral ligament's reconstruction finite element model provided for multi-body contact, large displacement interfacial sliding, large deformation capsule ligament representation, and clearly reflected the real ischiofemoral ligansent's anatomy and biomechanical behavior. The maximum on Mises stresses at the joint interface was more than that fur an otherwise identical hardware-only construct.
选择成人尸体髋关节行CT成像得到髋关节每层横截面图像,提取边界坐标,利用有限元分析软件Unigraphics NX 2.0和Solid-Works 2006 SP0.0构建出髋关节三维有限元模型及人工髋关节假体,并模拟全髋置换术进行装配,将坐股韧带按其术中重建位置进行构建骨骼与金属模型采用三维十节点四面体实体单元进行网格划分,关节囊六面体连接单元划分,模拟坐位腿交叉动作载荷获取假体撞击过程的角活动度和相应的von Mises应力分布情况结果所构建的多体连接、大界面划移、大变形的坐股韧带重建有限元模型,客观反映坐股韧带真实解剖形态及生物力学行为,增加坐股韧带重建的模型其关节面的最大主应力值大于仅有金属的模型。
-
According to the space distance between the metro structure and adjacent buildings, the degree of surface settlement and tilt of adjacent buildings caused by the construction of metro tunnel excavation, we divide the degree of adjacent buildings affected by a single metro tunnel construction into four adjacent grades, that is very nearby, quite adjacent, adjacent and nonadjacent, and give the criteria for the classification and the calculation method of the settlement and tilt of building close to metro.
依据地铁结构与邻近建筑物间的空间距离、地铁隧道暗挖施工引起地表沉降和邻近建筑物倾斜的程度,将受单个地铁隧道施工影响的邻近建筑物的邻近程度划分为很邻近、邻近、较邻近和不邻近4个邻近等级,并给出划分标准以及邻近地铁建筑物沉降及倾斜的计算方法。
-
The best theoretical solution to a partitional clustering problem is to find all possible partitions and choose the partition that minimizes the objective function. However, the enumeration of all possible partitions is impractical even for data sets of moderate size. Therefore, as an alternative, most partitional approaches use an iterative optimization technique. And this could be cause local minimum.
本文在分析了目前聚类的基本方法的基础上,指出以K平均法等为代表的分割聚类虽然理论上找到类的所有划分并使得目标函数最小就可以获得最优解,但由于对于相当尺度的数据集列举所有可能的划分并不现实,因而多数分割方法采用迭代优化技术作为变通。
-
The application of the extension engineering method in regionalization avoided the shortcomings of single indicator, such as the aridity or precipitation, and conduced to the consummation of the physicogeographical regionalization, the establishment of the eco-geographical regional system of China, and the further research on the transitional areas.
运用可拓工程方法,以综合考虑引起区域自然景观分异、变化的主导因子为出发点,解决了中温带半湿润、半干旱区界线划分问题,弥补了单指标(如仅考虑干燥度或降水量)在区域界线划分中的不足;有助于综合自然地理区划的进一步完善和中国生态地理区域系统的构建;也有益于对生态过渡带的深入研究。
-
But in current engineering practice,these two concepts are confused.On the one hand,it causes no fit theory for delimiting seismic statistical zone in PSHA to be set up;on the other hand,researches about delimitation of seismic belts with purposes of seismicity zoning and studying on structural environment,mechanism of earthquake generating also paues to go abead.
现行工作中将两者不加区分地使用是不合适的,一方面造成地震统计区未形成自身的适应概率地震危险性分析方法的划分理论,另一方面也造成以地震活动特征和地震孕育发生环境、机制研究为目的的地震带划分研究的停滞不前。
-
The new division method based on the flow unit conforms with the vadose laws. Therefore, it is quite applicable in the production of the oilfield and hence satisfies the need of exploitation layers adjustment.
这种基于流动单元划分沉积微相的方法是依据储层渗流性质的差异将储层划分成符合其渗流规律的层系,便于同油田开发的生产层系相结合,从而满足层系开发调整的需要。
-
3D model produce enormous degree of freedom.(3) Simulating have to employ multi-step load for moving heat source. In order to solve problems mentioned above and improve solution accuracy, this paper choused suitable material property parameter, and used transition mesh, with two point and line heat sources model. The program which applyload of moving heat sources and suitable time step was edited by means of ANSYS' APDL (ANSYS Parametric Design Language).
为了解决这一问题并提高计算精度,本文对高温时材料的物理性能参数进行了适当的选取和处理;采用过渡网格划分形式划分网格以保证焊缝处网格足够细小;点热源选取高斯函数分布和线热源进行叠加,利用ANSYS软件的APDL(ANSYS Parametric Design Language)语言编写程序实现移动热源的加载;选取适当的计算时间步长。
-
6 First Division: In the first place then I say that the primary division of essential order appears to be that of an equivocal term into its equivocates, namely into the order of eminence and the order of dependence.
1.6 第一种分类:首先,我认为对本质秩序的初始分类似乎是把一个模棱两可的概念进行模棱两可的划分,即划分为卓越的秩序与依附的秩序。
- 推荐网络例句
-
And discuss some key point of integrated management system design, include hazard identification and risk assessment and risk control in the occupational health and safety management, the measure of satisfaction target of customer, the flawlessness of law system, the integration of the integrated management system and enterprise standardization system, unify lead institution and work orgnization, integreted internal audit and integrated management review.
同时,论述了一体化管理体系构建中的几个主要问题,包括职业健康安全管理中的危险源辨识、风险评价和风险控制、顾客满意度的科学监测、法律、法规体系的完善、一体化管理体系与企业标准化体系的有机结合、统一的领导机构和工作机构、一体化的内部审核和管理评审。
-
Deepwater Taranaki is investigated for its petroleum potential, using all available seismic data tied to shallow-water wells.
运用与浅水井相关的现有全部震波探测数据考察了深海区塔拉纳基盆地的油藏前景。
-
If you're huffing and puffing at any point during the run, slow down and make sure you can take deep breathes.
如果你任何时候在跑步过程中气喘如牛,降低速度并且确保你能够深呼吸。