切的

The clinical characters of oligodontia concluded from this study are following:(1) There is significant difference that more teeth absent and more existent teeth anomalies in patients of oligodontia/S group than in patients of oligodontia/I group, and the peg-shaped upper lateral incisor is the most frequently affected teeth with shape anomaly.(2) Both of the two groups have no significant differences in number of teeth missing between maxilla and mandible as well as that between left and right side.(3) The distribution of teeth missing is bilateral symmetry in both groups, but the frequency of teeth lost are different: excluding the third molar, in oligodontia/I group, the lower second premolar is the most frequently congenitally missing tooth followed by the upper lateral incisor, while in oligodontia/S group, the most frequently missing teeth are mandibular canine and maxillary lateral incisor. Nevertheless, the first molars are the most stable teeth in both groups.(4) In oligodonita/I group, the mean mesiodistal dimensions of all type of existent teeth are significantly smaller than normal value. It is implied that oligodontia is not an isolated phenomenon, but is related to a complex of other dental changes.

对于口腔多个恒牙先天缺失的临床特点有以下初步结论：(1)综合征型先天缺牙患者较单纯型先天缺牙患者恒牙缺失数目更多，平均分别为23.9个和14.9个，且现存牙齿有更多的形态异常，分别为7／10例（70％）和6／22例（27.3％），其中最常见的是上颌侧切牙畸形；(2)两种类型的多个恒牙先天缺失患者的缺牙数目在上下颌及左右侧之间均无差别；(3)两种类型的多个恒牙先天缺失患者在缺失牙位上均呈对称分布，但在具体牙位上有所差异：不计第三磨牙，单纯型先天缺牙最常缺失的牙位是下颌第二双尖牙、其次为上颌侧切牙；而综合征型先天缺牙最常缺失的牙位是下颌尖牙和上颌侧切牙；无论何种情况，第一磨牙均为牙列中最稳定的牙齿；(4)在单纯型先天缺牙患者中，现存恒牙的牙冠宽度较国人正常值偏小，差异显著，提示牙齿形态与多个牙先天缺失有一定相关性。

Home position shear tests of slope rock, point loading tests and indoor AMD simulation action tests in XingQiao concave slope had show shearing strength and coherence between body layers of quartz sandstone decrease by 13.2%~21.3% after attacked by AMD, the angle of internal friction between layers is decreased by 5.0%~7.5%, in general, AMD affects the rocks mechanical property at range of 60~100m interior the perpendicular slop. Data analysis shows: 1 The actions to slope are major focused on zone of weakness, shearing strength of slope foot and AMD centre are reduced by 52% and 64.7% separately. 2 The explosion stress wave of long distance field has obviously increasing influence to disturbance amplitude value of slope with increasing of the slope height and distance, the response of the top of slope and fault region are obvious as well as damage effect; the foot of slope is with smallest disturbance amplitude value, the disturbance amplitude value of the step close to free face is obviously bigger than the interior of slope. 3 With the coupling effect of the AMD and explosion loading, the stress distribution inside of slope mainly presents characters of explosion stress field; the area affected by AMD becomes a weak area of shearing stress.

新桥深凹露天矿边坡岩体的原位剪切试验、点载荷试验、室内模拟AMD作用试验表明：AMD蚀化后的石英砂岩，岩体层面间的抗剪强度和粘聚力减小的幅值约为13.2%~21.3%；层面间内摩擦角减小幅值在5.0%~7.5%之间；AMD一般影响垂直边坡体内部在60~100m范围内的岩体力学性质数值分析表明：AMD对边坡体的作用主要集中在弱化区域内，边坡体的底脚和AMD作用中心区域的剪切应力减少了52.0%和64.7%；(2)随着边坡体高度和距离的增加，远场爆炸应力波对边坡扰动幅值的增加趋势明显，边坡顶部和断层部位的响应突出，损伤效应明显；边坡底脚扰动幅值最小，临空面附近台阶的扰动幅值明显大于边坡体内部；(3)AMD与爆破荷载耦合作用后，边坡体内部的应力分布主要呈现出爆炸应力场的特征，AMD影响区域形成了一个剪切应力弱区。

Manual cutting machine, straight strap and 45-degree diagonal straps machine suitable for cloth, adhesive-bonded fabric, tent, umbrella, sponge foam, leather, reflective material, plastic, paper, two-side glue, acetate fabric, reinforced belt, conductive cloth, copper, foil and other materials of various width straight.

手动切捆条机及直纹，45度斜纹卷布机适用于布料，无纺布，帐篷，雨伞，泡棉，皮革，反光材料，塑胶，纸张，双面胶，醋酸布，补强带，导电布，铜箔等材料各种宽度直条，45度斜条的卷布及裁切。

The cutting roller includes at least one cutter disposed on the circumferences of the cutting roller.

切刀罗拉包括配置於切刀罗拉之圆周上的至少一刀具。

The results show that the plasticity zone and dynamically quiescent layer become fine equiaxed recrystallisation under the thermo-mechanical effect, the grains in the heat-affected zone grow up because of the effect of friction heat. When the rotation speed is 2 500 r/min and the welding time is 12 s, good joint is achieved, and the tensile shear strength of the joint reaches 9.24 kN. The tensile shear strength of spot increases with increasing tool rotation speed, with increasing welding time, the strength increases first, while then reduces. The microhardness of plasticity zone is high, but is slightly lower than that of the base metal, the minimum value of microhardness is in the heat affected zone. When the energy input of joint is high, the fracture type of spot is mode Ⅰ, and the tensile shear strength is high; on the contrary, when the energy input of joint is less the fracture type of spot is mode Ⅱ, and the strength is low.

结果表明：塑性区和动态静止层的晶粒在热和力作用下发生动态再结晶形成细小的等轴晶，热影响区的晶粒在摩擦热作用下长大变粗；搅拌头旋转速度为2 500 r/min，焊接时间为12 s时，可以获得力学性能较好的焊点，焊点的剪切强度达到9.24 kN；焊点的剪切强度随搅拌头旋转速度的增大而增大，随焊接时间的延长先增大后减小；塑性区的显微硬度较高，但略小于母材，接头显微硬度的最小值分布在热影响区；焊点热输入量较多时，接头为Ⅰ型断裂，焊点的剪切强度较高；焊点热输入量较少时，接头为Ⅱ型断裂，焊点的强度较低。

Methods The clinical presentations,MRI images, operative technique and prognosis of 9 cases with tumors of the foramen magnum were analyzed retrospectively.

回顾性 分析 9例枕大孔区肿瘤的临床表现和MRI影像，手术技巧和预后。结果全切5例，次全切3例，部分切除1例。结论熟悉枕大孔区解剖，运用显微外科技术，选

Acquaintance with anatomy of foramen magnum region,microsurgical technique,suitable surgical approach and post--operative management are closely related with the therapeutic effect.

回顾性 分析 9例枕大孔区肿瘤的临床表现和MRI影像，手术技巧和预后。结果全切5例，次全切3例，部分切除1例。结论熟悉枕大孔区解剖，运用显微外科技术，选择合适手术入路，注重术后处理，都与疗效密切相关。

Analysis of the digestion of lysyl endopeptidase and N-terminal amino-acid sequence showed that Thr204 was the phosphorylated site which was consistent with the phosphorylation of Thr199 in DnaK.

赖氨酰肽链内切酶酶切、反相分离、氨基酸测序确定磷酸化位点为204位苏氨酸，与大肠杆菌Hsp70---DnaK的199位苏氨酸磷酸化一致。

Though Philinte agrees with some of what Alceste has to say, he tells Alceste, The world won't change its ways on account of anything you may do.

&虽然Philinte同意一些事情阿尔切斯特的话，他告诉阿尔切斯特，&世界将不会改变其方式对帐户的事情你可以做。

Methods In 50 cases of patients after treatment of artificial kidney and 54 healthy volunteers, the prevalence of HHV-7 in peripheral blood mononuclear cell and cell-free viral DNA in plasma was tested by nested polymerase chain reaction assay; the product of PCR was digested by restricted enzyme EcoR I to identify its specificity.

采用巢式聚合酶链反应对50例肾透析病人和54例正常健康人PBMC和血浆标本中HHV-7 DNA进行定性检测；用限制性核酸内切酶EcoRⅠ对PCR产物进行酶切图谱分析以确定扩增产物的特异性。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。