英语人>网络例句>分离面 相关的搜索结果
网络例句

分离面

与 分离面 相关的网络例句 [注:此内容来源于网络,仅供参考]

Based on a quadratic separator, a robust reliable filter design method for a class of systems with polytopic type uncertainty is presented against sensor failures.

摘要针对凸面体不确定系统并考虑传感器发生故障的情况,基于二次型分离算子进行了鲁棒可靠滤波器设计的研究。

By Jonathan Dorn, BACKPACKER Executive Editor Dan NelsonMost cobblers can repair separated seams in a boot's upper or tongue, give the leather a thorough cleaning and waterproofing, reglue peeled toe guards and rands, and replace or restitch busted eyelets and hooks.

大部分的补鞋匠能够修补在靴子鞋面或者鞋舌头处分离的接缝,对皮革进行彻底地清洁和防水处理,调整脱落的鞋头、鞋后根与鞋底中间的垫皮,更换或者复原破裂的垫圈和吊钩。

24 New Zealand white rabbits were divided into control group,Saline group and Mailuoning group,on the latter two groups the models of Hemifacial spasm were made by the temporal superficial artery closely contacting the main trunk of facial nerve at stylomastoid foramen.From the 5th week,the Saline and Mailuoning were injected intravenously into ear margin for 2 weeks on Saline and Mailuoning group respectively.At the 7th week,the MDA and SOD in serum were measured,meawhile the microstructure and ultrastructure of facial nerve were observed on 3 animal groups.

将24只新西兰大白兔随机分为对照组、脉络宁组和生理盐水组,在手术显微镜下分离出其茎乳孔处的面神经主干和颞浅动脉,使二者密切接触,以制备半面痉挛动物模型;术后第5周起对脉络宁组和生理盐水组分别自耳缘静脉推注脉络宁注射液和生理盐水持续2周;第7周取3组动物血清测定丙二醛和超氧化物歧化酶,并处死取材行面神经光、电镜观察。

Although these injuries may consist of a variety of posterior element pathologies spanning the spectrum from fracture separation of the lateral mass 25,26 (with translation or rotation since an undisplaced lateral mass fracture falls within the compression morphology) through completely dislocated or locked facets.

尽管这种损伤可以包含多种后方结构的病理改变,包括从侧块的骨折分离到完全的脱位或关节交锁,各种程度的棘突、椎板、侧块等后方结构的骨折伴随椎体的爆裂、矢状面和/或冠状面的骨折,如所谓的泪滴状骨折。所有这些损伤存在于1个椎体相对于邻近椎体的平移。

Unstressed specimen, which is due to hydrogen concentration in bended specimen is higher.

利用裂纹面分离及SEM和EDS研究了L360MCS钢焊接热影响区在湿H2S环境中的应力导向氢致开裂行为。

A method using demodulated resonance technique based on blind source separation is developed for gear contact diagnosis.

提出一种运用基于盲源分离的共振解调技术对齿轮齿面接触故障进行诊断的方法。

The physico-mathematical model was established by considering the variation of the apparent contact angle to describe the configuration of the total extended thin film region,including the equilibrium region,the interline region and the meniscus region.In addition,the ratio of disjoining pressure and capillary pressure was introduced to distinguish the film ranges of the different regions by considering the influence of film configuration,liquid property and channel size.

借助表观接触角的演化,建立起包含固有弯月面、过渡薄液膜和平衡区三部分的延展薄液膜形状及其表面蒸发的物理数学模型,并考虑液膜的结构、工质物性和通道特征尺度,引入分离压力和毛细压力比确定液膜不同区域的范围。

In an ideal BHJ solar cell, this two phases uniform interpenetrated through vertical phase separation to ensure charge carrier transport to the electrode without recombination.

在理想的异质接面结构中,主动层两材料藉由均匀地垂直相分离形成互相贯穿的通道,以确保电荷传输至电极并减少再结合现象发生。

For example, the interaction between substrate and block copolymer is determined by surface free energy of the substrate, crystallization is dependent on crystallization temperature and annealing temperature, and microphase segregation strength varies with chain length of the block copolymer.

基体和嵌段共聚物之间作用力可通过基体表面自由能调控,可结晶链段的结晶可通过结晶条件调控,相分离强度可通过嵌段共聚物链长控制。

If the fluid flow separated from the sharp edge of the rearward steps reattached in the effective region, the reseparated point would occur downstream of the cross section of the cylinder and the drag would be reduced.

对再附流动的有限级数解表明,由有效再附区开始的再附边界层能够保持其边界层状态,发展至柱面最大迎流截面之后的流动再分离点。

第9/10页 首页 < ... 2 3 4 5 6 7 8 9 10 > 尾页
推荐网络例句

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应,而且减少跟风的可能性。

The new PS20 solar power tower collected sunlight through mirrors known as "heliostats" to produce steam that is converted into electricity by a turbine in Sanlucar la Mayor, Spain, Wednesday.

聚光:照片上是建在西班牙桑路卡拉马尤城的一座新型PS20塔式太阳能电站。被称为&日光反射装置&的镜子将太阳光反射到主塔,然后用聚集的热量产生蒸汽进而通过涡轮机转化为电力