分离面

Wastewater containing titanium pigment was treated by microfiltration membrane, Nanometer titanium can be purified and concentrated by use of microfiltration. Operational conditions were optimized and the model was built. Finally, the amount of wash water was reduced. Based on the above research, the whole set equipment was designed, which can meet the needs in a titanium industry with a capability of 500 ton per year. Backflush and automatic control were used in the equipment, which has been steadily run two years, has been widely adopted in titanium industry. The technology has been widely adopted in titanium industry.In the recent years, whole set equipment of ceramic membrane was increasingly used in the recovery of desired production from fermentation broth in China. A new membrane process integrated with pretreatment of flocculation or coagulation was exploited to recover Inosine. ZrO2 ceramic membrane was used in the work, and the average permeation flux could reach 150L/m2.h under pH value of 3, transmembrane pressure 0.1MPa, CFV 3m/s, and temperature higher than 70C. The recovery ratio of inosine is higher than traditional recovery method, although inosine degraded under acidic and high temperature condition.

实验表明，ZrO_2膜处理肌苷发酵液的合适条件为pH=3、操作压力为0.1MPa、膜面流速3m／s、温度大于70度，此时可以获得平均渗透通量150L／m~2h，但由于酸性条件、高温下肌苷降解，导致肌苷收率有所降低，但仍高于传统肌苷提取方法得到的收率；为进一步提高肌苷得率，缩短提取工序，实验研究了絮凝剂预处理发酵液，解决碱性条件下由于蛋白析出导致膜污染加重的问题，研究表明采用CaCl_2絮凝并调节pH=11，可以获得平均渗透通量为180L／m~2h，肌苷得率大于95％；比较了三种肌苷提取工艺得到的产品质量，采用预处理与陶瓷南京工业大学博士学位论文膜分离结合的除杂工艺得到的粗昔质量与陶瓷膜分离、离子交换及活性炭吸附工艺生产的粗普质量相当，均优于传统的提取工艺；设计了每小时处理12一巧吨肌普发酵液的陶瓷膜成套装置，采用部分内循环的方式降低设备的能耗，简化了肌昔提取方式，提高了产品的收率和得率，由于减少离子交换和活性炭吸附，使得工厂废水排放量降低30一40%，降低酸、碱用量，有利于环境保护。

The liquid level of separator at gathering station uses dual－figure control and continuouly detecting the liquid level of the separator by differential liquid level transducer.

气体在集气站内的初脱水及排水计量是由高效分离器完成的，因此有效地控制分离器内的液面是个关键问题。

By using the CFD software FLUENT, the inner-flow field of centrifugal fans with ruled-surface impeller versus with enveloping surface impeller has been simulated. The static pressure distribution, the dynamic pressure distribution, the total pressure distribution, the turbulent intensity and the speed vector of the two kinds of centrifugal fans are then analyzed and compared. From the calculating results, we found that the pressure distribution, the speed vector and other parameters of the two kinds of centrifugal fans are basically same. This implies that the tool-path generating arithmetic for the machining of the impeller can meet the aerodynamic requirements of the centrifugal fan. Furthermore the method can provide proof for designing department to establish sound manufacturing tolerance for impeller.

最后采用CFD软件FLUENT，利用标准k-ε湍流模型，采用分离隐式求解器，分别对直纹面叶轮离心通风机和包络面叶轮离心通风机整体风机内部三维流场和单个通道流场进行了数值模拟计算，在计算结果的后处理中，对相同坐标值处的静压力、动压力、湍流强度和速度矢量等参数进行了分析与比较，结果表明：在相同的计算参数条件下所得到直纹面叶轮离心通风机和包络面叶轮离心通风机内部流场差别不大，从而揭示所采用的叶轮数控加工的刀位规划方法的规划误差对流体机械动力性能的影响不大，这也为设计部门制定合理的叶轮加工公差提供了依据。

Forearm flexor origin from the medial epicondyle was exposed to allow tunneling of the long head tendon underneath the flexor origin.

方法切断胸大肌在肱骨的止点，在肱骨结节间沟顶端切断肱二头肌长头腱，然后向远端分离，显露至长头腱桡骨结节止点处，将前臂屈肌起点从肱骨内髁下方分离；将肱二头肌长头腱从前臂屈肌下方深面穿过，反折后穿过胸大肌止点，调整好张力再返回远端编结缝合。

We have obtained the exact solution of the electrical potential functions and power line functions and plotted the relative equipotential line maps and power line maps ;Meanwhile, we have made the necessary discussion.

对偏心圆柱面带电导体和分离圆柱面带电导体这两个不同边界问题的静电场进行了统一的描述，严格地求出了电势函数和电场线函数，作出了相应的等势线簇图形和电场线簇图形，并且进行了必要的讨论。

The crystal structure of pure Pd is of face centered cubic and it is a hydrogen absorbing metal.

钯是一种面心立方结构的吸氢金属，氢原子溶解在晶格中，占据八面体间隙位，形成fcc的子晶格，吸氢时晶格发生等方性膨胀；氢在钯中的扩散路径为O T O跃迁，存在反同位素效应；钯氢化物的氢同位素分离因子较大，并受到温度、氢浓度等因数的影响；钯氢体系的p c等温线表现出良好的坪台性，Pd H和Pd D均存在临界点，尚未确定Pd T有无临界点；单晶钯氢反应动力学与不同的晶面有关；钯氚体系存在氚老化效应

The main products are FW400-turbine grinder, QCF ultrafine mill, 605-wood flour mill, Hammer series of 56-grinder, SLH of 0.5-30 m double helix cone mixer, artificial agate, resin decorative plate vacuum Forming mixer, all kinds of solid-liquid filtration, separation, drying, grinding, pulse-bag filter Chen Shui-bian, bucket elevator, conveyor movements, vibration fine grading screen, flat screen rotary separation.

主要产品有FW400型涡轮粉碎机，QCF超细粉碎机、605型木粉粉碎机、锤片56型系列粉碎机，SLH型0.5-30m双螺旋锥形混合机、人造玛瑙、树脂装饰板材真空成型搅拌机、各种固液过滤、分离、烘干、粉碎、脉冲扁面袋除尘器、斗式提升机、升降输送机、振动精细分级筛、平面回转分离筛。

An improved method for measurement of complex permittivity using six-port reflectometer is presented. Error caused by incomplete superposition between the measured plane and reference plane, which is often in the case of conventional measuring method, is eliminated with the developed novel algorithm by separating the two planes.

提出了六端口反射计测量介质材料复介电常数的一种改进方法，新的算法使测量面与参考面分离，消除了传统测量方法中测量面与参考面无法完全重合引入的误差。

The results showed that the TiN andN films are polycrystalline phase. The properties and structure of TiN films are mainly determined by the N2 mass flow rate, and as the N2 mass flow rate increases, the structure of the TiN films transforms to f.c.c. type leading to better the properties of films. The presence of negative bias voltage can optimize the grain of TiN films, lower the defect proportion and denser the films, which improves the hardness of films. The TiN films conform to the free carrier absorption mechanism and there are many of free electrons with lower N content in TiN films. With the increase of N content, the quantity of free electrons and reflectivity of films decrease, and the plasma frequence shifts to the lower energy, which leads to the regular change of colors of films from silver, yellowy, golden to yellow-red, meanwhile the lightness of films decreases. The goldenN film consists of TiN and ZrN phase, but belongs to a sigle f.c.c. structure with (111) preferred orientation. The Zr-doping dosen't change the position of the valance band, conduction band and forbidden band ofN film, but leads to the presence of new energy levels, which is the reason thatN film remains golden. The transparent hard films with good corrosion resistance and high hardness have been prepared and the further reseachs showed that the grain size of those films is by far smaller than the wave length and the width of forbidden band of those films is very broad, is the reasons that those films are transparent.

研究表明：氮化钛和N 薄膜为多晶态，氮流量决定了氮化钛薄膜的结构和性能，增加氮流量能使氮化钛薄膜的结构向面心立方结构转变，从而得到性能良好的氮化钛薄膜；施加负偏压能优化氮化钛晶粒和减少薄膜中的缺陷，使膜层变得更致密，从而提高薄膜硬度；氮化钛主要遵循自由载流子光吸收，氮含量较少时薄膜中的自由电子数目较多，随着氮含量的增加，薄膜中的自由电子数目不断减少，反射率逐渐降低，等离子体频率向低能端移动，从而使薄膜颜色出现规律变化，由金属色银白色到淡黄、金黄再到红黄，并且薄膜亮度呈下降趋势；金黄色的N 薄膜中存在TiN 和ZrN 的分离相，但其为单一的面心立方结构并具有(111)面择优取向；相对于TiN 薄膜，Zr 掺杂后，并没有使薄膜的导带、价带和禁带发生变化，只是在TiN 禁带内增加了新能级，这也正是掺杂Zr 后，薄膜仍

Results:According to different part of the vessels,there were 2 types:type 1,from the superficial surface of anterior belly of digastric muscle to the surface of inferior margin of mandible to subcutaneous part,accounting for 36%;type 2,from the deep surface of anterior belly of digastric muscle to the deep surface of inferior margin of mandible to s...

结果 ：根据血管走行差异分：1型：主干经二腹肌前腹浅面到下颌骨下缘表面至皮下占 3 6%，2型：主干经二腹肌前腹深面到下颌骨下缘深面至皮下占 64%；1型血管位置表浅，易于分离，且蒂较长，旋转度大，2型相比反之。结论：根据颏下动脉走行设计不同皮瓣的大小来修复面部皮肤组织

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。