分析试验

In this paper a six-story steel frame model is studied by ANSYS which is a numerical analysis program based on the experiment of this model to analysis the effect of the story isolation.

本文在一六层钢框架模型试验的基础上，利用有限元分析软件ANSYS对该模型进行理论分析，旨在分析层间隔震结构的隔震效果。

Analyze the results of the six-minute walk test (6MWT) in patients with adolescent idiopathic scoliosis.

目的：分析原发性脊柱侧凸青少年患者六分钟走路试验(6MWT)试验结果。

In order to ensure the success of industrial test of directly producing master alloys in a shaft furnace, theoretical analysis, detailed process calculations and a series of process experiments were completed.

为确保实现在竖炉上直接冶炼不锈钢母液的工业试验顺利完成，试验前专门进行了理论分析、详细的工艺计算以及一系列的工艺准备实验。

A new special economical experimental unit which applies to the R717 recurrence system of the screw compressor with the economizer has been designed and set up. The experiential results of the single stage recurrence and recurrence with the economizer, such as refrigerating capacity, shaft power, volumetric efficiency etc, under different conditions are got from the experiments. The author analyze and the calculate results of theory in this paper.

建立了独特节能的R717工质带经济器螺杆制冷循环系统的试验装置，通过对所研究压缩机的试验测试，得到了普通单级螺杆循环和带经济器螺杆循环在各种工况下的制冷量、轴功率、容积效率、相对补气量、中间压力等数据，并与了本文理论计算的结果进行了比较分析。

At last, matching of groove and welding seam test are carried through. The result of test is analyzed.

最后进行了坡口及焊缝图像处理试验，并对试验结果进行了稳定性分析。

According to the similarity rule for the scale test, the experimentations of several scale projectiles perforating the RC targets are conducted.

按照相似准则对动能弹贯穿钢筋混凝土靶板进行了弹道试验研究，分析了钢筋混凝土的动态破坏特征，为数值模拟提供了可靠的试验数据。

On the basis of above-mentioned theory, Lime rock specimens indifferent scale series from Hebei Jingxing is tested under uniaxial compression.Besides, through numerical simulation and test of coal specimens from Datongand Luan scale effects rule is found out. And that, physical and mechanicalcharacteristics of specimens are studied under uniaxial compression.

基于上述理论认识，通过对室内不同尺度系列的井陉石灰岩单轴压缩试验和数值模拟，以及对大同、潞安的有关煤样试验，得出了尺度效应相关规律，并对岩样在单轴压缩过程中相应的物理力学现象进行了分析研究。

It is suggested that this defect is originated from the internal crack and the subcutaneous bubble s of billet,as well as unreasonable pass design of roughing mill.

通过对试样进行金相分析，对铸坯表面修磨试验结果分析及对连铸坯在高线粗轧第1道和第2道轧制的受力和变形的分析，发现盘条表面的一种特殊的线状缺陷形成的原因是连铸坯存在边内裂和皮下气泡，粗轧机组(特别是第1和第2架)孔型设计不合理，也促进这种线状缺陷的形成。

Currently the related research on the large-diameter cast-in-place pile embeddedin rock is relatively less.

作者在采用单桩竖向抗压静载荷试验对大直径嵌岩灌注桩竖向承载性状试验进行研究时发现，上述假定不适用于桩-岩体系的嵌岩桩承载性状的分析研究，并建立了桩—土荷载传递计算模型。

Adjuvant external beam radiotherapy in the treatment of endometrial cancer (MRC ASTEC and NCIC CTG EN.5 randomised trials): pooled trial results,systematic review, and meta-analysis

外照射辅助治疗子宫内膜癌（MRC ASTEC和NCIC CTG EN.5随机试验）：试验结果汇集，系统性回顾和Meta分析

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。