分析设备

In this paper, the producing process of condensed soybean lecithin was explained, by studying the concentrating technology of soybean lecithin from hydration soybean oil gleditsia in industrial conditions, and the production process control was also described.

通过研究在工业条件下，如何利用水化豆油的油脚加工浓缩大豆磷脂，详细介绍了大豆磷脂的生产工艺过程，并对生产过程中的工艺条件控制进行了逐一的分析论述，同时对关键生产设备和操作安全注意事项进行了重点描述。

In this paper, the producing process of condensed soybean lecithin was explained, by studying the concentrating technology of soybean lecithin from hydration soybean oil gleditsia in industrial conditions, and the production process control was also described. Meanwhile, the safety operation guide lines, especially on the key equipments, were expatiated.

通过研究在工业条件下，如何利用水化豆油的油脚加工浓缩大豆磷脂，详细介绍了大豆磷脂的生产工艺过程，并对生产过程中的工艺条件控制进行了逐一的分析论述，同时对关键生产设备和操作安全注意事项进行了重点描述。

Process of hydrogen chloride synthesed by two-in-one graphitic synthetic furnace and its specification of equipment were briefly introduced.

简要介绍了二合一石墨合成炉合成氯化氢的工艺流程及设备规格，并对运行情况进行了总结分析。

Clinical requirement in dental simulation is firstly analyzed and performance goal of haptic display is proposed. Based on characteristics of human haptics, software system of surgery simulation and force rendering is developed and prototype of surgery simulation system is established using Phantom desktop. Dental exploration and cutting operation in cavity preparation are simulated with haptic and graphical display capabilities.

全文首先通过分析牙科手术模拟的临床需求，提出了力觉显示手术仿真系统的模拟指标；针对操作者触觉生理学特点，基于力觉交互设备Phantom desktop，开发了手术仿真和力觉渲染软件，建立了手术模拟原型试验系统；以牙面探查和牙体预备中的切削操作作为研究对象，实现了力觉和图形集成显示的手术操作过程模拟。

In the dehydrogenation process of HD process, the temperature set at 580℃ and pressure set at 100Pa is a perfect parameter, it can make the magnet to have high magnetic performance. In the HDDR process experiment, the paper contrast four HDDR process such as C-HDDR V-HDDR V-HD-S-DR and d-HDDR by the anisotropy and magnetic performance of ternary NdFeB magnetic material. The results show that adjusting the parameter of the d-HDDR process can make the anisotropy and magnetic performance of ternary NdFeB magnetic powders to catch up with the hexahydric NdFeBCoZrGa magnetic powders. At the end the paper discusses the betterment of the equipment which produces ternary NdFeB magnetic with the d-HDDR process.

和580℃的脱氢温度相搭配的脱氢气压选择在100Pa左右是理想的工艺参数，这样的搭配使得最终烧结磁体综合磁性能优异；在HDDR制粉工艺实验中，本文对比了C-HDDR、V-HDDR、V-HD-S-DR和d-HDDR四种HDDR工艺对于三元NdFeB合金各向异性和磁性能的影响，得出结论：通过发展d-HDDR工艺，调整工艺参数和控制水平，可以使三元NdFeB合金磁粉的性能达到或接近六元NdFeBCoZrGa合金磁粉的水平，在文章末尾，还对配合使用d-HDDR工艺设备的改造进行了分析。

The results also show that intercooling can lead little improvement in performance and recovering the intercooling heat is of no use, and on the contrary, reheating can remarkably enhance the efficiency and power output of all cycles investigated.

通过分析实际热力循环的特点，根据热力学原理，提出了一种新的估算复杂循环热力性能的方法——系数修正法，其思路为：通过对指定温限间具有最高热效率的埃里克森循环进行设备完善性和循环完善性修正，以达到估算和评价实际循环性能的目的。

Using wireless temperature logger produced by ebro, German, several important factors which influence temperature field obviously have been found. They are loadage, low temperature air mass, temperature controllers and location of temperature sensors. Some suggestions also have been given.

以德国ebro生产的无线温度数据存储器为测温设备，在总结大量实验数据的基础上分析出影响温场的几个重要因素：装载量、残余冷汽团、温度控制器、温度探头位置，并对其影响温场的原理做了通俗易懂的阐述，且结合实际使用情况给出建议。

Through detailing the maloperation process of the circuit breaker because of the defect in the auto-reclosure,this paper analyses the course of the accident and improves the defective protections circuit.

通过对一起重合闸缺陷引起断路器误动作的过程详细描述，分析了误动原因，对有缺陷的保护回路提出了改进方法，较好地解决了重合闸误动作问题，提高了设备运行稳定性。

It is common equipment that be used to explore the preparing technology and analyze the metallographical structure.

利用普通设备，探索了制备工艺过程，分析了金相组织。

Review and update the specifications as necessary for the requirements of Metallurgic and coating lab.

确保实验室测试设备的高效平稳运行，并对实验数据做统计分析

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。