分析曲线
- 与 分析曲线 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Then,the paper analyzes common-mode voltage and output voltage range of operational amplifier influenced by temperature and process problems that may appea.
基于混沌、均匀分布的真随机数发生器的工作电路和精度要求较高的电压参考电路的温度漂移进行分析,给出了仿真得到的温度曲线;分析了工艺中可能存在的问题和温度的影响与运放的共模电压和输出电压幅度,以及与混沌公式直接相关的开关电容等,根据最坏分析得到混沌公式,给出了仿真测试结果。
-
Development and application of software and hardware of open type cast iron thermal analysis of cast iron melt inspection have been reported with explanation of each module function of analysing and calculating chemical composition,as-cast mechanical properties and structural characteristics,solidification phase transformation heat,some thermal phisical parameters based on solidifying and cooling curve of samples.
报告了用于检测铁液熔炼质量状况的开放式铸铁热分析软、硬件系统的研制与应用情况,并系统地阐述了根据热分析试样的凝固冷却曲线实现对铁液化学成分、铸态下的力学性能和组织特征以及对凝固相变热和某些热物理量进行分析和计算的各子模块功能。
-
Finally, by means of electrometric method, the stress of the exterior surface of the feed inlet was measured. The curvilinear figure of the stress distribution of the exterior surface was drawed and compared with the results of the finite element analysis. The rationality of theory analysis and the reliability of finite element analysis were verified.
最后,采用电测法对进料口的外表面应力进行了实验测量,绘出进料口外表面应力分布曲线并与有限元分析结果对比,验证了理论分析的合理性和有限元分析的可靠性。
-
Lysis software SPSS13.0 to carry out comprehensive economic strength factor analysis and curvilinear regression analysis of kezuohouqi, the two conclusions of a lower score from overall strength factor and a higher factor scores from the level of social consumption and agriculture can be reached.
通过使用SPSS13.0统计分析软件对科左后旗经济综合实力进行因子分析和曲线回归分析,得出该旗综合实力因子得分较低,而农业及社会消费水平因子得分较高。
-
The effect of characteristic parameters on differential thermal analysis curve, solidification setup temperature and cooling rate on dendrite arm space was studied, and IAS-4 Image Analysis System was used for microstructural examination.
本文采用差热分析方法研究DTA曲线特征参数、凝固开始温度和冷却速率对二次枝晶间距λDAS的影响,同时使用IAS - 4图像分析系统分析了合金的微观组织。
-
It performs a dual pressure-out curve analysis of the actual typical wells and proves that this method conform to the actual conditions and is used widely in Daqing Oil Field.
对现场实际典型井进行了双憋压曲线分析,该方法分析符合实际,并在大庆油田得到了推广应用,有的地方作为一种判断分析泵况的规定资料录取。
-
Fisher's exact test and odds ratio with its 95% confidence interval were used to analyze the relationship of pulmonary artery to lesion with the possibility of malignancy. The degree of pulmonary arterial encasement in the benign lesion and malignancy was evaluated by Wilcoxon rank sum test. The agreement between 2 observers was evaluated by kappa statistics. In addition, the sensitivity and specificity profiles of the degree of encasement in diagnosis of malignancy were determined by plotting an empirical ROC curve.
肺部病灶及其邻近肺动脉之关系来预估恶性的可能的资料分析方法为费氏分析检定法(Fisher's exact test),胜算比以及95%信赖区间;评估肺动脉被包埋压迫的程度用在预估恶性肿瘤之能力是使用威尔科克逊秩和检定;2位观察者间的同意度之检定是用Kappa 统计分析;除此之外,用肺动脉被包埋压迫的程度来预估恶性肿瘤之能力的敏感度以及特异性是用接受者操作特徵的曲线来评估。
-
Afterwards, Euler distance acts as classifying criterion and experimental results show that the three methods can classify fire alarm effectively. Finally, performance of the three classification identifier is compared by means of ROC(receiver operation characteristic), error rate and calculation complexity.
最后从计算复杂度、ROC曲线方法和所需存储空间三方面,对三种分类器性能进行了分析比较,结果显示FFT频域分析的方法更适合于对空预器再燃烧进行分析检测。
-
The fatigue is analyzed for the SENT specimen of TA6V titanium alloy at different stress ratio and on different stress level by the general finite element analysis software ANSYS. The dangerous fatigue location is predicted by the nodal stress Y-direction of the hemicycle notch for TA6V titanium alloy SENT specimen. Based on the local stress-strain method and the material S-N graph, the nominal stress-strain of the specimen is converted to the local stress-strain of the dangerous location by the elastic and plastic finite element analysis, thus the fatigue life is estimated by Miner fatigue damage accumulation theory and compared with the fatigue test of small crack growth.
借助大型通用有限元分析软件ANSYS对TA6V钛合金SENT试样在不同应力比和不同应力水平下进行疲劳分析,根据SENT试样缺口处的应力状态分布预测疲劳危险部位,采用局部应力应变法,结合材料循环的S-N曲线,通过弹塑性有限元法将构件上的名义应力谱转换成危险部位的局部应力应变谱,从而根据危险部位的局部应力应变历程采用Miner累积损伤理论对构件的疲劳寿命进行估算,并与疲劳小裂纹试验数据进行比较分析。
-
Applying integral intermediate value theorem, new effective elasticity modulus expressions were presented, which creep aging coefficient can be calculated by the creep coefficient of intermediate time of incremental time segment. Creep and shrinkage strain were treated as a kind of compulsive strain. Compulsive strain methods were used for the analysis of creep effect and shrinkage effect about concrete curved box-girder bridge.
根据积分中值定理,推导了增量时间段中点时刻徐变系数等效弹性模量的计算式;将徐变和收缩应变视为强迫应变,推导了强迫应变法计算混凝土梁桥的徐变、收缩效应的分析方法,写出了混凝土桥梁的徐变、收缩时效分析有限元列式,并将此方法应用到曲线箱梁桥的时效分析中。
- 推荐网络例句
-
And discuss some key point of integrated management system design, include hazard identification and risk assessment and risk control in the occupational health and safety management, the measure of satisfaction target of customer, the flawlessness of law system, the integration of the integrated management system and enterprise standardization system, unify lead institution and work orgnization, integreted internal audit and integrated management review.
同时,论述了一体化管理体系构建中的几个主要问题,包括职业健康安全管理中的危险源辨识、风险评价和风险控制、顾客满意度的科学监测、法律、法规体系的完善、一体化管理体系与企业标准化体系的有机结合、统一的领导机构和工作机构、一体化的内部审核和管理评审。
-
Deepwater Taranaki is investigated for its petroleum potential, using all available seismic data tied to shallow-water wells.
运用与浅水井相关的现有全部震波探测数据考察了深海区塔拉纳基盆地的油藏前景。
-
If you're huffing and puffing at any point during the run, slow down and make sure you can take deep breathes.
如果你任何时候在跑步过程中气喘如牛,降低速度并且确保你能够深呼吸。