英语人>网络例句>分析曲线 相关的搜索结果
网络例句

分析曲线

与 分析曲线 相关的网络例句 [注:此内容来源于网络,仅供参考]

Dynamic and static comparative analyses of settlements of overlength PHC pipe piles

基于5根桩现场试验资料的分析,对表征管桩承载性状的桩顶荷载-桩顶沉降曲线、桩身压缩-桩顶荷载曲线进行了数学描述。

By integrating drilling and well logging data, the Jurassic system was divided into 6 Ⅲ sequences and 17 systematical domains. The sequence boundary was identified by using the terminal correlation of seismic reflection, regional lithologic interface, changes of paleontologic distributive characters, number of logging curve and its style discontinuity. The systematical domain was divided based on the recognition of the first flooded surface and maximum flooded surface and in combination with analysis of parasequence superimposed style.

综合钻井、地震等资料,将滴南凸起侏罗系划分为6个三级层序和17个体系域,应用地震反射终止关系、区域性的岩性界面、古生物分布特征的变化、测井曲线数值和形态突变等进行了层序边界的识别;在依据岩性和测井曲线的变化识别首次湖泛面和最大湖泛面,并结合准层序叠置样式分析的基础上,进行了体系域的划分。

Drying experiment of pelleted corn seed was conducted through three factor and three level orthogonal experimental design, its drying characteristic curve was obtained as an index curve, and the effects of various experimental factors on drying property were analyzed....

采用正交试验的方法,对玉米丸粒化种子进行了 3因素 3水平的干燥试验,得出其干燥曲线为指数曲线,并分析各试验因素对干燥特性的影响。

Address the characteristics of non-uniform speed transmission, position function control and transmission ratio function control were presented to realize electronic gearbox. The differences between position function curve interpolation and general NC interpolation were analyzed. Considering the effect of uncontrollable continuous principal motion, interpolation slope and position function precompensation interpolation were presented. The relationship among interpolation, servo dynamic response and transmission precision was studied. The coordinate linkage relationship and electronic gearbox scheme in noncirclar gear hobbing were studied.

对电子齿轮箱实现非匀速比传动进行了研究,提出了位置函数控制与传动比函数控制两种非匀速比传动关系的实现方法;对位置函数控制方式,分析了位置函数曲线的插补与普通数控插补方法的区别,提出了插补斜率的概念与位置函数曲线的预补偿插补方法;对非匀速比电子齿轮箱传动精度进行研究,得出了插补精度、伺服系统动态性能指标与传动精度之间的关系;研究了非圆滚齿加工坐标联动的非匀速比传动关系,列出了多种可以满足要求的电子齿轮箱传动方案。4。

Based on the analysis of similarities and differences between core data, well log and seismic prospecting, the thesis makes a primary match between them;(2) Through layer boundary dividing by Walsh transformation, lithology determination by gray system and stratigraphy correlation by dynamic waveform match, an application to the aimed area was done;(3) This paper also gives the research on the character of well logs and reservoir parameters. According to the FBM protype, the profile of density and acoustic value between two wells was built. And the result showed good accordance with real logs.(4) By means of fractal reconstruction, it rebuilt the three dimensional shapes of the main stratigraphy boundaries in the studied area.

在详细分析总结岩心、测井和地震数据异同点的基础上,对三种数据进行了初步的匹配;②通过对测井曲线的沃尔什变换分层、灰色关联法岩性判别,综合多种动态层序对比技术,增改对比过程所需要的参数,进行了井间地层对比方法的探讨与应用研究;③详细研究了测井曲线以及储层参数分布的分形特征,以分数布朗运动为原型模拟出两口井中间对应地层的密度和时差参数剖面,结果与验证井数据表现出了良好的一致性;④采用分维重建方法再现了研究区块泉头组顶底面以及登二段底面的空间形态。

Based on a lot of experiments, it shows the distinct error between classical theory curve which express the relation of cell diameter, cell density and foam tensile strength , tensibility tensile product and re-spring degree and experiment curve. It also can't explain the relation of hole degree , area of cell wall with above four mechanics parameter. But the sub-cluster scale theory was demonstrated successfully to explain the relation of cell structure and foam mechanics property on different mold temperature, mold pressure, mold period and different chemical blowing agent, blowing activator content.

通过大量的实验结果理论分析表明:以往的经典理论存在着很多不足之处,它不能有效地解释孔径、泡孔密度与抗拉强度、断裂伸长率、断裂功、及回弹率之间的理论曲线与实验曲线之间的偏差,也不能解释空隙度、泡孔壁厚与上面四者之间的关系,而群子标度理论则成功地论证了在不同模压温度、模压压力、模压时间及不同用量发泡剂、发泡促进剂条件下泡体力学性能与结构之间的相关性。

Taken A 200MW unit as an example, the unit's cold end system characteristic curves were drawn. The curves considered various conditions, including the forced velocity of air, the air temperature, scale thermoresistance in pipe and condenser heat load.

以某200MW 直接空冷机组为例,通过仿真模型计算出不同风速、风温和排汽量下凝汽器冷端系统特性曲线;并且分析了管内污垢热阻对凝汽器压力的影响,画出了影响曲线。

By analyzing the equivalent network model, a new method with the resonant frequency of six strange points on the amplitude plot and phase plot of transmission coefficient S21 for computing the coupling coefficient has also been proposed in the thesis.The full-wave EM simulation has verified validness of the method by utilizing the models, which has been established with HFSS.

通过等效网络的理论分析,提出利用传输系数幅度曲线和相位曲线上的六个奇异点对应的谐振频率计算耦合系数的方法,并用HFSS建立模型,通过全波仿真计算验证了上述方法。

Through analyzing the in-situ test data , the curves of pile and soil top average stress ratio of composite foundation changing with embanking time were obtained . The rules of road foundation settlements in the center and pile top varying with embanking time were studied , and the pore pressure laws changing with time were discussed .

通过对现场测试数据的分析,得到了复合地基顶部桩土平均应力随填土时间的变化曲线,研究路基中心和桩顶沉降随填土时间变化规律,并讨论了孔隙水压力随时间消散曲线和侧向位移沿深度变化规律。

The data from stress box indicate that the observed values usually are smaller than the theoretical ones, and the relationship between the vertical or lateral stress and the fill soil thickness can be described in a power function curve: a- a hb. The fact that the soil stress is bigger in the portion adjacent to the central part of gully and becomes smaller in the portion close to the side illustrates that the gully has an apparent unburdening effect. From the monitoring results of the settlement deformation during and after constructingperiod, the study conducts statistical system analysis and evaluation on the change of settlement with time.

根据压力盒测试结果表明,测量值往往比实际的理论计算值小,填土的竖向和侧向土压力与填土厚度可以用幂次型曲线表示:σ=ah~b愈向沟谷中心部位,土压力值愈小,愈向沟谷边缘,土压力数值越大,说明沟谷边坡具有明显的卸荷作用;根据施工期和工后期的沉降变形监测数据,对路堤内各测点的竖向沉降随时间的变化规律进行了数理统计系统分析和总结,工后期路面沉降和时间关系可用对数曲线表示:S=aln+b,并根据此沉降规律对高填方加筋土路堤的工后沉降进行了预测。

第30/100页 首页 < ... 26 27 28 29 30 31 32 33 34 ... > 尾页
推荐网络例句

However, as the name(read-only memory)implies, CD disks cannot be written onorchanged in any way.

然而,正如其名字所指出的那样,CD盘不能写,也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口,替代木托盘,免薰蒸,符合欧盟、北美各国对出口货物包装材料的法令要求;喷涂钢托盘适用于重载上货架之用,托盘表面根据需要制作成平板状、波纹状及间隔形式,满足不同的使用要求。

A single payment file can be uploaded from an ERP system to effect all pan-China RMB payments and overseas payments in all currencies.

付款指令文件可从您的 ERP 系统上传到我们的电子银行系统来只是国内及对海外各种币种付款。