分布规律

The conclusion is that inductive electromotive force, gotten from sensor with the distribution regularities of weighting function, is proportional to the average flow velocity in pipe and is not relevant to the distribution of flow velocity when flow velocity is non-central symmetry with the central axis.

得出按权重函数分布规律的传感器，在流速非中心轴对称分布时，感应电势仅与平均流速呈正比，而与流速分布无关的结论，从而从原理上解决电磁流量计了高精度测量的问题。

For simply research, HMM assume the time of continuous states staying obey geometry distributing.

为了研究方便，隐马尔科夫模型假设连续段长分布的时间是服从几何分布，但这与真实的分布规律并不相符。

With selecting earlap as the measuring spot,a multi-layer simulation model of the earlap is established.The transmittance of the earlap model and its distribution regularities under vary beam properties(beam radius,the input energy and its distribution) and model parameters are researched by Monte-Carlo method.

选择耳垂作为测量部位，建立了多层耳垂组织仿真模型，利用Monte-Carlo方法研究了不同光源特性(光束半径，入射能量大小及分布等)及模型参数下耳垂组织模型的光透射能量及分布规律，由透射光能量分布、光电二极管光敏面积和探测灵敏度推出特定测量信噪比要求的入射光能量。

The distribution of fig trees in the world was presented in this paper, and then the distribution and research advance of fig species in China were elaborated, suggesting the importance of understanding of Ficus species occurred in China for the worldwide researches.

介绍了榕树在世界的分布规律，着重阐述了榕树在中国的分布及中国榕树分布种的研究现状与存在的问题，探讨了中国榕树的花序特点、开花物候及在协同进化中的意义，指出了中国榕树资料在世界研究中的地位和作用。

Studied present measuring methods" advantages and disadvantages, and presented the necessity and importance of researching propellant transient heat transfer.2.according to 130 and aeronautic 90 rocket projectiles" structure, analysed and acquired physical and mathematical models for propellant transient heat transfer, also designed propellant temperature field simulation units for test.3.acquired discrete transient heat balance equation and temperature calculation program, and gave contrasting curves between experimental temperature values and program calculating temperature values as well as maximum errors and average square root errors between them.4.by programs based on the first class boundary condition, worked out temperature distribution in propellant temperature field simulation units at different time, analysed temperature field distribution law and main elements affecting heat transfer, acquired propellant mass weighted average temperature and one at the half position of propellant maximum thickness as well as maximum errors and average square root errors between them.5.established transient heat transfer mathematical model and temperature calculation program for the third class boundary condition, drew contrasting curves between temperature experimental values and calculation values and gave maximum errors and average square root errors between them, got temperature distribution in the simulation unit at different time and main elements affecting heat conduction, figured out propellant mass weighted average temperature and one at the half position of propellant maximum thickness as well as maximum errors and average square root errors between them.

分析了现有测试方法的优缺点，提出了研究推进剂瞬态导热的必要性和重要性。 2。根据130和航90两种火箭弹的结构，分析得到了推进剂传热的物理模型和数学模型，设计了推进剂温度场模拟实验装置。 3。得到了离散形式的瞬态热平衡方程和温度场计算程序，给出了实验温度与程序计算温度值的对比曲线及其最大偏差与均方差。 4。利用程序求出了第一类边界条件下、不同时刻推进剂温度场模拟装置中的温度分布，分析了温度场的分布规律和影响传热的主要因素，求出了推进剂质量加权平均温度和最大肉厚1／2处的温度时间曲线并给出了两者之间的最大偏差与均方差。 5。建立了第三类边界条件下的瞬态导热数学模型和温度计算程序，求出了温度实测值与计算值的对比曲线并给出了两者之间的最大偏差与均方差，得到了不同时刻温度场模拟装置的温度分布与影响导热的主要因素，求出了推进剂质量加权平均温度和最大肉厚1／2处温度及两者之间的最大偏差与均方差，讨论并确定了能代表130和航90推进剂温度的特征点的位置。

Using this kind of fluxmeter, the heat-flux distribution in a pulverized-coal tangentially-fired test furnace under different operating conditions, the effect of sandwiched-air on the heat-flux and the dependence of the distribution on the coal properties were measured and investigated.

利用该辐射式热流计，作者测试并研究了四角布置切向燃烧锅炉炉膛内在不同燃烧工况下的辐射热负荷分布规律、夹心风的投入与关闭对炉内热负荷分布的影响，以及煤种变化时炉内热负荷分布的变化。

Thethesis compares the characters of ecosystem service in different district, main drainage basinand different segment in it, confirms the rules that the ecosystem service value is higher insouthern area than northern area and different characters along river and ridge. The ecosystemservice value is decreased regularly with the increasing of population density and elevationby compared analysis. The results of the ecosystem service values in 1981 and 2001 shows arule that ecosystem service value is steady for whole researched region and fluctuate in localarea in LRGR.

本文对比了各行政区、主要流域以及流域内部不同区段的生态系统服务功能特点，确定纵向岭谷区生态系统服务功能价值存在着南高北低的空间分布规律，且在河流、山脊处有着不同的变化特点；通过分析不同人口密度和海拔梯度下生态系统服务功能的价值，得出生态系统服务功能价值有随人口密度和海拔升高而下降的规律；通过对比81年与2001年生态系统服务功能价值的变化，阐述了纵向岭谷区生态系统服务功能价值总体稳定、局部变化的规律。

The flash butt welding parameters, such as flash model, flash velocity and initial clamp distance were analyzed quantitatively. The rule of heat producing and temperature distribution by different welding parameters in coupling with electric and heat was researched.

对钢轨闪光焊过程中闪光模式、闪光速度及起始夹具距离等规范参数的变化规律进行了定量分析，揭示了电热耦合过程中不同焊接规范组合下的产热规律和温度分布规律。

The forming process and the characteristics of plastic deformation, the sites of the heavily strained zones with severe thickness reduction and their evolution, the influences of the main processing parameters, such as the plastic melt pressure and its distribution from the gate to the end of the mold, and of friction coefficient between the sheet flange and the mold, on these during the hybrid forming of the aluminum sheet have been revealed by the updated Lagrange finite element formulation for the finite elastic-plastic deformation.

运用弹塑性大变形更新的Lagrange有限元方法，揭示了铝薄板的成形过程和塑性变形的特点与规律、大塑性变形区的产生位置及其塑性变形特点，探明了复合成型过程中塑料熔体压力及其分布规律以及铝薄板凸缘与模具摩擦系数等主要工艺参数对铝薄板成形过程和塑性变形的影响规律。

The effects of gas-liquid ratio, oil saturation and permeability on nitrogen foam flow law in porous media were studied systemly. Oil saturation is the main influential factor of foam's fluidity, and just for this, the aggravation of formation heterogeneity has little effect on the effect of the profile control, foam's flow law is decided by remaining oil distribution.

系统研究了气液比、含油饱和度、渗透率对氮气泡沫渗流规律的影响，结果表明，含油饱和度是影响氮气泡沫渗流阻力的最主要因素，泡沫渗流阻力随着含油饱和度的升高而降低，剩余油分布规律决定了调驱过程中氮气泡沫的渗流规律，受此影响，地层非均质性的增加对泡沫调剖效果的影响较小。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐