分布系数

Therefore,the complicated problem is simplified into asolving procedure of a group of infinite dimensional algebra equations.In thefact,not only is a general solution of the problem obtained,but also a method tocompute the dynamic thermal stress distribution at the surface of the cavity afterthe definition of the coefficient of the dynamic thermal stress distribution isgiven.

事实上，不但得到了单连通区域或复连通区域型二维孔洞表面的动态热应力分布问题的一个一般的解析解，而且，在定义了非耦合和耦合无量纲化动态热应力分布系数后，推导出计算单连通区域或复连通区域型二维孔洞表面的动态热应力分布的方法。

Defines a d imensionless initial height of a heat source to reflect the effect of a heat source on heat distribution regularity of an air conditioned room with upward displacement, using variance analysis method obtains the dimensionless relationship between the heat distribution resularlty and other factors as Arn, Zr,ZJ and DIHHS, and reveals their importance in desoendins ceder as Arn, Zr, DIHHS and Zj.

提出了用热射流起始无因次高度来反映热源起始高度对下送风空调房间热分布系数α的影响，利用回归原理得出了α随阿基米德数Ar_n、热射流自由度Zr、机械射流自由度Zj及热射流起始无固次高度变化的准则关系式。用连结向量图法和对实验数据回归公式的F检验，对影响室内热分布规律的各个因素进行了分析，发现这些因素均为主要影响因素，其影响的相对主次依次为Ar_n，Zr，和Zj，回归结果具有很强的显著性。

The proposition of the horizontal distribution coefficient provide reliable basis for the analysis and design of high road dike in mountain area.

该分布系数的提出，为山区高填土路堤边坡的抗震稳定性分析设计，提供了可靠的依据。

Weakly acidic and basic drug analysis ; fixed pH titration ; distribution coefficient ; acid dissociation constant of drugs

弱酸弱碱性药物分析；固定pH滴定；分布系数；药物酸离解常数

Based on analysis and certification of a large number of measured data of different channels and different discharges, it is shown that weather theoretical form or measureds results of lateral velocity distribution are consistent with the laws of logarithmic distribution.

大量不同梯拱形渠道、不同流量的流速实测数据分析和验证表明，理论与实测流速横向分布都符合对数分布规律，利用多变量回归分析，确定了流速横向分布系数a、b值。

The coefficients of load distribution along the contact line of pitch position in axial middle section are obtained.

应用它计算了六对齿轮在不同接触线上的载荷分布，得出齿轮在轴向中间截面节点位置啮合时接触线上的载荷分布系数，分析了轮齿刚度的变化规律，给出轮齿刚度的简化计算公式。

Based on it, the research content of this dissertation has been determined. Tuan Shan River Bridge is selected as an example and APDL is used to analyze the elastic properties. After calculating the internal force influence surface of assembly skew hollow slab bridge, the internal force-controlling section is attained; the transverse distribution of internal force is studied and the transverse distribution coefficient is parametric analyzed. Based on the results, relation formula of transverse distribution coefficient between skew and perpendicular bridges are fitted. Practical calculation method for the internal force calculation of assembly skew hollow slab bridge is offered. Some conclusions are drawn from comparing and analysing the internal force, bearing reaction and deformation of both assembly and monolithic skew slab bridges.

本文对装配式斜交空心板桥的发展现状进行了综述，从此出发，确定了本文的研究内容，以团山河大桥为工程背景，采用ANSYS 提供的参数化语言APDL，对装配式斜交空心板桥弹性特性进行全面分析，计算了装配式斜交空心板桥的内力影响面，得到内力控制截面；同时计算了内力的横向分布影响线和横向分布系数，并对内力横向分布系数进行了参数分析；基于参数分析的结果，拟合了装配式斜交空心板桥与对应正交桥内力横向分布系数的关系式，为装配式斜交空心板桥的内力计算提供了实用计算方法；对比分析了装配式斜板桥与整体式斜板桥的内力、支座反力以及变形特点，得出了一些有益结论。

Designed the sensitivity algorithm that is based on dc tide, built mathematical model; to give out the definition of a few kinds of sensitivity coefficient and computation are formulary, if power transmits distributinging coefficient , spur track leaves to distributing coefficient and spur track leave to transmit distributinging coefficient .

梗概： 设计了基于直流潮流的灵敏度算法，并建立了数学模型；给出了几种灵敏度系数的定义及计算公式，如功率传输分布系数，支路开断分布系数和支路开断传输分布系数。

Through designing of composition and structure of the bioactive graded coating,innerstress and its distribution in the coating were analyzed and calculated, the resultsshowed that when composition distribution coefficient n was 1.5, a reasonable stressdistribution could be got, that was at the beginning of deposition the suspension containingrichly BG granules was used so that a rich BG granules layer, a good transitional layerbetween BG layer at the bottom and the coating could be obtained at the titanium alloy side,the bottom of the coating; the stress value near the interface and surface and its character,pressure stress or tensile stress, were decided by the character of its composition itself.Changing composition distribution coefficient n could only change the variation tendency ofstress in the coating, but did not change the stress distribution rule in the coating. Thethinner the coating is, the sharper stress variation in the coating is, which does not mean thatthicker coating is better because the thicker the coating is, the little the permitteddeformation of coating is, so the coating thickness should be thinner, for example, about50μm for bending applications, but for applications only bearing pure shear stress, such asroot of tooth implant, the coating can be thicker little, for instance, about 80～100μm. The study on electrification characteristic and electrophoresis deposition of HAand BG granules in aqueous and non-aqueous solution system found that EPD almost didn'toccur in aqueous solution system. However, because HA granules take position charges inabsolute alcohol, a homogeneous EPD be carried out on the cathode titanium alloy slice, but taking negative charge in absolute alcohol the BG granules not be deposited on the cathode. A guided HA crystallizing, 100～300nm, on surface of the BG granules be realized by metathetical reaction, which cover BG granules with HA microcrystals and make the covered BG granules taking position charges in absolute alcohol, sequentially realize the EPCD of the BG and HA granules on the cathode, so it is feasible to make a titanium alloy/BG/HA bioactive graded coating by making use of EPCD technology. The corrosion experiment of rich boron bioglass coating and plasma spray coating showed that split phase, rich boron and rich silicon phase, occurred during its preparation. In basic medium the corrosion behavior of 〓 BG coating showed uniformity corrosion, the corrosion mostly occurred at rich boron phase area, therefore batch formula design of BGshould avoid the occurring of split phase. The corrosion appearance of plasma spray coatingappeared a non-uniform corrosion, mostly occurred at the edge of the laminated HA moltendrops, and emerged an accelerated corrosion tendency, which will easyly lead to corrosioncrackles extending to the interface and the happening of osmotic interfacial corrosion, thatmay be one of the major reasons leading to the coating cracking-off in the later period. Thetesting results of thermal expansion coefficient of 〓 and 〓BG showed the thermalexpansion coefficient of 〓 BG matched with that of titanium alloy better, and 〓 BG couldsinter with titanium alloy into densification enamel layer at low temperature (720℃).

将Ti6Al4V合金在1000℃下进行真空热处理会降低其力学性能，且合金内的V元素会向表面富集，因此，钛合金真空热处理和表面涂层的烧结温度不能过高，即应低于其相转变点；通过对生物活性梯度涂层的组成和结构的设计，分析和计算了梯度涂层内的应力大小和分布，结果表明：对于本研究，当成分分布系数n=1.5时，可以获得较合理的涂层力学性能，即在沉积开始时，采用富含BG颗粒的悬浮液，以便在钛合金侧获得同底层BG有良好过渡的富BG涂层；梯度涂层界面和表面的应力大小、性质由材料组成本身的性质决定，改变成分分布系数，只能改变涂层内应力变化的趋势；涂层的厚薄不影响涂层内的应力分布规律，但涂层越薄，涂层内的应力变化越快，但这并不意味着涂层越厚越好，因为涂层越厚，涂层允许的变形越小，对于应用于弯曲受力部位的涂层而言，涂层应薄一点为好(50μm)；而对于仅纯受剪切应力的部位，如牙根种植体，涂层可适当加厚(80～100μm)；通过对HA和BG颗粒在水溶液体系和非水溶液体系中的带电特性和电泳沉积的研究发现，它们在水溶液体系中很难发生电沉积；在无水乙醇溶液中，HA颗粒带正电，可在阴极钛合金片上发生均匀的电泳沉积，而BG颗粒则带负电荷；利用复分解反应法，可以制得100～300nm的HA，通过诱导HA在BG颗粒表面结晶，可对BG颗粒进行表面包覆，获得了被HA包覆的BG颗粒，改变了BG颗粒表面的带电特性，使BG和HA颗粒在无水乙醇中均带上正电荷，从而实现了HA和BG颗粒在阴极上的共沉积。

Proceeded for beam strength and stress; analysis and checking calculations are made of Traverse beam and surface plate.

将所推荐桥梁进行了全面的计算分析，利用横向分布系数确定活载分布，求得上部结构主梁的内力，从而确定主梁配筋，然后进行主梁强度和应力验算，并分析验算了横梁和桥面板。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。