几何分布

The magnet size （here the angle of the magnetic pole was used） modification to eliminate the phase shift was estimated by using a hard-edge approximation to the magnetic field distribution along a circle.

给出了由滑相角度估算磁极张角修正量的方法，根据滑相角度计算磁场沿圆周的平均值与等时性场的偏差；为消除此偏差，将磁场沿圆周的分布做硬边界近似，估算出磁极几何尺寸的修正量。

A geometric optical and radiative transfer model was proposed to simulate hemispherical gap frequency.

在此基础上建立了一个几何光学和辐射传输混合模型模拟半球空间的孔隙率分布。

Simplicial homology group; topological invariant; homotopy type invariant; degree distribution; clustering coefficient; average distance; simplicial complex; triangulation; complex network; orientability

基础科学，数学，几何、拓扑单纯同调群；拓扑不变量；伦型不变量；度分布；簇系数；平均距离；单纯复形；三角剖分；复杂网络；定向

The regularities of casing strength distribution were obtained by means of Latin Hypercube stochastic simulation method based on Monte-Carlo method.

采用基于Monte-Carlo方法的Latin Hypercube随机模拟方法，模拟得出了套管强度的分布规律以及套管几何尺寸和管材力学性能的随机性对套管强度随机性的影响规律。

The usual travel time tomography method is based on geometrical ray theory,however,it assumes that the seismic wave has very high frequency,which often makes the tomographic inversion have ill posed problem because of the sparse ray distribution in the model space and finally affects the reliability and resolution of the tomographic results.

基于几何射线理论的旅行时层析方法假设地震波频率足够高，这样往往由于射线存模型空间的稀疏分布，使层析反演问题具有严重的不适定性，从而极大地影响层析成像结果的可靠性和分辨率。

The paper resolves the difficulty of time and space integration through the geometry principle based on the hypothesis of the linear density distribution that is adopted here.

本文在推导过程中采用了稠密车流线性化密度分布的假设，并在此基础上利用几何原理解决了时空积分的困难。

The current research points out that for the CFCHS joints the linear extrapolation method can be used for chords,whereas the quadratic extrapolation method must be used for braces.The hot spot stress distributions on the CFCHS joints tend to be more uniform and their SCFs become smaller significantly,compared with the CHS joints.Axial tension on the brace puts the CFCHS joints at a disadvantage,which produces higher SCFs than axial compression.The effects of nondimensional geometric parameters β,τ and γ on SCFs of the chords of the CFCHS joints are basically the same as those of the CHS joints,but for the braces,there is a bit difference in the effects of parameters β,τ and γ between the two kinds of joints.Concrete has the function of improving the CFCHS joint rigidity and then decreasing SCFs which is expected to increase fatigue strength,but concrete strength grade does not exert significant influence on SCFs.

研究表明：CFCHS节点的热点应力，对主管可采用线性外推方法，对支管需采用二次外推方法；相比CHS节点，CFCHS节点的热点应力分布趋于均匀，SCF显著减小；CFCHS节点支管轴向受拉比受压不利，SCF增大；CFCHS节点几何参数β，τ，γ对主管SCF的影响效应与CHS节点基本一致，但是对支管SCF的影响效应与CHS节点有些差异；混凝土的作用主要是改善CFCHS节点刚度，从而降低SCF，并预期可提高疲劳强度，但混凝土自身强度等级的高低没有显著影响节点的SCF。

Tectonic subsidence play dominant role in their geometric shapes, basin fillings, sequence evolution and sediment distribution in the Wushi Sag. Outline of the sequences are in shape of box-wedge or sheet-wedge and boundaries of sequences are varied from bilateral fault to monoclinal fault overlap, so that the sequences show distinct semigrabens which overlay in different ways. Seven sequences were formed in different stage of tectonic evolution. The sequence of SQ1 formed in initial rift stage and deposited alluvial sequence. Sequences SQ2-SQ4 developed in intense rift stage and sediment lacustrine sequence. Sequences SQ5-SQ7 formed in late period of rift before thermal subsidence and deposit mere and delta sediment. The place adjacent to the synsedimentary fault is the subsidence center and depocenter; meanwhile, controlling fracture migrates in horizontal made subsidence and sedimentary center of the sag changed.

构造沉降是控制层序几何形态，充填叠置方式、演化及沉积体系分布的最重要因素：凹陷由多个半地堑在不同层序发育时期以不同方式叠置联结而成；受断层控制，层序外部形态有箱状-楔形、楔形-席状披覆型，边界终止方式有双断终止型、单断终止超覆型；不同构造演化阶段层序内部充填的沉积体系各具特征，初始断陷阶段的SQ1沉积冲积层序，强烈断陷阶段的SQ2-SQ4充填湖相层序，晚期断陷阶段SQ5-SQ7内部充填浅湖和河流三角洲沉积；同沉积断层陡坡带沉降迅速、可容纳空间快速增长，是凹陷的沉积和沉降中心，断陷期主控断裂活动时间和空间的变化导致了凹陷沉积和沉降中心的迁移。

A new flux expansion nodal method was developed to solve three-dimensional multigroup neutron diffusion equations in hexagonal-z geometry. The method expands the intranodal homogeneous flux distributions in analytic basis functions for each energy group.

提出了一种在三维六角形几何节块内数值求解多群中子扩散方程的节块法，该方法把节块内各群中子通量分布用解析基函数近似展开。

Analysis by the elastic-plastic finite element model, taking into account the non-linear geometry and Multilinear Isotropic Hardening material mode, adopting the pipe's strain-damage, have a different shape model to limit the impact load and the stress distribution of defects.

分析采用了弹塑性有限元模型，考虑了几何非线性和材料非线性，采用了多线性等效强化模型和管道破坏的应变准则，得到了不同形状模型对极限荷载的影响以及管壁缺陷处的应力分布状态。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。