凝胶

The impact of temperature,pH and ionic strength on the volume phase transition of the hydrogels is studied.The result shows that the volume phase transition temperature of ionizable and thermosenstive copolymer hydrogels depend upon the hydrophilic/hydrophobic character of the comonomers...

结果表明，疏水基末端端基的疏水程度决定凝胶体积相变的速率，随着疏水性单体甲基丙烯酸酯烷基链的增长，凝胶的疏水性增强，凝胶的相转变pH向低pH处迁移；温度高于LCST时，分子间的氢键作用减弱，疏水基团间的相互作用加强，凝胶发生体积相变。

The colour of most detected bands became light in the five media with the order of mannosan, mannose, xylan, glucose and pectin.(4)The pectinase in the supernatant was purified by centrifuge , acetone precipitation and sephadex G-75 cloumngel filtration. The specific activity was increased 9.8-fold with an activity recovery of 32.98%.The molecular weight of pectinase was 42.2KD estimated by SDS-PAGE.

确立了以葡萄糖培养基6h的发酵液为提取果胶酶的最初取样点，发酵液经离心，丙酮沉淀，Sephadex G-75葡聚糖凝胶柱层析后获得了凝胶电泳均一的样品，比活力较原酶液提高了9.8倍，回收率达到了32.98%，用SDS-PAGE凝胶电泳测的纯化后的果胶酶分子量为42.2KD。

Scanning electron microscopy,transmission electron microscopy,circular dichroism and small-angle X-ray diffraction were used to analyze the aggregation mode of CSG in the organogel phase.A hierarchical self-assembly model was proposed to explain the transition from molecular to primary and secondary structure.It is shown from our results that CSG can aggregate into a micellar fibril nanostructure with high length-to-width ratio which is bundled and entangled to form a three-dimensional(3D) network that immobilize the fluid component probably by surface tension.Moreover,sol-gel polymerization of tetraethoxysilane was carried out using CSG in the gel phase.

通过扫描电镜(ScanningElectron Microscopy，SEM)、透射电镜(Transmission Electron Microscopy，TEM)、圆二色谱(Circular Dichroism，CD)和小角X—射线衍射仪(Small-angle X-rayDiffraction，SAXRD)考察CSG分子自组装行为结果表明，CSG形成的聚集体具有多级结构：首先CSG通过手性堆叠自组装形成直径在9—10nm的细纳米纤维，这些细的纳米纤维再以不规则的六方堆积的方式进行排列，构成直径在40—100nm的粗纳米纤维(即细纳米纤维的&捆束&)，最后粗纳米纤维互相粘连形成三维网络状结构，使有机溶剂&固定&，从而形成凝胶；以CSG有机凝胶为模板，四乙氧基硅烷为前体，通过溶胶—凝胶聚合的方法制备了直径大约为100nm的二氧化硅纳米管。3。

The SiO2 gel was prepared through hydrolysis and condensation polymerization of tetraethyl orthosilicate and H2O. The gel and LaNi4.25Al0.75 powders were mixed completely and heated at 500 ℃ for 2 h to obtain samples.

摘 要：以正硅酸乙酯为原料，采用溶胶凝胶法制备多孔SiO2凝胶，将LaNi4.25Al0.75合金粉与凝胶混合在500℃进行真空烧结。

The occurrence of deleterious alkali-carbonate reaction and performance of certain aggregates were determined by detailed petrographic examination of the aggregates in destructive concrete'structures.

在对材料制备过程的研究中，通过对溶胶—凝胶过程及干凝胶不同烧成温度的物相变化的研究，结合热力学函数方法的计算结果，提出了多组份溶胶的形成过程、溶胶的干燥过程、凝胶的烧成过程中的主要物相的生成反应。

The high content of Iohexol, a contrast media, in nanogel based on PNIPAAm dispersion had a profound effect on the volume phase transition of nanogel particles and thermosensitive phase behavior of nanogel dispersion, which mainly due to the presence of Iohexol with polyhydroxy group changed the micro-environment of nanogel particles.

这主要是因为多羟基的碘海醇的存在改变了纳米凝胶粒周围的微环境，使纳米凝胶粒在较低温度时处于收缩状态，并使纳米凝胶的VPTT比不含碘海醇的水分散体的升高10℃。

Using New Zealand rabbit ears cartilage makes chondrocyte suspension, Fibrinogen was mixed with D-hank's makes a final fibrinogen concentration of 50mg/ml mixture solution, then chondrocytes resuspend with fibrinogen solution, chondrocytes-seeded fibrinogen was mixed with thrombin (25U/ml in 40mM calcium choride) to make chondrocytes/fibrin glue polymer. Pluronic F-127 was mixed with D-hank's makes a final Pluronic F-127 concentration of 400mg/ml mixture solution, then chondrocytes resuspend with Pluronic F-127 solution to make chondrocytes/Pluronic F-127 polymer. The chondrocyte concentrations was 10 million chondrocyte/ml of polymer.

为确定纤维蛋白凝胶与Pluronic F-127在注射方式形成组织工程化软骨过程中的优劣，我们进行了如下实验：应用新西兰大白兔耳软骨获取软骨细胞并体外培养，纤维蛋白原应用D-hank's液配制为50mg/ml，然后以纤维蛋白原溶液重悬软骨细胞，再与40mM的氯化钙配制的25U/ml凝血酶混合形成软骨细胞—纤维蛋白凝胶复合物；Pluronic F-127应用D-hank's液配制为400mg/ml，同样用PluronicF-127溶液重悬软骨细胞而形成软骨细胞—Pluronic F-127凝胶复合物。

Secondly, according to the construction and characteristic of the N-isopropylacrylamide and the temperature-sensitivity of PNIPA hydrogel, Pdualistic hydrogel was synthesized by microwave low temperature plasma. The effects of the factors on the swelling characteristic of P dualistic hydrogel, such as treatment time and power of plasma, concentrations of crosslinking agent and total monomers, proportion of AMPS, polymerizing temperature etc, was discussed in detail. The three dimensions structure , thermostability , reversional volume , swelling/deswelling kinetics, temperature-sensitivity and pH-sensitivity of the hydrogel were also investigated. The optimal synthesizing technics of P dualistic hydrogel initiated by microwave low temperature plasma was confirmed.

在此基础上，结合NIPA的结构特征和PNIPA的温敏性，用微波低温等离子体引发聚合了P二元智能凝胶，详细探讨了微波低温等离子体处理功率、处理时间、总单体浓度、AMPS单体浓度、交联剂浓度及聚合反应溫度等因素对P二元凝胶溶胀性能的影响；并对其三维交联结构、热稳定性、失水-吸水动力学、温度敏感性、pH敏感性、体积复原性等进行了研究；确定了适合微波低温等离子体引发聚合P二元智能凝胶的最佳工艺。

The present invention provides a method for preparing biodegradable and biocompatible, porous, polymeric scaffolds for tissue engineering, which comprises the steps of: dissolving a polymer in an organic solvent to prepare a polymeric solution; mixing an effervescent salt in the resulting polymeric solution to give a polymer/salt/organic solvent mixed gel; removing the organic solvent from the polymer/ salt/ organi c solvent mixed gel; and effervescing the salt in the resulting polymer/salt gel to yield a polymeric scaffold.

一种用于组织工程学的生物可降解和生物相容的多孔聚合物支架的制备方法，该方法包括下列步骤：在一种有机溶剂中溶解一种聚合物以制备聚合物溶液；在所得的聚合物溶液中混入泡腾盐，得到聚合物／盐／有机溶剂混合的凝胶；从聚合物／盐／有机溶剂混合的凝胶中除去有机溶剂；和在酸性溶液中浸泡所述凝胶以使所述盐泡腾产生聚合物支架。

The results show that MgO powder is enwrapped by the BST sol during the Sol-Gel process.

结果表明，采用溶胶－凝胶法制备出包裹MgO粉体的BST凝胶，凝胶经干燥、预烧得到BST/MgO复合粉体。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。