凝固

The specific properties of materials, such as the palate adhesion, dynamic cruor, anti-bacterial and the degradability of lysozyme, were studied, which provide valuable data for further application. The main creative ideas are listed as follows:(1) The water-retention chitosan/poly vinyl alcohol blend fiber was obtained by coagulating in 10％ NaOH/ethanol solution, and the blend and crosslink due to GA can enhance the mechanical properties of fiber;(2) The controlled degradable chitosan/gelatin blend fiber was obtained by solution filature, and the mechanical properties were improved;(3) The N-acylchitosan with the different degree of substitution were successfully prepared, and the relationship between structure and properties was estabilished;(4) By a new solvent system of 6％ NaOH/4％ urea for cellulose, the blood anti-coagulant function films were prepared by blending cellulose with chitin;(5) In the same solvent system above mentioned, the anti-bacterial blend films based on cellulose and carboxymethyl-chitosan were prepared, and the relationship of DS and the anti-bacterial property was concluded;(6) The controlled degradable chitosan films was obtained by the chemical crosslink.

本论文的主要创新点：（1）以NaOH水溶液／无水乙醇为凝固液，采用溶液纺丝法制备出保水性壳聚糖／聚乙烯醇纤维，共混和戊二醛交联极大提高了壳聚糖纤维力学性能；（2）用壳聚糖和明胶共混，以溶液纺丝法制备出可控降解的壳聚糖／明胶纤维，并大幅度提高了壳聚糖共混纤维的干、湿态抗张强度；（3）确立了不同取代度N-酰基壳聚糖的合成方法及其膜的结构与性能的关系；（4）利用纤维素新溶剂6％NaOH／4％尿素制备出抗凝血性纤维素／甲壳素共混膜；（5）利用上述纤维素新溶剂制备出抗菌性纤维素／羧甲基壳聚糖共混膜，揭示了羧甲基壳聚糖取代度与抗菌性能的关系；（6）制备出可控降解壳聚糖交联膜。

The best ink in the off-time after opening the packaging end use, not to open the ink on the outside when not in use Add to carton packaging, the cartridge so as to avoid talking about the dust falling into the hands of the next use of the dust caused by plugging into the nozzle first, the head following a reset state of ink wash sponge pad, open the front cover, press the Print Paper knife, move out, the hair can not suction clean cloth towel or sponge the ink pad, a large amount of about 10 days, then wash first, because each sponge pad is printer ink wash drawing of fatigue, if the dust and fatigue more ink will be solidified with the protection of Garra and print images will be the first flush, if the plug was found, and if the use of cleaning 3 seconds is not normal use, we must enter the printer maintenance menu kk2 or use kk1 cleaning, large format printers and a small printer operation principle is similar, if the correct maintenance and use, it will increase the service life, which Like is like a car, but also for us to maintain and are familiar with it

墨水最好在拆开包装后断时间内使用完，不要把打开的墨水放在外面，不用时包装好放入纸盒内，以免墨盒嘴上落入灰尘，下次使用时灰尘进入喷头造成堵头情况，喷头复位状态下面有一个洗墨海绵垫，打开前盖，按下打印切纸刀，往外移，用不起毛的纸巾或布吸干净海绵垫的墨水，用量大的话大约在10天清洗一次，因为海绵垫是打印机每次冲洗时吸取疲墨水的，如果灰尘多就会和疲墨水凝固在一起，对墨头的保护和打印头冲洗会有影像，如果发现堵头情况，如果使用清洗3秒还不能正常使用，我们要进入打印机的维护菜单用kk2或kk1清洗，大幅面打印机和小打印机的操作原理是差不多的，如果正确的维护和使用，它的使用寿命就会增长，这也好比一辆轿车一样，还要我们去维护和熟悉它

This is the washed-out door by the time, one shabby chair, the time was frozen in this moment, the warm and the cold of the history were well integrated together.

这是一扇褪色的门，一个破旧的椅子，凝固的时间，历史的冷暖结合在一起……这个位置，会不会已经空闲了很久了？

Objective To evaluate the applicability of a water-cooled shaft-free microwave therapeutic instrument in percutaneous microwave coagulation therapy of liver cancer.

目的 评价水冷循环式无杆温微波治疗仪在经皮微波凝固治疗中的价值。

Sticky stuff has been solidified, and raised many white and slightly yellow potato lumps, some things just can not describe it swelling on the skin color is brown, yellow and slightly green mixed color.

黏稠的东西已经凝固了，凸起著许多白色的和略带黄色的洋芋疙瘩，有些疙瘩物简直没法形容它的颜色，是褐色的、黄色的和略呈绿色的混合色。

In this way, solidified in the summer sky smile, a long time ...... the wind did not disperse to shake off the last trace of smile, the summer, very much like the smoke, like an end.

就这样，夏天的微笑凝固在天际，久久没有散去……风挥去最后一丝笑意，这个夏季，便像炊烟一样结束了。

Purification is mainly done by adding zinc dust to the solution. As all the elements to be removed lie below zinc in the electrochemical series they can be precipitated by cementation.

净化过程主要是加入锌粉到溶液，这样所有电位序在锌之后的元素都被置换出来并且凝固沉淀下来。

The connection of microstructure and floating zone melting process was studied .

利用EBFZM法，本文研究了区熔工艺和凝固组织之间的关系。

In this paper, two high temperature gradient directional solidification apparatus with liquid metal cooling and electron-beam floating zone melting were used.

本文采用LMC和电子束区熔两种高温度梯度定向凝固装置，研究合金成分及工艺参数对初生相析出行为的影响，优化了自生复合材料的制备工艺。

According to the study on solidification behavior of YBaCuO compound, laser floating zone melting technology is developed to grow YBaCuO superconducting crystals, and the microstructure and superconductivity of the crystal have been discussed.

根据对YBaCuO化合物凝固行为的研究，发展了一种用激光浮区熔化法生长YBaCuO晶体的新工艺，並对用此法制备的超导体的组织与性能进行了分析。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。