冷却通道
- 与 冷却通道 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The result is of significance to the design and manufacture of regenerative cooled channels with high aspect ratio.
结果对液体火箭发动机大高宽比再生冷却通道的设计和制造具有参考价值。
-
The two-year manufacture practice has confirmed the validity and feasibility of developed loxodrome coolant channel milling method.
经过两年多的实际生产过程应用,验证了所开发的斜航线冷却通道加工方法的正确性和可行性。
-
In order to do this, the width of narrow annuli cooling channel of beryllium beam pipe was designed by optimization method, the theoretical analysis and finite element method were used, then the optimal width was chosen, the influence of concentrated heat on the temperature of inner and outer wall was studied, and the optimal working velocity of cooling fluid was given.
本文结合理论分析和有限元数值模拟对束流铍管的冷却环形窄通道尺寸进行优化设计,确定了窄通道最佳间隙,研究了集中热负荷对内外壁温度场的影响,并确定了冷却液最佳工作流速。
-
This study experimentally examined the heat transfer characteristics of 180-deg turning duct under forced convection cooling, as the internal cooling structure of 180-deg turning duct is widely applied to industrial cooling. While several perforated holes were separately arranged within the 180-deg turning duct, the cold flow of better cooling capability was guided in the first duct into the second duct in advance, so as to reduce the overheating of the second duct and realize uniform cooling of the machine members. In addition, the centrally separated holes could yield extra turbulence against the air current, and the interaction between bypass air current and mainstream may possibly improve the overall heat transfer capability.
本研究系以实验方法探讨180度转弯通道於强制对流冷却下之热传递特性,180度转弯通道之内部冷却构型在工业冷却之应用非常广泛,本研究设计将180度转弯通道其中间分隔具多个穿孔,目的在将第一流道内具较佳冷却能力之冷流提早引入第二流道,以减少第二流道产生过热情况,如此可使得机件获得均匀之冷却,此外,中间分隔上之穿孔对气流也具有额外之扰动效果、流经穿孔之旁通气流与主流交互作用,这都有可能增益整体热传能力。
-
Numerical simulation was conducted to investigate the flow field of internal cooling passages with both rib-roughened walls and film hole suctions and discharge coefficients of film holes,with rib angles 45°,60°,90°,120°respectively.
利用有限体积法对三维不可压缩的N-S方程进行离散,对同时带肋和气膜孔出流的内流冷却通道在45°,60°,90°,120°肋的结构下进行了数值模拟。
-
Some primary metering grooves with different curvature radiuses and geometrical dimensions were designed,and the hydraulic characteristics of them were all tested Based on the experiment results, different flow characteristics of them were obtained The great differences between the experimental results and the conventional theoretical predictions were found by the comparison between them Under the condition of this experiment, the critical Reynolds is 1000~1200, and is diminished as the decrease of th...
为了在设计层板发汗冷却推力室时选择合适的一次调节通道,对不同曲率半径、不同几何尺寸的一次调节通道进行了流阻试验,得出了不同几何尺寸的一次调节通道的流动特性。试验结果与经典的层流理论计算结果之间存在较大的差异。试验表明,一次调节通道的临界雷诺数随曲率半径的减小而减小,摩阻系数随曲率半径的减小而增加,并得出了相应条件下的一次调节通道摩阻系数的修正关系式,在层流范围内能较好地反映一次调节通道的流阻特性
-
It is also preventing properties for the pump, packings and cooling channels of the plasma torch.
它对泵,packings 和等离子体割炬的冷却通道也具有保护作用。
-
The contrast hot test of the copper cooling stave with different cooling channels was done in the hot test whole-scale furnace which is designed by the authors.
在自行设计的1:1热态试验炉上对不同孔型的铜冷却壁进行了热态对比试验,对试验结果作了传热学分析,提出优化铜冷却壁水流通道断面设计的方法,优化后的水流通道可以达到强化传热和减少铜料消耗以及节约冷却水用量的目的。
-
The physical character of the super-critical hydrogen in the regenerative cooling channel is studied : started with the physical character of the super-critical hydrogen , using the method of least square , figuring out the state equation which is applicable to the state from liquid to the super-critical in the super-critical pressure , the constrained convection and the heat transfer in the super-critical channel are simulated using the equation , the results of the simulation are identical with the experiment in the same condition .
对再生冷却通道内的超临界氢的物性进行了研究:从超临界氢物性的实验结果入手,用最小二乘法拟合出适用于超临界压力下氢由液态过渡到超临界态的状态方程,并利用该方程对超临界氢管内强迫对流换热进行了数值仿真,仿真结果与相同条件下实验结果相一致。
-
Combustion chamber designs are generally categorized or identified by the hot gas wall cooling method or the configuration of the coolant passages, where the coolant pressure inside may be as high as 7,000 psia.
燃烧室的设计,一般归类或确定由热气体壁面冷却的方法或配置冷却通道,而制冷剂的压力,内可能高达
- 推荐网络例句
-
As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.
每逢看到沃林顿那刚毅的脸,那乌黑、忧郁的眼睛,她便会相信,他一定作过不幸的爱情的受害者。
-
Maybe they'll disappear into a pothole.
也许他们将在壶穴里消失
-
But because of its youthful corporate culture—most people are hustled out of the door in their mid-40s—it had no one to send.
但是因为该公司年轻的企业文化——大多数员工在40来岁的时候都被请出公司——一时间没有好的人选。