冷却的

During the compression, room between the compressor's rotor and cylinder reduces. Oil content in the compressed air will be lower than 2PPM after the compressed oil-air mixture goes through mechanical separation and filtering separation. Purified compressed air will cool down in aftercooler. Condensated water after the cool-down is drained out solenoid valve.

在压缩过程中，压缩机转子的滑片与气缸之间容积不断减少，压缩后的油气混合气3/4机械分离和过滤分离，使压缩空气中含油量低于2PPM.3/4净化后的压缩空气进入后冷却器中进行冷却，冷却后所形成的凝结水3/4由一排水电磁阀而排出。

This article introduced the current freshing measures and its mechanism of chilled meat, in order to provide theories for the research and developments in future.

本文对目前冷却肉的保鲜方法及其研究机理做了较为系统的论述，为今后冷却肉保鲜技术的研究与开发提供了理论依据。

The investigation focused on the parameters affecting cooling effectiveness, including: opening ratio, height of ripple board, diameter of holes and height of cooling passage.

研究隔热屏的四种结构参数开孔率、波纹板高度、孔径和冷却通道高度的改变对隔热屏冷却效果的影响。

Based on cooling condition,considering potential heat of phase transformation,the temperature field of lap joint and non-lap joint of high carbon steel wire on STELMOR cooling line are calculated.

根据高碳钢线材的冷却条件，考虑了相变过程的相变潜热，计算出线材搭接点与非搭接点在斯太尔摩冷却线上的温度分布，计算结果与实测结果吻合较好。

This paper discusses the temperature distribution in the accelerating structure of a 20MeV electron linac designed for medical use.

本文分析了一种20MeV电子直线加速器中的温度场分布，查明了目前所用具体结构与恒温冷却方式的质量水平，并与国外某些加速器所用的单向流动冷却方式在优缺点方面作了对比。

The simulated results showed that in cooling tube the thermophoresis force had removing effect on the diesel engine particles,and it is possible to increase the deposition efficiency of diesel engine particles in cooling tube by rational design and control of the cooling tube structure and working parameters.

研究结果表明，热泳力对柴油机微粒具有一定的脱除作用，通过合理设计和控制冷却通道的结构和运行参数，可以有效地提高柴油机微粒在冷却通道中的沉降率。

The results show that the parameters of steam over water vapor supplied by the heating device is stable,besides,during taking steam over water vapor as coolant and lubricant,the tool wear was reduced about 50 and 40 percent respectively by com.

研制了以过热水蒸汽作为冷却润滑剂的绿色切削技术所需供汽系统中的二次加热装置，并用该装置进行了不同切削速度下改变冷却润滑剂切削45钢时的刀具磨损对比试验。

An expression of combined heat transfer coefficient was obtained based on the heat transfer analysis of a blast furnace copper stave, and the combined heat transfer coefficients at different gas temperatures were obtained through the thermal test in an experimental furnace.

根据铜冷却壁传热过程分析，得到铜冷却壁热面复合传热系数的计算公式，并在1：1的热态实验炉上进行了热态实验，得到不同炉气温度下相应的热面复合传热系数值。

The overpressure transients of the most penalizing category 2 condition and category 3 condition are simulated by the thermal-hydraulic code-CATIA 2, and the reactor coolant system overpressure protection under the stretch-out operation for LING AO NNP is validated.

本文阐述岭澳核电站延伸运行工况下反应堆冷却剂系统超压保护分析的原理和方法，利用热工水力程序CATIA2对最为严重的二类工况和三类工况超压瞬变做了分析和计算，计算表明岭澳核电站延伸运行期间冷却剂系统超压保护是有效的。

Persian by birth, Avicenna invented a coiled pipe which allowed the plant vapor and steam to cool down more effectively than previous distillers that used a straight cooling pipe.

波斯人Avicenna发明的盘管比之前用于蒸馏的冷却直管在蒸馏植物、冷却水蒸汽方面来的更有效。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。