冷却的
- 与 冷却的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The connetion between cooling way,cooling water flux ,cooling water temperature and cooling effect is not clear.
冷却方式及冷却水流量和温度与冷却效果之间的关系一直是模糊的。
-
This paper introduces the food refrigerated theory and the basis of the current industry refrigerated developments in the situation; And then in the long cylindrical-shaped food heat conduction process and the mathematical model using the method of differential thermal conduction equations for discrete, Programming come through long cylindrical-shaped food cooling process numerical solution; After further analysis of numerical solution of the test results; Finally, the impact of the cooling process food all relevant factors, such as moisture content, wind speed and temperature of the cooling medium for in-depth research, while comparing the different shapes of food to food cooling process.
本文首先介绍了有关食品冷冻冷藏的基础理论和目前冷冻冷藏行业的发展的发展概况;然后研究了长圆柱状食品热传导过程的数学模型并利用差分的方法对热传导方程进行离散,通过编程得出长圆柱状食品冷却过程的数值解;之后再分析解对数值解的结果进行验证;最后对影响食品冷却过程的各相关因素,如含水率、风速和冷却介质温度等进行了深入的研究,同时又对比了不同形状的食品对食品冷却过程的影响。
-
By using the silicomolybdic yellow colorimetric method, the paper determines not only the existing form of soluble glass in the newly made-up, being used, and discarded cooling liquid,but also the relation of the stability of cooling liquid to the concentration and standing time of monosilicic acid and total silicic acid. The relation of the concentration of polysil...
本文采用硅钼黄比色法测定新配制、使用中和报废冷却液中的水玻璃存在形态和研究冷却液的稳定性与单正硅酸、总硅酸的浓度和放置时间的相关性;用四氢呋哺萃取比色法测定冷却液中的高聚硅酸含量与放置时间的相关性;研究用超声波、磁场等物理方法处理废冷却液的再生可行性及水玻璃的形态变化。
-
In order to investigate the basic heat transfer characteristics of the platelet regeneratively cooled thrust chamber, the second chapter focussed on the developed flow and heat transfer in the long straight regenerative cooling channels with rectangular sections.
为了解层板再生冷却推力室在传热上的基本特征,第二章重点研究流动和热充分发展的矩形截面长、直再生冷却通道内的传热问题,建立了层板再生冷却推力室二维流固耦合传热过程的数理模型,采用通用形式控制方程描述冷却剂紊流传热和通道材料内导热的共轭传热问题,从而避免了流-固区域之间的反复迭代,大大缩短了计算时间。
-
Zirconia/graphite compound mold core was prepared by the coating, in which the silicon sol was used as binder and zirconia was used as refractory materials. The application feasibility of metal particles as a coolant in the solidification process was studied, and the application of metal particles as subsidiary coolant in the liquid metal cooling of directional solidification were analyzed and studied in this investigation. The conclusions can be drawn as follows: 1 The zireonia/graphite compound cores fabricated by brushing coating which was prepared by making silicon sol agglutinated zirconia as a refractory material were casteded at 800℃and 1000℃respectively, and the results show that the strength of the mold core is strong enough to meet the requirement of practical casting.
本文研究了以硅溶胶为粘结剂,氧化锆为耐火材料来制备氧化锆/石墨复合型芯的制备工艺;并分析了金属颗粒作为冷却剂在金属凝固过程中应用的可行性、金属颗粒的冷却能力以及金属颗粒作为辅助冷却剂在定向凝固的液态金属冷却法中的应用,得出以下结论:(1)以硅溶胶为粘结剂,氧化锆为耐火材料来配制涂料,采用刷涂石墨型芯的方法来制备的氧化锆/石墨复合型芯经800℃和1000℃实际浇铸实验,结果证明型芯的强度足够满足实际浇铸要求。
-
The results show that at sea level, coolant flow rate affects the plug pressure, heat flux and temperature; at design operating condition, coolant flow rate has no effect on pressure and heat flux on the plug wall. With the same coolant flow rate, plug temperature at sea level is higher than that at design operating condition; under the same operating condition, ramp temperature is higher than the plug base temperature.
计算结果表明:地面工况下,冷却剂流量的改变对塞锥和塞锥底部壁面的压强、热流密度和温度的影响较大,高空环境下,冷却剂流量的改变对塞锥和塞锥底部壁面的压强、热流密度的影响较小;在冷却剂流量相同的情况下,塞锥和塞锥底部在地面工况下的壁面温度要远高于在高空环境下的温度;在相同工况和相同冷却剂流量的情况下,塞锥壁面上的温度要远高于塞锥底部壁面上的温度。
-
The process and application of the cooling system of horizontal catenary continuous annealing line for stainless strip are introduced.
介绍了不锈钢带水平悬索式连续退火炉冷却系统的工艺与应用,并对某新建热轧不锈钢退火炉的冷却段进行了分析,包括初冷段、终冷段喷头的布置及影响冷却效果的因素,探讨喷水冷却系统的应用。
-
The cooler cavity is equipped with a double jacket containing 35-40℃ circulating oil by which the hot paste is cooled to a temperature of 70℃ and then discharged into the ACM feed hopper.
冷却机的冷却腔是双层结构,双层结构的夹套内通温度35-40℃的循环使用的冷导热油,热糊料在此冷却。待糊料冷却到70℃后,将冷糊料放置到ACM的进料料斗。
-
Dump cooling , which is similar to regenerative cooling because the coolant flows through small passages over the back side of the combustion chamber wall.
转储冷却,这是类似再生冷却,因为冷却剂流经的小通道,超过背面燃烧室壁。
-
When Carp vehicle fuel economy stick to the running car engine cooling system of water tanks (also called the "expansion of the pot"), after the car in a moving process, the engine heat and heat transfer to the cooling liquid, heating and cooling liquid Carp Festival Oil rods in the "Bioglass" play a role and have a lot of negative ions, with a lot of negative ion engine coolant along the cylinder piston and the cylinder head outer space waterways cycle, formed around the cylinder piston engine of the electromagnetic field.
当卡普汽车节油棒投放到汽车发动机冷却系统副水箱里后,汽车在行驶过程中,发动机发热并将热量传递给冷却液,受热的冷却液与卡普节油棒中的&Bioglass&发生作用并产生大量的负离子,充满大量负离子的冷却液沿着发动机活塞缸体和缸盖外壁的水道空间循环,形成环绕发动机活塞缸的电磁场。,发动机活塞缸中的混合燃料气体在这种电磁场作用下,形成阿萨卡瓦效应,燃烧增强、爆发力增大、燃烧效率提高,从而降低汽车燃料消耗、提高发动机动力、显著减少尾气排放。
- 推荐网络例句
-
I didn't watch TV last night, because it .
昨晚我没有看电视,因为电视机坏了。
-
Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.
今年以来,在北京的很多小区里,电梯液晶电视被撤了下来。
-
I'm running my simile to an extreme.
我比喻得过头了。