冷却的

The measuring unit includes one heat block, one cooling block, and one sleeve. The facing end of the heat block and cooling block has one loaded plane which forms one loaded cavity with the sleeve in which the heat block and cooling block can be relative move.

所述量测部包括一加热块、一冷却块及一套筒，所述加热块及冷却块相面对的一端分别具有一承载平面，所述承载平面与所述套筒构成一承载腔，且所述加热块与冷却块可于所述套筒内相对移动。

This paper measured the cooling curve of quenched and tempered heavy forging in temper cooling, and calculated maximum instantaneous elastic stress in cooling below 400℃.

测量了调质大锻件高温回火冷却时的表面及心部冷却曲线、室温及低温冲击韧性，并且计算了400℃以后冷却时最大瞬时弹性热应力。

According to the invention, said texturing machine is provided with an element which lifts the thread in order to modify the length of contact of the cooling tube.

按照本发明为了改变冷却段的接触长度设有一个导纱杆，通过它使纱线在冷却段内在部分长度上与冷却管圆周无接触地导引。

Regenerative cooling is the most widely used method of cooling a combustion chamber and is accomplished by flowing high-velocity coolant over the back side of the chamber hot gas wall to convectively cool the hot gas liner.

再生冷却是最广泛使用的方法冷却燃烧室和是通过流动的高冷却速度超过回到会议厅一侧的热气体墙convectively冷却热气体班轮。

The dilatometric curves of low-carbon micro-alloyed steel with Mo at different cooling rates were detected on Gleeble-3800 thermo-mechanical simulator.

在Gleeble-3800热模拟试验机上，测定了含Mo 低碳微合金钢在不同冷却速度下连续冷却时的膨胀曲线，利用热膨胀法并结合金相-硬度法，测定了该钢的连续冷却转变曲线；研究了冷却速度对该钢组织及硬度的影响。

By dilatometric change referencing microscopic test and hardness measurement, the critical point at Ac1, Ac3 and Ms of 27CrMo27S steel was determined in Gleeble-3800 thermal mechanical simulator, By measuring the different expanding curves of CCT in different cooling rate, CCT diagram was obtained.

利用膨胀法结合金相-硬度法，在Gleeble-3800热模拟机上测定了27CrMo27S钢的临界点Ac1、Ac3以及Ms；测定了该钢在不同冷却速度下连续冷却时的膨胀曲线，获得了连续冷却转变曲线；研究了冷却速度对该钢组织及硬度的影响。

According to failure analyses of the cooling wall of No.5 blast furnace in No.1Iron Making Plant of Jigang in heavy repair in 2000, the main cause of longitudinal crack of cooling wall with ribs enchased in bricks is the temperature instability of hot side of cooling wall.

根据济钢第一炼铁厂5＃高炉在2000年大修中的破损情况，分析筋条镶砖式冷却壁纵裂原因是冷却壁热面温度不稳定，而全覆盖式冷却壁由于其结构能使冷却壁本体温度变化幅度小，且有很强的抵抗裂纹扩展的能力，因而破损速度较慢。

This paper reports the current studies on the film cooling characteristics of single-row holes on flat plate at different blowing ratios, and analyzes the distributions of adiabatic film cooling effectiveness and heat transfer coefficient downstream the film holes.

对不同吹风比条件下的典型单排孔冷却结构的平板气膜冷却特性进行了实验研究，对冷却孔下游的气膜冷却效率及换热系数分布规律进行了分析。

For a regenerative cooling system, the coolant supply pressure must be sufficient to flow the coolant through the narrow cooling passages at high velocities.

为蓄热式冷却系统，冷却液供应的压力，必须有足够的流动冷却剂通过狭窄的通道，在冷却速度高。

The study shows that regenerative cooling can meet the airframe/engine integrated cooling requirements in the range of flight Mach numbers from 6 to 12, as fuel injection concept (injector locations and injection fuel mass flow) is set properly, and hydrogen temperature at the exit of cooling passage is allowed to be a relative higher value.

研究表明，在马赫数6～12的范围内，通过适当配置燃料喷射方案和提高冷却通道出口冷却剂的温度，采用再生冷却方式能够满足机体／发动机一体化高超声速飞行器的冷却需求。

Finally, according to market conditions and market products this article paper analyzes the trends in the development of camera technology, and designs a color night vision camera.

最后根据市场情况和市面上产品的情况分析了摄像机技术的发展趋势，并设计了一款彩色夜视摄像机。

Only person height weeds and the fierce looks stone idles were there.

只有半人深的荒草和龇牙咧嘴的神像。