冷却

It is found that the function relationship is affected by initial enrichment, cooling time and burnup range. The function relationship is also affected by irradiation history while the cooling time is shorter than 2 a.

发现幂函数关系中的系数受初始富集度、冷却时间、燃耗范围的影响；如果冷却时间大于2 a，这个关系不受辐照历史的影响；如果冷却时间小于2 a，这个关系受辐照历史的影响。

They are generally two different types of cooling system:water-cooling system and air-cooling system.

他们通常是二个不同的类型冷却系统：水-冷却系统和空气-冷却系统。

Besides, it can avoid the direct flow of steam and air mixture to air extraction outlet, in case of the load accretion for air ejector.

设置当汽板，防止主凝结区的蒸汽与空气冷却区的空气混合，影响传热效果；并防止蒸汽不经过主凝结区直接进入空气冷却区而增大该区域的热负荷；还可防止蒸汽-空气混合物不经过空气冷却区，直接流入抽气口，而使抽气器负荷增大

At present, many foreign countries use low-level mold casting, its aim is to improve the cooling intensity, to reduce or eliminate a cooling air gap zone heating phenomenon, it is virtually non-existent secondary cooling of the quenched situation, ordinary flat ingot casting has been the crystallization of height reduced to 100 people, of course, this has required the operator to operate a high level or additional level of white dynamic control system.

目前，许多外国国家使用低级别的模铸造，其目的是提高冷却强度，以减少或消除地区差距的冷却空气加热的现象，几乎是不存在的二次冷却淬火的情况，一般小锭铸造一直减少到100人，当然，高度结晶，这需要经营者经营的高层次或白色的动态控制系统的额外的水平。

It reduces the cooldown of your Cold Snap, Ice Barrier, Deep Freeze and Summon Water Elemental spells by 10/20%.

它减少急速冷却，冰盾，深结和召唤水元素的冷却时间10/20%与急速冷却相连

In order to improve the marine storage battery 's distilled water cooling system, a new automatic control unit based on single-chip computer is developed.

针对船上蓄电池组蒸馏水冷却系统存在的缺点，开发了一种根据蓄电池温度对蓄电池组进行冷却或分层冷却的自动控制装置

Carries out the macroscopic and microscopic analysis for corrosion of heat-exchange tubes used for lithium bromide absorption chiller,investigates the corrosion substance by scanning electron microscopic and X-ray energy dispersive spectroscopy,analyzes the chemistry composition of tubes,cooling water and lithium bromine solution.

对某制冷机组吸收器的冷却水管出现不同程度的腐蚀穿孔进行宏观和微观形貌分析，对腐蚀孔附近腐蚀产物进行扫描电镜-能谱分析，并对冷却水管化学成分、冷却水质和溴化锂溶液进行分析。

The preparative technique of solid lubricant is cold-press sintering method.The micro-structure , friction surface, lubricant transfer film surface of base material was characterized by SEM; XRD was used to do phase analysis. The degrees of crystallinity of pure PTFE under the different conditions of water cooling, air cooling and furnace-varying cooling were made comparison by XRD. The thermal stability of pure PTFE and solid lubricant was analyzed by DSC-TG; The composition and valence state of elements in the surface of carbon fiber ,solid lubricant before and after friction test and lubricant transfer film were characterized by XPS; The frictional property of solid lubricant was tested by pin and disk test rig .

用SEM表征原料微观结构、摩擦表面及润滑转移膜表面形貌：用XRD进行原料物相分析，及比较水冷却、空气冷却、随炉冷却三种工艺条件下的纯聚四氟乙烯树脂的结晶度；用DSC-TG分析纯聚四氟乙烯树脂及固体润滑剂的热稳定性；用XPS表征碳纤维表面、固体润滑剂摩擦前后表面、润滑转移膜表面的元素组成、价态变化；用销盘式摩擦磨损试验机对固体润滑剂进行摩擦性能测试；采用专用的台架模拟试验机对固体润滑剂镶嵌轴承套与钢轴摩擦副间的摩擦磨损性能进行测定；用莱次偏光显微镜测试固体润滑剂的硬度；用材料试验机测试固体润滑剂的抗压强度等。

Making use of evaporative cooling technology for stator coil, static liquid level of system is not higher than stator line bar, also not lower than 2/3 of line bar beeline segment; when both copper ring down-lead and main lead-out line also adopt evaporative cooling method, static liquid level of system shall be prescribed by manufacturer in technical documentations.

6.1.3.4蒸发冷却系统液位要求定子绕组采用蒸发冷却技术时，系统静态液位不高于定子线棒，也不低于线棒直线段的2／3；当铜环引线和主引出线也为蒸发冷却方式时，系统静态液位要求由制造厂在技术文件中规定。

The total static loads and dynamic loads are summed as 4.692W and 38.4W, respectively. And comparison between the double-wall cooling method and the cooling tube method for the 77 heat shield has been discussed to provide the thermal parameters for flow process simulation. The critical thermal parameters of the main components of the QWR cooling system were determined for parallel arranged QWR cryostats. The mass flow and time for cool-down of the QWR to 4.2K was also estimated.

本文在详细描述恒温柜冷却系统的基础上，详细计算了4.2K冷质量与77K冷屏的辐射漏热，同时，还对恒温柜内部支撑系统计算了变物性下的导热漏热，得出了恒温柜系统的静态和动态热负荷分别为4.692W和38.4W，并分析比较了液氮冷屏采用夹层冷却方式与铜管缠绕冷却方式的优缺点，为流程模拟的参数确定提供了依据。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。