冷却

It use two disparting surface,and it's frame is fast.It use point moulding gob,so,it can fall off automatism.When it is pulled out ,the pulling pole pull the product and accomplish the pulling of it's side concave . The design project is divided into two parts.

它采用双分型面分型，结构紧凑；采用点浇口，且浇口可以自行脱落；顶出时，由推杆和斜顶杆顶出制品并完成制品内侧凹的抽芯；模具定模上的水道以多支回路分别冷却，动模一侧的型芯由三组水道分别冷却。

First, the grain will be increase at double speed, second, a large scale "structure" builds by collision and coalescence of favorably oriented particles (namely primary phase coalescence), third, primary phase entraps the eutectic structure.

分别研究了浇注温度、拉坯速度、冷却速度等工艺参数对合金组织的影响，结果显示：在本实验条件下，浇注温度以650荀70'℃为宜；拉坯速度以8.4一9.6 cm/min为宜；二次水冷流量控制在1.0一2.0比为宜。综合考虑磁场强度B和冷却速度对非树枝晶组织初生相平均尺寸D和形状因子S影响的数学表达式为：D=A一ns二；。

--- Method and apparatus for abstracting water from air wherein in a first phase of a recurring cycle a stream of cool, moist air from the atmosphere first cools a first heat storage condenser (1) and then humidifies a hygroscopic medium (14); in a second phase a stream of warm air additionally heated by solar radiation expels moisture from the hygroscopic medium and carries the moisture into said first heat storage condenser (1) where it condenses, releasing condensation heat, and drains away; in a third phase another stream of cool, moist air from the atmosphere first cools a second heat storage condenser (2) and then rehumidifies the hygroscopic medium, and in a fourth phase another stream of warm air heated by solar energy again expels the moisture from the hygroscopic medium and carries the moisture to said second heat storage condenser where it condenses and drains away, and wherein the warm air streams of the second and fourth phases, are preheated using the heat of condensation picked up by the said second heat storage condenser (2) in the fourth phase and the heat of condensation picked up by said first heat storage condenser (1) in the second phase, respectively, before being additionally heated by solar radiation and being used to expel moisture from the hygroscopic medium.

摘要---方法和仪器取水，从空气，其中在第一阶段的周期性循环流冷静，潮湿空气从大气中的第一冷却的第一个蓄热冷凝器（ 1 ），然后humidifies一吸湿中等（ 14 ）；在第二阶段流的暖空气此外，激烈的太阳辐射驱逐水分从吸湿中等，并进行水分成表示，第一蓄热冷凝器（ 1 ）凡它凝结，释放出凝结换热，及雨水渠的距离；在第三阶段另一流的冷静，潮湿空气从大气中冷却，第一第二蓄热冷凝器（ 2 ），然后rehumidifies该吸湿中等，而在第四个阶段的另一流的暖空气加热太阳能再次驱逐水分从中期和吸湿性带有水分说，第二蓄热冷凝器而凝结及排水渠远离，和其中的暖空气流，第二和第四阶段，预热用热凝结回升，由说，第二蓄热冷凝器（ 2 ）在第四个阶段和热凝结回升，由说，第一蓄热冷凝器（ 1 ）在第二个阶段，分别之前，此外激烈的太阳辐射和被用来驱逐水分从吸湿中等。

This research is a new low cost method of producing abrasive grit. It is to put the iron ore concentrate, coal powder, hydrated limed and addition agent together to make coal mixed pellet in prior which is rapidly auto-reduced in high temperature and kept about 10min above 1350℃, and then furnace cooled. The 2CaO·SiO2 of slag phase change、volume increase and natural bloom in reduction process. Finally we obtain no-slag abrasive grit through screen separation , in which the iron yield can be above 90%,the sulfur content can be below 0.05% and carbon content is lower than 4.0%.

本研究是一种全新的低成本生产铁粒的方法，它是将铁精粉、煤粉、消石灰和添加剂预先制成球团，在高温下迅速加热还原，在1350℃以上保温10分钟后随炉冷却，渣相中2CaO·SiO2在冷却过程中发生相变，体积膨胀而自然粉化，通过筛分便可以得到不含炉渣的铁颗粒，铁的收得率在90%以上、S≤0.05%、C在4.0%左右。

Film cooling provides protection from excessive heat by introducing a thin film of coolant or propellant through orifices around the injector periphery or through manifolded orifices in the chamber wall near the injector or chamber throat region.

气膜冷却提供保护，从过多的热量通过引入薄膜的冷却剂或推进剂通过口周围的喷油器周边或通过manifolded开口在会议厅内的墙壁附近的喷油器或分庭喉咙地区。

A simple and opeative method of discharging highly metalized pellets is obtained: first cooling the pellets to about 900℃, then discharging them directly into the open air with the metallization rate of 90%.

4本文研究得到一种较为简单有效的高金属化球团出炉冷却方式：在炉内将高金属化球团冷却至900℃左右后直接在空气中出料，金属化率可保持90％。

To date,the mechanism of beef aging is not absolutely understood.Based on prevenient researches,the purpose of this research is to study the effect of electrical stimulation and delay chilling on tenderness of beef by analysis of carcass temperature、pH and shear force value and tenderizing effect of delay chilling.

本实验是承前人研究的基础上，根据对胴体温度、pH值及牛背最长肌剪切力值的分析综合评价了电刺激和延迟冷却对牛肉嫩度的影响，并通过对肌原纤维超微结构的研究，探讨了延迟冷却处理的嫩化机制与电刺激处理对肌原纤维超微结构的影响及对牛肉嫩度改善的影响程度。

They are generally two different types of cooling system: water-cooling and air-cooling system.Water-cooling syetem is more common.

它们一般是两种不同类型的冷却系统：水冷和风冷system.water冷却syetem更为常见。

Additionally, the air cooling zone should be set up so as to cool the steam and air mixture. Thus, the steam and air mixture supercooling can be enlarged, the working medium loss reduced and the burden of air ejector taken away.

另外，应该设置空气冷却区，使蒸汽-空气混合物得到冷却，以增大排出的蒸汽-空气混合物的过冷度，减少工质损失，并降低抽气器的负荷。

Introduces the significance of application of all-air air conditioning system and analyzes the two problems about energy- saving and purifying of using all outdoor-air in all-air air conditioning system .

介绍了应用全空气空调系统的意义，分析了全空气空调系统中全新风运行方式所带来的节能与净化的两大问题；认为全空气空调系统是较好的空调系统，将蒸发冷却技术、热回收技术、变风量控制技术相结合的蒸发冷却新风空调集成系统具有广阔的应用前景。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。