再搅拌

The sample of granular cellular fiber with size of 5-8 mm is produced by using this technology which can be depicted as follow, adhering the asphalt particutate, which can be depicted as follow: adhering the asphalt particulate, which is made of news paper and asphalt, on the surface of fiber by emulsion method, then mixing them by mechanical stirrer, dewatering and pelleting.

采用这一工艺，以新闻纸和优质路用沥青作为原料，通过胶乳法使沥青颗粒均匀粘附在木质纤维表面，再通过机械搅拌、脱水、造粒等工艺，制备出5～8mm的颗粒状路用木质纤维样品，通过室内高温稳定性试验，比较掺入进口颗粒状路用木质纤维和掺入自制颗粒状路用木质纤维的沥青混合料的抗高温永久变形能力。

Stir in the tomato paste and season with pepper, salt and a little cayenne pepper.

搅拌加入西红柿酱，再用胡椒、盐、和小红辣椒调味。

Dedicated to the new blowing agent mixer, cement (or cement, fly ash mixture, etc.), water, etc. into a uniform liquid mixing concrete foam, and then poured template gathered roof to reach the appropriate thickness.

用专用搅拌机把新型发泡剂、水泥(或水泥、粉煤灰等混和物)、水等搅拌成均匀的流质泡沫混凝土，再用模板浇聚到屋面，达到相应的厚度。

Add water, light soy sauce and cornflour. Hand mix till well combined.

再加入清水、生抽、生粉，用手搅拌至完全混合。

Cyclophos phamide long-term storage of precipitation, after mixing and should be easily after re-dispersible; II in order to have a good flow properties and viscosity; three parts, a good storage stability about drying performance will be faster and appropriate; by not printing plate and business card printing and membership card making machine have any adverse effect; personality default cannot have too much hen'egg cretonne.

长期存放沉淀后，经搅拌后应很容易再分散；②要有良好的流动性能和粘度；③有良好的贮存稳定性；④干燥性能要快而恰当；⑤不能对印版及制卡和会员卡制作机有任何不良影响；⑥不能有太大的刺激性气味。

Then the fiber was transferred to a 4 mL vial which was filled with 100 μL of trifluoroacetic anhydride and stood 30 sec for headspace extraction. Afterward the fiber was transferred again to another blank 4 mL vial and stood 10 min for on-fiber derivatization before the analysis with GC/MS. The absorption-time profiles for both furoic acid and creatinine were examined.

有关尿中肌酸酐的量测，首先亦使用65μm PDMS/DVB纤维，在电磁搅拌转速1200rpm下以直接样本接触方式吸附60秒后，将已吸附肌酸酐的纤维挪至装有100μL无水三氟醋酸的4mL样本瓶中顶空吸附30 sec，再将纤维挪至另一个空白的样本瓶并静置10min（以利衍生物trifluoroacetamide的生成），最后再以气相层析质谱仪进行分析。

In early days, there were two kinds of Old-fashioned Clear Ice. One is to sprinkle the syrup onto the shaved ice; the other kind is to shave the frozen ice brick, which is a mixture of boiling water, white sugar and banana oil, into snow-like tiny pieces.

老式清冰有两种，一种是将冰砖刨成雪花状后再淋上糖水；另一种则是将开水煮沸后加入白砂糖及香蕉油，搅拌后冷冻成冰砖状，再刨成雪花状的冰品，尝起来有股清新的果香与微甜口感。

First of all, Rose petals will be cleaned and then Shaguo inside into about 500 milliliters of water, in order to make broth Gengnong, better, we first half of the Rose petals filled Shaguo, mixing the slightly, Yong Xiaohuo Slowly Aozhu;About ten minutes time, open the lid, you will find that this time the broth a deep color change, and rose petals into the color of pale yellow, and this time we will be able to pan the petals fishing Out; and then the remaining half of the rose petals Add to that Shaguo continue Aozhu; pot after opening, according to personal tastes by adding appropriate Bingtang, covered with lid, or Yong Xiaohuo cook, the only need about five minutes Will be all the time, the pan to remove the petals, you can fire the Commissioner; Sheng-Xiaowan the broth, adding sugar osmanthus stirring uniform, it is as sweet side of roses on the well-exposed.

首先，将玫瑰花瓣洗净，然后在沙锅里边倒入500毫升左右的清水，为了让汤汁更浓、效果更好，我们先把一半的玫瑰花瓣倒进沙锅，稍微搅拌一下，用小火慢慢熬煮；十分钟左右的时间，打开锅盖，这时候您会发现汤汁的颜色变深了，而玫瑰花瓣的颜色变成浅黄色了，这时候我们就可以把将锅里的花瓣捞出来了；然后再把剩余的那一半玫瑰花瓣放入沙锅中继续熬煮；锅开以后，根据个人口味加入适量冰糖，盖上锅盖，还是用小火煮，这次只需要5分钟左右的时间就可以了，把锅里的花瓣捞出去，就可以关火了；把汤汁盛入小碗，加入糖桂花搅拌均匀，这道甘甜香醇的玫瑰清露就做好了。

The method comprises: adding 4-(3,4-dichlorophenyl)-1-tetralone and solvent at a ratio of 1:(3-4) into a three-necked flask with a stirrer, heating under stirring until 4-(3,4-dichlorophenyl)-1-tetralone is completely dissolved, heating to 60-100 deg.C, refluxing for 0.5-2 h, cooling the filtrate to -5-10 deg.C, filtering, recrystallizing to obtain refined 4-(3,4-dichlorophenyl)-1-tetralone, and drying at 40-80 deg.C to obtain dry 4-(3,4-dichlorophenyl)-1-tetralone.

该方法的步骤是：在带搅拌的三颈瓶中依次加入4-(3，4-二氯苯基)-1-萘满酮和溶剂，溶剂与4-(3，4-二氯苯基)-1-萘满酮的L∶W为3～4∶1，将上述4-(3，4-二氯苯基)-1-萘满酮及混合精制溶剂搅拌下升温，使4-(3，4-二氯苯基)-1-萘满酮全部溶解，升温至60～100℃，回流0.5-2h；滤液用冰水冷却至-5～10℃，过滤，所得物料再用上述方法进行一次重结晶得到精品4-(3，4-二氯苯基)-1-萘满酮，40～80℃干燥后即得到干品4-(3，4-二氯苯基)-1-萘满酮。

The results show that the plasticity zone and dynamically quiescent layer become fine equiaxed recrystallisation under the thermo-mechanical effect, the grains in the heat-affected zone grow up because of the effect of friction heat. When the rotation speed is 2 500 r/min and the welding time is 12 s, good joint is achieved, and the tensile shear strength of the joint reaches 9.24 kN. The tensile shear strength of spot increases with increasing tool rotation speed, with increasing welding time, the strength increases first, while then reduces. The microhardness of plasticity zone is high, but is slightly lower than that of the base metal, the minimum value of microhardness is in the heat affected zone. When the energy input of joint is high, the fracture type of spot is mode Ⅰ, and the tensile shear strength is high; on the contrary, when the energy input of joint is less the fracture type of spot is mode Ⅱ, and the strength is low.

结果表明：塑性区和动态静止层的晶粒在热和力作用下发生动态再结晶形成细小的等轴晶，热影响区的晶粒在摩擦热作用下长大变粗；搅拌头旋转速度为2 500 r/min，焊接时间为12 s时，可以获得力学性能较好的焊点，焊点的剪切强度达到9.24 kN；焊点的剪切强度随搅拌头旋转速度的增大而增大，随焊接时间的延长先增大后减小；塑性区的显微硬度较高，但略小于母材，接头显微硬度的最小值分布在热影响区；焊点热输入量较多时，接头为Ⅰ型断裂，焊点的剪切强度较高；焊点热输入量较少时，接头为Ⅱ型断裂，焊点的强度较低。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。