再建立

This thesis discusses the following. First, we use the condition of inference and the concept of wildhabor cone to design the addendum circle. Second, we use TCA technique to obtain the relationship between the slip track and the angle of action, which then leads to the calculation of contact ratios. We can then design the tooth face width and the numbers of teeth based on contact ratios.

本文一开始先对空间渐开线齿轮之齿冠圆范围使用齿轮干涉条件与Phillips提出的Wildhabor Cone进行设定，再利用Litvin提出的齿面接触分析方法，得到空间渐开线齿轮对在啮合过程中作用角与滑动轨迹之间的关系，藉由此关系可以建立一套设计流程来调整齿面宽以及齿数等参数，使其能符合设计需求。

Given a planar point set,the moving least squaremethod is adopted to denoise and resample it so that the resulting point set is with low noise and uniform sampling density.Then the reliable signed distance field of the preprocessed point set is constructed by using the Level Set method.Finally,an algebraic B-spline function is adopted to fit the signed distance field by solving a linear equation system.

首先给定一个表示封闭曲线、可能带有噪音且分布不均匀的平面点云，采用移动最小平方(moving least square，简称MLS)方法对点云去噪、重采样，得到一个低噪音、分布均匀的"线状"点云，再通过Level Set方法建立该"线状"点云的离散几何距离场，最后用一个代数B-样条函数光顺拟合该离散距离场，代数函数的零点集即为重建曲线。

METHODS: Models of ALIF, PLIF and TLIF were simulated. After examination as normal group, the samples were randomly divided into three groups (n=5). Besides anterior, posterior and transforaminal lumbar interbody fusion include anterior, bilateral pedicle screw fixation was performed.

模拟临床手术建立前路椎间融合术、后路椎间融合术、椎间孔入路椎间融合术3种椎间融合术模型，先将所有标本作为正常对照组进行测试，然后将标本随机分为3组，每组5个标本，制成单纯椎间融合组，分别采用3种椎间融合术测试后，在此基础上再附加双侧椎弓根螺钉内固定进行测试。

From the solution to local problems of motion vision and static vision to the design of relatively complete computer vision systems and then to the establishment of general-purpose vision systems comparing with human intelligence is a long course full of allurement and challenge.

从局部的运动视觉和静态视觉问题的求解，到较为完整的计算机视觉系统的构造，再到通用性的可以类比于人类智能的视觉系统的建立，这是一个充满诱惑且极富挑战的漫长历程。

The previous research, in which macro-kinetics of ammoniation of phosphoric acid was measured in a double magnetic stirring reactor,found that the reaction between wet phosphoric acid and gaseous ammonia was a rapid reaction controlled by the gas-film mass transfer.

本文采用数学模型法，根据氨化反应过程的机理，通过小试建立数学模型并经合理简化，再通过中试对模型进行修正和完善，最后用工业大装置加以验证，使所得的模型可用于工业放大。

In chapter four,at first,we investigate classification theory of the positive homogeneous p-Laplacian equation ,the main method is Prufer's transformation,and then we discuss the nontrivial solution for associated nonhomogeneous equation by making use of Leray-Schauder degree.

接着研究了非齐次方程的可解性。在第四章中，我们首先是建立了正齐次p-Laplacian 方程的分类理论，主要利用Prufer 变换。再应用Leray-Schauder 度理论证明非齐次方程的可解性。

In the time series analysis, Granger causality is adapted to vector autoregression models to analyze the causal relationships among variables.

本文利用时间数列资料的特性，建立向量自我回归模型，再运用 Granger因果关系的概念，探讨台湾妇女劳动参与、婚姻、生育行为和劳动市场状况等相关变数的因果关系。

The contents from the third chapter to the fifth chapter are the kernels which are a series of applications of generalized regression model and generalized regression estimator. At first, this paper constructs ratio model, linear regression model, post-stratified regression model and nonparametric regression model through different regressive relationship between auxiliary variable and study variable.

首先是依据辅助变量与研究变量之间回归关系的不同，分别建立比率模型、线性回归模型、事后分层回归模型和非参数回归模型，然后再利用第二章中推导出的广义回归估计理论，对各种回归模型辅助下(来源：A4bBC12论文网www.abclunwen.com)的估计方法进行了系统性研究，从而构成了模型辅助估计方法的整个研究体系。

It uses the balanced scorecard to set key performance indicator. Each hospital builds data warehouse and data cube for their own KPI.

再依不同的指标建立样本医院的资料仓储及资料方体做为处理个别医院之主管资讯系统的实体资料。

In modeling the controlled plant, the mathematical model is at best the approximation to the actual system.

在建立受控系统数学模型，再怎麼精确的鉴别一个系统，我们所得到的也仅是一个"近似"於实际系统的数学模型。

I didn't watch TV last night, because it .

昨晚我没有看电视，因为电视机坏了。

Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.

今年以来，在北京的很多小区里，电梯液晶电视被撤了下来。