再处理

Through practical application, this system can deal with the cutter tool path file of counters, groves, holes, curves and surfaces directly, not need to do second-managing.

通过实践验证，本系统能够直接处理轮廓、内槽、孔系、曲线及曲面的刀具路径文件，不需人工再做2次处理。

Through practical application, this system can deal with the cutter tool path file of counters, groves, holes, curves and surfaces directly, not need to do second-managing.

通过实践验证，本系统能够直接处理轮廓、内槽、孔系、曲线及曲面的刀具路径文件，不需人工再做二次处理。

For ground I used wall filler again, sprinkled with fine sand (picture 9) and then made boots imprints for better fit of figures to the base.

对于地面的处理，我再次使用了填缝剂，然后再撒上些细砂（见图9），再留下人物的脚印，以便于放置兵人。

Besides, we tattooed on skin of pig and removed by Q-switched lasers. According to these results, we suggest white, yellow, and flesh-colored inks must be approached carefully.

另外我们将化妆性刺青刺在猪皮，再分别用Q开关雷射处理，根据这些结果，我们建议白色、黄色、以及肤色，在用Q开关高能量短脉冲雷射处理时需特别小心。

Loofa obtained from traditional market was cut into approximate 1 cm in length and then treated with 1 N sodium hydroxide at 85 oC for 4 hours. The pulp like suspension was bleached by 25 % sodium hypochloride until the fiber turned colorless and the pulp was washed by distilled water to remove excess hypochlorite. The white pulp was again filtered and lyophilized to make into a paper-like membrane.

将购自传统市场之菜瓜布，裁剪出大约1公分长之纤维，再於浓度1 N的氢氧化钠之溶液加热至85 ℃处理4小时，以25 %之漂白水将此纸浆状之悬浮液漂白，使其纤维褪色后再以蒸馏水清洗以去除次氯酸盐，最后将此白色悬浮液过滤及冷冻乾燥，制成纸状的薄膜。

The results are as follows:(1) While the basal expression of Fos is relatively low in brainstem, RAO is capable of inducing a robust Fos-like immunoreactive neurons in the nucleus tractus solitarius, area postrema, nucleus paragigantocellularis lateralis and locus coeruleus.

肾脏缺血预处理减少缺血-再灌注引发的心肌细胞凋亡，并可能通过减少缺血-再灌注心肌组织中Fas和Bax蛋白的表达而起作用。

The new substrate surface pretreatment that included the action of an oxidizing oxygen/acetylene flame with borax solution addition was studied on the base of methods of the WC-Co cemented carbide surface pretreatment.

在分析已有的硬质合金基底表面预处理的基础上，首次提出了用硼砂溶液和燃焰外焰的热量及其氧化性对基底表面进行预处理，抑制钴的副作用并降低基底表面温度，然后再利用内焰沉积金刚石的新方法。

It 's mainly used in steel tubes of high 's mainly used in steel tubes of high temperature superheaters with surface temperature temperature superheaters with surface temperature ≤625℃ and high ≤625℃ and high temperature reheaters with surface temperature temperature reheaters with surface temperature ≤650℃, and high ≤650℃, and high temperature headers and steam pipes with surface temperature temperature headers and steam pipes with surface temperature ≤600℃.

主要主要用于壁温≤625℃的高温过热器、壁温≤650℃的高温再热器钢管，以及壁温≤600℃的高温集箱温≤625℃的高温过热器、壁温≤650℃的高温再热器钢管，以及壁温≤600℃的高温集箱和蒸汽管道，国内外已逐步用该钢代替和蒸汽管道，国内外已逐步用该钢代替T22、F12、TP304L、TP347H等，但该钢焊接性能T22、F12、TP304L、TP347H等，但该钢焊接性能也比较差，容易产生焊接冷裂纹，所以同样要求有合适的预热温度和及时进行焊后回火处也比较差，容易产生焊接冷裂纹，所以同样要求有合适的预热温度和及时进行焊后回火处理。

In comparison with the sample directly sintered at 650 ℃＜TN, an interesting, irreversible transformation in the crystal structure of the MgB2 phase is observed with the sample going through the stages of initial sintering at 750 ℃, then re-sintering at 650 ℃ in an Mg-rich environment after the processes of regrinding and pressing.

把直接在650 ℃＜T N，烧结的样品与先在750 ℃下烧结，之后又再次重磨和处理后，并于富镁的环境中在650 ℃下再烧结处理的样品相比较，观察到了MgB2的不可逆的晶体结构转变。

BackgroundIschemic preconditioning refers to the increased tissue resistance to ischemia reperfusion injury that can be induced by the pre-exposure to one or more brief periods of hypoxia followed by reoxygenation.

背景： 缺血预处理是短期缺血应激使机体组织对随后更长时间缺血再灌注损伤产生明显保护作用的一种适应性机制，缺血预处理的保护作用具有呈初始阶段、延迟阶段双峰表现的特点。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新