再做

Finally, a two-mask process was attempted to extend the same concept of the chip process. Here the mask of the contact aperture was replaced by the mask of the LED pad. After etching the SiO2 and ITO in the aperture region, a lateral etch of SiO2 was made to increase the ITO contact area. Although the forward voltage of the GaN LED shows a normal value, the process yield is still low and requires further study.

二道光罩制程延伸了三道光制程的理念，只是因为透明导电层的圆孔图形，是用电极的光罩去开的，所以蚀刻完二氧化矽膜及氧化铟锡膜后，必须再做二氧化矽膜的回蚀刻，让二氧化矽再内缩进去，以增加氧化铟锡和电极的接触面积，不会造成发光二极体的顺向电压提高，但因制程良率太低，所以还须要继续研究改善。

Then create yet another layer and make a new set of concentric circles.

再创建一个新图层，再做一个同心圆。

In every period, do the following operations:# For each 8*8 block, do the discrete cosine transform, then take out direct current coefficient in each block, using the transformation above for each DC coefficient, the gold stands for the code of the spread-spectrum we use when embedding the different watermark bit in different frames, after all of the watermark information which we want to embed is embedded, then do the inverse discrete cosine transformation, and store the current frame in a new file.

于是利用DCT变换域的这点重要的几何不变性，我们可以推导出一种能够抵抗几何攻击的视频水印算法，即将所需要嵌入的水印信息以127位扩频序列作为辅助，以求和值形式嵌入到DCT变换后的每个宏块的每个DC系数当中，具体嵌入和提取算法如下：根据使用的扩频序列的长度N，基于相关的嵌入器需要选取包含N帧的视频子序列，令这N帧视频子序列作为一个嵌入周期，对于每N帧视频子序列做如下的操作，#即对于每个8×8的像素块进行DCT变换，然后取出每个DCT变换后的直流分量，对于每个DC系数，做如上所述的变换，其中gold为在第k帧中嵌入第i位水印信息时使用的扩频码字值，待将所有需要嵌入的水印信息全部嵌入后，再做反DCT变换，保存当前帧。

My colleague told me that before design I must know what is the client need. I modified again. But the client still not satisfied.I think it was cause of my lower work experience.I understood design is a serious matter after I observed my colleague. Design should consideration a lot. Design should not be precipitance.

同事告诉我需要先了解客户的需求才能自己再做设计，后来我修改了很多次都没能通过，原因是我的工作经验不足，无法做出迎合客户需求的设计，后来我观察同事们做设计的过程我才明白做设计不能太随便，需要很严谨，需要考虑很多，不能太鲁莽。

We have done things we ought not to have done and B.left undone things we ought to have done.

我们做过的事情不要再做了，我们应该做一遗留下来的没作的事情。

Firstly,all patients have been excided the upper ductus choledochus,the liver gross duct,left right liver duct besides one centimeter of liver duct that lies upwards the hepatolith.Secondly, we have sutured the excided bile duct, which has been shaped acetabuliform,lifted one part of jejunums,intered non-port one subcuneously,and then inosculated gall with enteron by Roux-en-Y way.Lastly,we have partly excised the ill liver in regular way.Results 26 ones have been follow-up for 1～10 years.The rate is 81 percents,average for 6 years.

32例肝内胆管结石均接受皮下盲袢型胆肠吻合术，其中结石位于右肝7例（22%），左肝9例（28%），两肝均有16例（50%）；结石合并肝胆管狭窄24例（75%），全部病例均切开胆总管上部、肝总管、左右肝管，并切开肝内胆管狭窄部以上1cm肝管，将切开的胆管做必要的缝合，形成碟状，取一段空肠上提，盲袢埋置皮下，再做胆肠Roux-en-Y吻合，病肝做规则性肝部分切除术。

Use palmar palm root or rachis is carried on the back after boxing face is put in the patient on two side muscle (make from left muscle first, on the right side of redo muscle), do light, downy circumnutation, it is certain to notice the hand wants to press muscle to bring to bear on pressure, do not want to chafe on the skin.

用手掌掌根或拳面放在患者后背脊柱两侧肌肉上（先从左侧肌肉做起，再做右侧肌肉），做轻快的、柔和的回旋运动，注意手要按住肌肉施加一定压力，不要在皮肤上摩擦。

Cheney retaliated by saying he doesn't regret any of the decisions he made, and if he had to do it all over again, he would order President Bush to do exactly the same thing.

切尼回敬说他从不为自己做过的决定后悔，如果他不得不重新再做一次，他会命令布什总统做一模一样的事情。

The BB I have three days off 32 weeks, and I December 7, 2002 Nissan seized at the same time do make a B-, the doctor said everything will be all right, but some large fetus .2003 In January 10 I again seized the middle, I asked again B-, doctors say the size of a normal fetus, but fetal position is not correct, BB is still above the head is transverse fetus has not corrected, must be quasi - Preparation of caesarean section.

我的BB有32周过3天了，我2002年12月7号去做产检同时也做了B超，医生说一切正常，只是胎儿有些大。2003年1月10号我再次去产检，我自己要求再做一次B超，医生却说胎儿大小正常，不过胎位不正，BB的头还在正上面，是横胎，已经无法纠正，必须准备剖腹产。

Start by doing what's necessary; then do what's possible; and suddenly you are doing the impossible.-Francis of Assisi

方济会的弗朗西斯说：&先做必需做的，再做能做的，有一天你会突然觉得事竟成&。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐