内质的

Results AQP1 is expressed at the apical and basolateral membrane of the microvascular endothelium; AQP3 was detected at basal cells of both the bronchiole epithelium and submucosal gland acinus; AQP4 is present in the basolateral membrane of columnar cells in bronchiole; while AQP5 is expressed in the apical membrane of type Ⅰ pneumocytes, and also at the apical of columnar cells of superficial epithelium and submucosal gland acinar cells.

结果本研究发现AQPs基因在羊肺中的表达分布与人相似，AQP1在肺内的毛细血管内皮细胞表达；AQP3在小支气管黏膜上皮的基底细胞的基侧膜表达，AQP4存在于小支气管黏膜上皮的柱状纤毛细胞的基侧膜；AQP5存在于Ⅰ型肺泡上皮细胞的顶质膜，存在于小支气管黏膜上皮柱状纤毛细胞，以及在气道黏膜下腺的腺细胞的顶质膜表达。

The result indicates the t-BHP or diamide both cause the mass loss about the membrane protein thiol in hepatocytes, the fast oxidization about glutathione in hepatocytes, the leakage of lactate dehydrodenase, but the level of t-BHP is larger than of diamide. In the aspect of lipid peroxidation, only the t-BHP produces apparent change. As to actin and tubulin, they both find fall-off and present time-dependency effects. The result in Confocal fluorescent microscope also show these two cytoskeletal proteins are related to cell blebbing, but they don''t play the same role during the porcess. Tubulin may be more important than actin. If the study predispose dithiothreitol before adding t-BHP or diamide, then the damage by the diamide is repressed, but just partly protection for the damage by t-BHP.

结果显示t-BHP或diamide均可造成细胞膜蛋白硫醇大量流失与胞内GSH快速氧化，亦显著导致乳酸去氢□渗漏，但t-BHP诱发的渗漏程度大於diamide；在脂质过氧化方面，则仅t-BHP处理组产生明显的脂质氧化情形；至於肌动蛋白与管蛋白单体均可见减少且呈现时间依赖效应；在雷射共轭焦萤光显微镜观察中，亦显现这两种架构蛋白与细胞膜起泡有关，但两者在小泡生成的过程中扮演的角色并不完成相同，可能管蛋白较肌动蛋白重要；如果细胞在t-BHP或diamide加入前预先以dithiothreitol处理，则diamide 所造成的伤害显著的受到抑制，但DTT对t-BHP所诱发的伤害则仅有部分保护效果。

We describe the specific silencing of reporter gene lacZ in FHM cells (muscle cells of fathead minnow, a fish cell line) by either expressing small hairpin RNAs from plasmids or transfecting small interfering RNAs transcribed in itro.

在FHM细胞内通过转染质粒表达小发夹RNA或者直接转染小干扰RNA能特异沉默报告基因LacZ的表达，且siRNAs 抑制效果更加明显；这两种类型的小双链RNA在Hela细胞内同样能抑制报告基因的表达。

The results show that the optimal amount of foamer is 0.5 wt％and thisporous material has excellent porous structure, that is, interconnected and uniformlydistributed pores with the diameter of pores ranging from about 100μm to 700μm.

结果发现：发泡剂的最佳比例为0.5 wt％，多孔n-HA／PA6材料具有与松质骨相似的多孔结构，孔径为100～700μm，孔的贯通性好，孔隙率可通过调节工艺参数进行控制，最高可达到88.6％；总孔隙率相近的情况下，n-HA含量高的多孔材料的压缩强度较高；孔隙率在58～88％范围内，多孔材料的抗压强度在1.1～15.6MPa，与人松质骨的抗压强度相当。

Purposes: To observe intakes of 〓p-sodium-orthophosphate and 〓P-chromium- orthophosphate at various concentrations by brain gliomas cell; To make thorough inquiry of the inhibition to the SHG44 cell by 〓P-sodium-orthophosphate and 〓P-chromium-orthophosphate at various concentrations; To find out the regularities about the accumulation and elimination in the major organs of rats after inter-brain injection with 〓P-sodium-orthophosphate and 〓P-chromic-orthophosphate; To investigate the therapeutic effects of intert-injection with 〓p-chromium-orthophosphate on the neoplasia transplanted in the brain and hypoderma; To estimate the absorbed dose of the neoplasia body in rats after internal radiation; To study the pathological changes in the rat cells and tissues caused by the radiation exposure from 〓p.

目的：观察人脑胶质瘤SHG44细胞对不同浓度的〓P-磷酸钠和〓P-磷酸铬的摄取；探讨不同浓度〓p-磷酸钠和〓p-磷酸铬对SHG44细胞生长的抑制；揭示〓p-磷酸钠和〓p-磷酸铬在大鼠颅内注射在时全身主要脏器的蓄积与排除规律；观察〓p-磷酸铬大鼠颅内瘤体、皮下瘤体内注射的治疗效果；估算大鼠瘤体组织的吸收剂量；观察〓p照射引起的细胞及组织的病理学改变，为临床脑胶质瘤内照射治疗提供实验依据和吸收剂量计算方法。

Analysis indicates that the mechanism of intermittent gas injection production mode to increase output is mainly binging domino of competition adsorption,while that of injection and production mode is mainly displacement .

描述了注气开采煤层气生产过程，分析表明间歇注气生产模式的增产机理主要是竞争吸附置换，而边注边采生产模式主要是驱替；反映基质孔隙扩散能力的综合传质系数不仅影响煤层气井的生产能力，而且影响矿井煤与瓦斯的突出；建立了单井间隙式注气开采煤层气的扩散渗流数学微分方程组；注气过程和采气过程渗流方程式形式相同，但质量源的流向不同，生产井内的边界条件不同。

Research on influence factors of capillary force in immiscible displacement ;2. Analysis indicates that the mechanism of intermittent gas injection production mode to increase output is mainly binging domino of competition adsorption,while that of injection and production mode is mainly displacement .

描述了注气开采煤层气生产过程，分析表明间歇注气生产模式的增产机理主要是竞争吸附置换，而边注边采生产模式主要是驱替；反映基质孔隙扩散能力的综合传质系数不仅影响煤层气井的生产能力，而且影响矿井煤与瓦斯的突出；建立了单井间隙式注气开采煤层气的扩散渗流数学微分方程组；注气过程和采气过程渗流方程式形式相同，但质量源的流向不同，生产井内的边界条件不同。

The heat generation curves of seven rubber materials used in tires with the changes of temperature have been obtained by using Dynamic Mechanics Analysis technique on NETZSCH DMA242 instrument, knowing that the heat generation of every other rubber materials except inner liner rubber changes lightly alone with the temperature within 10℃～80℃. According to the Fourier law, the heat transfer coefficients of tire rubber are measured by stable method on self-made experiment instrument. The coefficients changes lineally within 20℃～80℃ and the relation formulas λ=λ〓+bt are given out attached with λ〓 and b. The specific heat of tire rubber are measured on Differential Scanning Calorimeter NETZSCH DSC204 and the relations with temperature are linear and the formula is c=c〓+bT, where c〓 and b gained from experiment result data are presented in the paper. The heat convection coefficients on the surface of rolling tire are measured according to the principle of heat-mass transfer analogy principle after simplifying rolling tire into rotating disk with straight movement on wind channel. The relation with rotation speed of disk is linear as h=5. 399+0.0258n and the relation with straight line speed of tire is linear too, h=

论文采用动态力学分析技术，使用NETZSCH DMA 242型实验仪，获得了轮胎用七种胶料的生热率随温度变化曲线，确知除内衬层胶以外，其它各种胶料在一般胎温范围内（10℃～80℃）的生热率随温度变化不大；轮胎胶料的导热系数根据傅立叶定律的基本原理，采用稳态法在自行搭建的实验台上进行测试，结果表明，材料的导热系数在20℃～80℃的温度范围内随温度呈线性变化，论文给出了各种材料导热系数的线性变化的关系式λ=λ〓+bt及其λ〓和b的值；轮胎胶料的比热运用差式扫描量热原理，在NETZSCH DSC204型DSC实验仪上进行测试，结果表明，胶料的比热随温度的变化呈线性变化，其关系可用c=c〓+bT表示，文中给出了根据实验数据拟合的c〓、b的值；对轮胎表面的对流换热系数的测定，本文先将滚动的轮胎简化为有直线运动的旋转圆盘，而后采用萘升华热质比拟技术，在风洞中测量了滚动轮胎表面的对流换热系数，结果表明，圆盘表面对流换热系数与转速呈线性关系，即h=5.399+0.0258n，轮胎表面对流换热系数与其直线运动的速度呈线性关系，即h=

RESULTS: There were many vacuoles and cracks in the cells, with heterochromatin margination, nuclear pycnosis and nuclear fragmentation. The high intensity pulsed electric fields caused damage in K562 cells, and the apoptotic percentage went up with the increase in frequency and intensity of PEF.

结果：经过高电压脉冲电场处理后的K562细胞，胞内出现大量空泡及裂隙，核内染色质向核周边聚集形成凋亡小体，呈典型细胞凋亡形态学改变；K562癌细胞的凋亡比例随着脉冲个数和电场强度的增加而增加。

Further study showed that ryanodine mediated CICR contributed greatly to the secondary NO elevation induced by BK treatment.

同时，缓激肽刺激后，在C6胶质瘤细胞内存在NO的持续升高，且NO是继发于细胞内尼诺丁受体介导的CICR之后。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。