内流

Lubricant dynamic characteristics in lubricant region of the four-leaves bearing were researched by using boundary element method,the distribution of flow field in lubricant and the pressure on the surface of bearing neck and bearing was obtained.

用边界元方法对复杂轴承中四叶轴承的流体动力学特性进行了分析，得到了轴承润滑区的流场分布、轴颈表面和轴承内表面上的压力分布。

Hydraulic pressure part consists of cylinder body around having some axial direction cylinders, pole piston, matching stream canister and timing equipment. Pyramidal difference decelerate part is composed of twin inner bevel wheel with difference of 2-toothes, twin outer bevel wheel without tooth difference and skew shaft etc.

液压驱动部分由周围均布有若干轴向缸的缸体、柱塞、配流筒及调速装置等组成，减速部分由二齿差内锥齿轮副和零齿差外锥齿轮周向限制副及歪轴等组成。

Methods: The ratios of Th1/Th2 cells in the mouse with immunological liver injure were detected by flow cytometry with two color intracellular cytokine staining; the changes in substance P, vasoactive intestinal peptide in the pituitary gland and peripheral blood were detemined by radio-immunoassary.

应用尾静脉注射卡介苗和脂多糖建立免疫性肝损伤小鼠模型，分离小鼠淋巴细胞，经佛波醇乙酯、离子霉素、莫能菌素刺激培养6h后，收获细胞，利用细胞内细胞因子染色流式细胞术检测Th1/Th2比例：采用放免法检测血浆和脑垂体中SP、VIP含量。

A mathematical model to describe the interfacial behavior between fluid steel and molten slag layer in a slab continuous casting mold with blowing argon gas was developed, and the prediction was validated by the water model.

利用VOF方法和Lagrange两相流模型描述了吹氩结晶器内钢/渣界面行为，并用水模型实验检验了数值模拟结果。

The formed conditions of a single and double recirculation flow pattern in a slab continuous casting mold with argon blowing were quantitive described using the Lagrange multi-phase flow model,and the prediction was validated by the water model.

使用Lagrange流体模型和水模实验对吹氩板坯连铸结晶器内单双循环流的形成条件进行了定量研究。

In the present study, the condition for the formation of the DRFP in a slab continuous casting mold with blowing argon gas was quantitively described using the Lagrange multi-phase flow model, and the prediction was validated by the water model.

利用Lagrange两相流模型定量研究了吹氩板坯结晶器内双循环流形成条件，并用水模型检验了数值模拟结果。

The interfacial behavior between fluid steel and molten slag layer in a slab continuous casting mold with blowing argon gas was described using the VOF method and Lagrange multi-phase flow model,and the prediction was validated by the water model.

利用VOF方法和Lagrange两相流模型描述了吹氩结晶器内钢/渣界面行为，并用水模型实验检验了数值模拟结果。

The formed conditions of a double-recirculation flow pattern in a slab con- tinuous casting mold with blowing argon gas were quantitive described using the Lagrange multi-phase flow model,and the prediction was validated by the water model.

利用Lagrange两相流模型定量研究了吹氩板坯结晶器内双循环流形成条件，并用水模型检验了数值模拟结果。

At the same time, in the exhaust under the fine powder container bag by trapping filter back to the outdoors, the process of trapping a large number of ultra-fine powder will have the selection, whether it is boiling in the flow or trapping operations , boiling the whole process of drying with ultra-fine powder movement.

同时，在排风作用下，容器内细微粉体经捕集袋过滤后排向室外，其捕集的过程就有大量的超细粉的产生，不管是在流态沸腾还是在捕集运行中，沸腾干燥的整个过程均伴有超细的粉体运动。

An experimental investigationon transient of wall temperature in start up process of pool boiling heat transfer innarrow annuli under atmospheric pressure was carried out.

对常压下竖直环隙流道内沸腾换热启动阶段壁温的瞬态变化特性和流动不稳定性进行了实验研究。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。