内流

Suitable for numerical simulation of subsonic、transonic and supersonic flow field of nozzle.

3适应于喷管内亚、跨、超音速流场的数值模拟。

Many experiments were conducted in order to understand the physical phenomena and mechanism after a heat pulse was released in superfluid helium.

在以上的温度范围内进行实验，研究了在热脉冲作用下，发生在超流氦浴中的沸腾现象及其物理机制。

Neutron superfluid vertex in neutron stars is discussed in this paper.

讨论了中子星内中子超流涡旋。

The increase in calcium current occurred within 1 minute of superfusion and the sustained inward holding current was slowly activated after prominent cell swelling.

钙电流的增加发生在灌流后1 min内，而内向性钳制电流在细胞明显膨胀之后缓慢激活。

The activities of superoxide dismutase, the content of malondialdehyde and the apoptosis were determined by flow cytometry.

观察各组细胞经I/R损伤后，细胞内超氧化物歧化酶活性、丙二醛含量的变化情况，并用流式细胞仪检测细胞凋亡率。

In this paper, the flow properties of helicopter landing and taking-off region and its influence on flight safety are introduced first, then the flow of flight deck is simulated using finite element method on the basis of Navier-Stokes equations, and the simulated results are compared with test results. The helicopter flight properties on flight deck is discussed, and it is point...

本文首先介绍了直升机舰载起降区域的气流流动特点及其对飞行的影响，然后以纳维—斯托克斯方程为基础，利用有限元法对甲板区域的气流流动进行了仿真计算，并将仿真结果与实验结果做了对比，分析了直升机在该甲板区域内的飞行特点，指出应重视流场对飞行安全的影响。

According to the request of adopting advanced technology, the main designing has such contents as below:⑴ Designing the two-fluid nozzle that is based on the theory of air-atomize spraying.⑵ Designing and choosing the type of the axial fan that is used to supply assisted airflow to waft droplets that comes from nozzle.⑶ Designing the swaying outfit that can rotate the spray assembly at a speed and inside a angle in order to satisfy the spray request of different crops, different planting states and improve the uniformity of distribution, the deposition of droplet. Here, we select TYV type reduction gear motor to adjust the swaying speed and use course switch to adjust the swaying angle.⑷ Designing the lift outfit that can adjust the height of the spray assembly to satisfy the request of the crops of different tallness, different spraying range. Here, we select cylinder as the main component that can be used as kickstand and controlled easily.⑸ Designing the switch of the power supply that is put out of the greenhouse in order to prevent worker from poisoning. After the mist sprayer being made, the experiment is made to test the function of the greenhouse mist sprayer fully.

根据采用先进施药技术的要求，本研究的设计内容主要有：⑴采用气液两相流喷雾技术，基于气力雾化原理，设计双流体喷头；⑵采用辅助气流输送雾滴，气流源为风机，对风机进行设计、选型；⑶为满足不同作物、不同栽培情况及提高雾滴分布均匀性、沉积性的施药要求，设计能带动喷射部件在一定角度内、以一定转速的旋转摇摆机构，本研究选用调速电机调节其摇摆速度，并利用反向行程开关调节其摇摆角度；⑷为满足不同高度作物、不同射程的施药要求，设计能调节喷射部件高度的升降机构，这里选用气缸为主要构件，既可以起到整机支架的作用，又可方便进行升降、固定控制；⑸设计行程开关的控制电路以及整机的控制系统。

In the circle passage, the pressure is lowest at the point 30～60°away from the inlet of the distributor and the component velocity in tangential direction is greater than that in radial direction.

环形流道内周向压强分布呈非单调变化，在距离气体进口30～60°处压强最低。

The findings indicate that, on the whole, the pattern of load transfer curves of adfreezing stress on a steel pipe pile stem and that of resistance stress on the pile tip are parabola and straight line, respectively; Due to the rheology effect, to different extent, adfreezing stress on the pile stem and resistance stress on the pile tip vary with time and relative displacement of pile-soil, respectively, and the settlement of pile tip varies with time tempestuously within 5 hours of loading, and then approximates to stability.

结果表明：模型钢管桩桩侧冻结力荷载传递函数曲线及桩端阻力荷载传递函数曲线其线状大致分别程抛物线及直线；由于流变效应的影响，桩侧冻结应力及端阻应力随时间有不同程度的变化；桩土相对位移和桩端下沉量开始5h内随时间变化较大，但加载5h后逐渐向稳定方向发展。

In this thesis we study largely two problems in the context of the φ-mapping topological current theory proposed by Prof. Yishi Duan, ranging from inner structure of homotopy in algebraic topology to topological excitations in the atomic Bose-Einstein condensates.

本论文在段一士教授提出的φ映射拓扑流理论框架内研究了两个问题：代数拓扑中同伦理论的内部结构，及原子玻色-爱因斯坦凝聚体中的拓扑激发。。。。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐