内折的
- 与 内折的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The general condition for athermalzing an optical system when the object surface is at finite or infinite distance is deduced in this paper, and the principle and design method of employing a diffractive optical element to athermalize and achromatize an optical system with normalized T-C chart are expounded.
本文推导了物面位于有限和无限距离时实现光学补偿的通用条件,论述了利用归化T-C图设计热补偿和消色差红外光学系统的原理和设计方法,给出了8-12μm波段内、焦距123mm、相对口径F/2.5在20-60℃温度范围内的折衍混合红外光学系统的设计结果和理论评价结果,所述的设计方法可方便地推广到前视红外系统中。
-
An underground unpowered anaerobic reactor for the treatment of rural domestic sewage was studied in this paper, based on the anaerobic biomembrane technology and push-flow theory by using the anaerobic pipeline or baffler reactor full of hollow-sphere fillings.
该文根据厌氧生物膜技术和推流原理,采用内充空心球状填料的地下厌氧管道式或折流式反应器为处理设备,研究了农村生活污水地埋式无动力厌氧达标处理技术。
-
Methods Fourty-seven cases of Pilon bone fracture were were performed with typing according to Ovadia and Beals standard, and Type Ⅰ was used plaster external fixation; Type Ⅱ was used the calcaneum skeletal traction plus manipulative reduction; Type Ⅲ was used open reduction and internal fixation and Ⅳ,Ⅴ were used limited internal fixation combined with outside clamp stand, meanwhile the patient were introduced to functional exercise and efficacy was evaluated.
对47例Pilon胃折患者按Ovadia和Beals标准分型,Ⅰ型采用石膏外固定;Ⅱ型采用跟骨牵引加手法复位外固定;Ⅲ型采用切开复位内固定;Ⅳ、Ⅴ型均采用有限内固定结合外固定支架的方法,术后功能锻炼,并进行疗效评定。
-
Above all, consider combination of 3 kinds of load and different constant load and alterable load effect to compare an effect, gave out representative ferroconcrete component is in give an environment to fall, the affirmatory principle that the reliability of different operating period analysed methodological; to put forward intended performance structure to design reliability level, namely index of reliability of component part of the construction inside intended performance cannot be under the standard; of active standard on foundation of expression of design of reliability of our country structure introduce wear to fold decrease coefficient, gave out the affirmatory method of this coefficient, assure in design phase through this coefficient and achieve target of reliability of component part of the construction inside intended performance not the standard under active standard.
首先,考虑三种荷载组合以及不同恒荷载和可变荷载效应比影响,给出了代表性钢筋混凝土构件在给定环境下、不同使用期的可靠度分析方法;提出了预期使用期结构设计可靠度水平的确定原则,即预期使用期内结构构件可靠度指标不能低于现行规范的标准;在我国结构可靠度设计表达式基础上引入耐久性折减系数,给出了该系数的确定方法,通过该系数在设计阶段保证和实现预期使用期内结构构件可靠度指标不低于现行规范的标准。
-
At this time, loosen the connection screw of standard section with spanner, hang the shaft of hand crane on the upper angle bar, sway the shaft of hand crane upward, separate this standard section from the next section, and lay it in the suspension coop, dismantle the other standard section for the same method, and turn the shaft to another direction, draw the lifting wire rope tightly, the operation staff leave the suspension coop, open the lock stopping instrument, fall the suspension coop to next position and lock the brake instrument, the operation staff return to the top of suspension coop, continually dismantle note: forbid the staff leave on the top of suspension coop or in the coop when the suspension coop is running
8.1折除时,首先将吊笼用停层装置停靠在待拆除的标准节的下两节上,操作人员上到吊笼顶,卷扬机松绳,用小吊杆将顶梁略向上提起,拔出顶梁横销,使顶梁值得徐徐降下,降到拆除节下一节中间框架角处,并重新穿上横销,这时用板手将标准节连接螺栓松开,将手摇起重机小吊杆钩挂在待拆节上框架用钢土,到吊笼内,用同样的方法拆下另一节标准节,然后将吊杆转向不影响升降机运行的方向,收紧起升钢丝绳,操作人员离开吊笼,打开锁止机构,使吊笼下降到下一个拆除位置,并将锁止机构锁死,人员重返笼顶,进行下一拆除循环注意:在吊笼运行时绝不允许有人员留在吊笼顶部或吊笼内
-
When dismantle the machine, firstly, stop the suspension coop on the lower 2 sections of the standard sections, the operation staff go on the suspension coop top, the hoisting machine loosen rope, lift the pillar with small shaft, pull out the horizontal pin of pillar, let the pillar fall slowly to thedismantled section's middle angle bar, insert the horizontal pin again. At this time, loosen the connection screw of standard section with spanner, hang the shaft of hand crane on the upper angle bar, sway the shaft of hand crane upward, separate this standard section from the next section, and lay itin the suspension coop, dismantle the other standard section for the same method, and turn the shaft to another direction, draw the lifting wire rope tightly, the operation staff leave the suspension coop, open the lock stopping instrument, fall the suspension coop to next position and lock the brakeinstrument, the operation staff return to the top of suspension coop, continually dismantle note: forbid the staff leave on the top of suspension coop or in the coop when the suspension coop is running
8.1折除时,首先将吊笼用停层装置停靠在待拆除的标准节的下两节上,操作人员上到吊笼顶,卷扬机松绳,用小吊杆将顶梁略向上提起,拔出顶梁横销,使顶梁值得徐徐降下,降到拆除节下一节中间框架角处,并重新穿上横销,这时用板手将标准节连接螺栓松开,将手摇起重机小吊杆钩挂在待拆节上框架用钢土,到吊笼内,用同样的方法拆下另一节标准节,然后将吊杆转向不影响升降机运行的方向,收紧起升钢丝绳,操作人员离开吊笼,打开锁止机构,使吊笼下降到下一个拆除位置,并将锁止机构锁死,人员重返笼顶,进行下一拆除循环(注意:在吊笼运行时绝不允许有人员留在吊笼顶部或吊笼内
-
The YW(subscript 25G) train corn partments were studied, and passengers and several kinds of barriers (including desks, racks, dosses, seats) were taken into account for airflow. The k-ε turbulence model was applied for numerical simulation of indoor fluid flow and age of air, and the air exchange efficiency was obtained.
笔者以YW(下标 25G)型空调硬卧列车车厢为研究对象,在物理模型中考虑了旅客以及车厢内各障碍物(包括边桌、行李架、床铺、折座)等对流场的影响,采用k-ε湍流模型及数值模拟的方法,对硬卧车厢内流场及空气龄的分布变化规律进行研究,从而得到车厢内的换气效率。
-
Because menstruation is the endometrium caused the formation of capillary rupture, with age, endometrial shedding fatally complete, incomplete, will be deposited in the womb, or the product flow folds in the vaginal area In addition, many inflammatory secretions often left in the uterus and vagina, use Fantasy cardamom product, the sediment left in the reproductive organs will be cleared, the vaginal opening form scums like substances.
因为女性月经是由子宫内膜脱落引起、毛细血管破裂形成的,随着年龄的增长,内膜脱落会变得不完整、不彻底,会在子宫内沉积下来,或积流在阴道皱折部位,另外还有许多炎性分泌物经常在子宫和阴道内遗留,使用天香豆蔻产品后,残留在生殖器官的沉积物会清理出来,在阴道口形成豆腐渣样的物质。
-
After you have finished plastic coated on the back, it is placed in dieblock, this will be the mandril of alignment marks on his line and the bottom side of the cover with the right hand by Mark line folded and wrapped it in tight, let the mandril of the cover.
背面涂完胶后,将其平放于台面上,将分过本的内芯对准封面痕线和底边规矩,用右手按痕线折起,让封面裹紧内芯。
-
Seconel to amorrhic detachment after hot press drum, not bright, fogging, self-good, non-foaming at this heat regionsun, hotmelts from the appearance to the internal deep down the entire can fully accept the role of thermal, matozoa biends a variety of raw materials in irradiated can be amply, the entire layer completely fused, creating a true, strong bond, rather than the surface, light differenc e.with shall not bend or heating occurs from carcasses, popping.
直观以复合体脱离热压滚筒后亮度高,不发雾,平度好,无起泡为基准,在这样的温度区域内,热熔胶从外表到内部深处,整个都可以充分接受热力的作用,胶体内各种原材料共混后的改性可以得到充分的发挥,整个胶层彻底熔融,产生了真正的、牢固的粘结,而非表面的、浅层次的、经不得折弯或再加热出现的离壳、起泡现象。
- 推荐网络例句
-
Do you know, i need you to come back
你知道吗,我需要你回来
-
Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.
1〕 杨银书,王祥生,李德昌。安徽省首次发现嗜群血蜱。
-
Chapter Three: Type classification of DE structure in Sino-Tibetan languages.
第三章汉藏语&的&字结构的类型划分。