英语人>网络例句>内壁 相关的搜索结果
网络例句

内壁

与 内壁 相关的网络例句 [注:此内容来源于网络,仅供参考]

Heating furnace of steel of Lai steel tape transforms nearly 6 years to come through type of accumulation of heat, in producing a course, because a variety of caustic medium such as SO2, H2S are contained inside flue gas conduit, after moving for a long time, conduit wall is rustily below these medium chemistry serious, cause conduit average ply is not worth 1mm, and occurrence bedding face of conduit of local flue gas accumulates rubiginous sodden phenomenon, air leak is serious, increased many and gas use up, and move to heating furnace safety cause menace.

莱钢窄带钢加热炉经过蓄热式改造近6年来,在生产过程中,由于烟气管道内含有SO2、H2S等多种腐蚀性介质,长期运行后,管道内壁在这些介质化学功能下锈蚀严重,造成管道平均厚度不足1mm,而且局部烟气管道出现大面积锈烂现象,漏风严重,增加了大量煤气消耗,且对加热炉平安运行造成威胁。

A powerful current of warm breath issued at regular intervals from the profound cavity of his mouth while in rhythmic resonance the loud strong hale reverberations of his formidable heart thundered rumblingly causing the ground, the summit of the lofty tower and the still loftier walls of the cave to vibrate and tremble.

从他那口腔的深窝里,每隔一定时间就吐出一股强烈温暖的气息;而他那颗坚强的心脏总在响亮、有力而健壮地跳动着,产生有节奏的共鸣,像雷一般轰隆轰隆的,使大地、高耸的塔顶,以及更高的洞穴的内壁都为之震颤。

In actual reactors, the cooling condition outside the hexcan-wall of blocked fuel subassembly is analogous to its counterparts in the SCARABEE BE+ experiments. The upward and downward heat transfer could be neglected, while the radial heat transfer plays a key role in slowdown the accident scenario. As time goes on, the dominant radial heat transfer mechanism is liquidus sodium convection at first, and then gradually transforms into sodium condensation near the inner surface of the hexcan-wall, and finally becomes volume heated boiling pool convection.

对实际快堆中发生全堵的燃料组件而言,其外部的冷却条件与SCARABEE BE+系列实验非常相似;2)堵流组件向上和向下的传热可忽略不计,径向传热对事故有较强的延缓作用;3)随着时间推进,径向传热的主导机理依次为液态钠单相对流、钠蒸汽在组件盒内壁冷凝、体热源沸腾池散热。

Model of animals were established by putting rats in a container with slippy inner wall and half-full of water in it, letting them swimming freely till died of being drowned. Each rat from different groups was killed by breaking its neck except drowning group, then BW and SO_2 was detected, and its chest was cut open rapidly, lung was taken out and weight was measured accurately to count lung coefficient. Its lung appearance was observed and lung tissue was fixed with formalin, which was made into pathology slices with HE staining, and pathology change of the lung tissue was observed;Expression of IL-8 and IL-10 in lung tissue was detected with Immunocytochemistry, and correlation between them was analyzed .

动物模型制作采用将大鼠放入盛有黄河水的内壁光滑的容器内,让其自由泳动自然溺死,除溺水致死组外,各组动物分别在规定的时间点断头处死,行体重和血氧饱和度等指标检测,并在冰盘中迅速开胸取肺,准确称重以计算肺系数,观察各组大鼠肺脏外观,取肺组织福尔马林固定,制成病理切片HE染色,光镜下观察肺组织病理改变;用免疫组化的方法检测肺内IL-8、IL-10的表达,并对其相关性进行分析研究。

MPR and VR were applied in the imaging post-processing. Results: All cases were divided into four groups according to the thoracic CT findings and pathologic results as follows:① spheral caseous pneumonia;② tuberculous granuloma;③ fibrous caseous nodule;④ Focal pulmonary consolidation with cavitation. The spheral lesion appeared inhomogeneous density (44/58). cavitation (14/58) or satellite foci (21/58). Contrast scanning was carried out in 31 cases, of which peripheral or ringshaped enhancement was seen in 15 cases, no enhancement in 9 cases and extensive enhancement was seen in 7 cases.

结果:依据影像学表现、随访结果和病灶的病理改变,将58例球形肺结核分为四种类型:①球形干酪肺炎11例,体积较大(最大直径3~5cm),边缘模糊或毛糙,可见晕征,无强化或环行强化;②结核性肉芽肿19例,软组织密度,形态规则或不规则,边缘清楚或光整,强化模式为均匀强化或厚壁强化;③纤维干酪结节14例,规则球形,边缘光滑锐利,内部密度不均匀,可见钙化,多无强化或薄壁环行强化;④结核空洞14例,干酪空洞或纤维空洞,内壁不光整,可见到引流支气管(2例)。

Combining the previous research on the pollen morphology, the present study indicated that: the plants of Stachyurus shared the common characters in pollen morphology and exine ultrastructure.

结果表明:旌节花属植物花粉形态的共同特征是:花粉粒球形或近球形,三孔沟;外壁具穴状纹饰,穴较细小;外壁内壁分层明显,容易区分,覆盖层光滑,几无附属物,柱状层明显,穿孔较少,不形成半覆盖层。

The results showed: four devices flower pollen sacs, anther wall conforms to the basic, from epidermis, the indoor wall, middle (2-3 layers) and tapetal composition tapetum to glandular type.

对悬铃木小孢子发生及雄配子体发育过程进行了观察,结果表明:花药具4个花粉囊,花药壁发育为基本型,由表皮、药室内壁、中层(2-3层)和绒毡层组成,绒毡层为腺质型。

Based on this principle, the mathematical model of an exothermic reactor is established to caculate Exothermic reator length L corresponding to reation temperature T, reation temperature T corresponding to ammonia mole fraction y and the average internal reactor wall temperature Tave corresponding to exergy output Enet and thermal power output Q. The curves of L-T, T-y, Q/Enet –Tave are drawn with the caculated date which can directly reflect the influence of reactor inlet gas temperature and reactant flow rate on ammonia synthesis reaction for the reactor under the conditions of definite design pressure and hydrogen/nitrogen ratio. Furthermore, the design parameters to realize maximum exergy output and thermal output are presented.

文章分析了储能体系的选择,介绍了氨基热化学储能的基本原理,在此基础上建立了放热反应器的数学模型,计算和绘制出了L-T、T-y以及热量和佣输出与反应器内壁平均温度之间的关系曲线,直观地反映了在一定的设计压力和氢氮比条件下,进气温度和进气流率对放热反应的影响,给出了实现佣最优化和热能最优化的操作参数。

The anther was tetrasporangiate, originated from the stamen primordium. The anther wall was composed of epidermis, fibrous endothelium, middle layer (2~3 layers) and tapetum (1~2 layers).

观光木的花药由花药原基发育而来,具4个小孢子囊,花药壁由表皮、药室内壁、2~3层中层和1~2层绒毡层组成。

Both the two sides superior thyroid arteries were mainly arose from antero-endhymenine wall of genesis arteries (58.45%), inferior thyroid arteries of the thyrocervical trunk from endhymenine wall, and the ima thyroid arteries of genesis arteries all from anterior wall.

甲状腺上动脉源自起源动脉前内壁最多(58.45%);起源于甲状颈干的双侧甲状腺下动脉均源自其内侧壁;甲状腺最下动脉均源自起源动脉前壁。

第21/29页 首页 < ... 17 18 19 20 21 22 23 24 25 ... > 尾页
推荐网络例句

However, as the name(read-only memory)implies, CD disks cannot be written onorchanged in any way.

然而,正如其名字所指出的那样,CD盘不能写,也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口,替代木托盘,免薰蒸,符合欧盟、北美各国对出口货物包装材料的法令要求;喷涂钢托盘适用于重载上货架之用,托盘表面根据需要制作成平板状、波纹状及间隔形式,满足不同的使用要求。

A single payment file can be uploaded from an ERP system to effect all pan-China RMB payments and overseas payments in all currencies.

付款指令文件可从您的 ERP 系统上传到我们的电子银行系统来只是国内及对海外各种币种付款。