内力

The structural design is carries on the design calculation after the plan comparison and appraisal recommendation plan, this stage design primary mission is: The design material analysis and the structure arrangement, the king post endogenic force computation, the pre-stressed steel ties the estimate and the arrangement, the computation king post section geometry characteristic, the steel tie the loss of prestress computation, the king post section intensity checking calculation, the king post nose partial bearing strength checking calculation, the king post distortion checking calculation and part compositions and so on lane board computation.

结构设计是根据方案评比后的推荐方案进行设计计算，这一阶段的设计主要任务是：设计资料分析及构造布置、主梁内力计算、预应力钢束的估算及其布置、计算主梁截面几何特性、钢束预应力损失计算、主梁截面强度验算、主梁端部的局部承压强度验算、主梁变形验算和行车道板计算等部分组成。

Meanwhile,by analyzing the calculation results of NL Method,and using Least Squares Method or Lagrange's Interpolation Polynomial Curves to simulate the relationship between horizontal force and deformation of both Steel-pile Cluster and Rubber Fender separately,the energy allocation rate of Steel-pile Cluster and Rubber Fender can be determined.

采用NL法来计算桩身内力和变形，同时，对NL法计算出的多个结果进行分析，并采用最小二乘法或Lagrange插值多项式曲线分别模拟钢簇桩和橡胶护舷承受的水平力和相应的变形之间的关系来求解钢簇桩和橡胶护舷能量分配比例。

So the main study contents of this thesis are as follows: the load distribution pattern along the length beam and the cross beam in the place of node、 the appropriate matching rigidity of the length and cross beams in the action of same anchorage force and the affection pattern discuss on sloping surfaces dip angle、 beam rigidity 、 anchor-rope angle as well as the position of load which affect the load distribution ratio on length and cross beams. In the end it brings forward lattice beam internal force calculated method on the basis of double parameter groundsill model.

鉴于此，本文主要的研究内容是格构梁节点处荷载沿纵横梁的分配规律、同一锚固力作用下纵横梁合理的匹配刚度以及对格构梁纵横梁荷载分配比值可能存在影响的坡面倾角、梁刚度、锚索夹角、加载位置等因素的影响规律探讨，最后提出基于双参数地基模型的格构梁内力计算方法。

In this article,a simplification of the entire bridge lattice into a "Plate Girder Frame" whose solution can be found by means of the force method is used instead.

在现有计算双梁桥架的内力的方法中，都是将桥式起重机的主梁简化成简支梁来计算的。

In this paper, the dynamic properties of folded plate type latticed shell are studied by modal analysis, response spectrum and time history method with the effects of thinness and slope on dynamic internal forces also discussed.

本文采用振型分解反应谱法和时程分析法对折板式网壳结构的动内力作了研究，计算分析了结构厚度、坡度等参数对动内力的影响。

During the float glass process, the hot glass is gently cooled in the "annealing lehr", which releas

中文名称：浮法玻璃的加工过程中，在退火炉里热融玻璃逐渐冷却，并且释放出内力使得其能够切割并进行进一步的深加工。

During cantilever casting of long span prestressed concrete continuous box beams, the construction control, a complicated and dynamic system engineering, is an important measure for bridges to ensure their lineament and to meet the design requirement of the internal force.

大跨径预应力混凝土连续箱梁悬臂浇筑施工过程中，施工控制是个复杂的动态系统工程，是实现大桥成桥线形、内力满足设计要求的重要手段。

In this paper the stress analysis solution of parallel circular tunnels in elastic ground under any coefficient of lateral pressure is derived, and the stress field and displacement field of parallel circular opening subjected to continuous boundary stresses are first solved, and then the ground pressure and the internal force in lining are obtained, using the displacement compatibility equation between linin...

先求得连续洞周边界应力条件下双圆形洞室的应力场和位移场；再利用衬砌和围岩界面位移协调方程，获得平行圆形隧道的地层压力和衬砌内力公式，并可考虑开挖面的三维效应和洞室自由位移等因素。根据结论公式，对隧道间距、地层性质、衬砌厚度等诸因素进行了讨论，得到了单因素的一般规律，在此基础上，提出了平行圆形隧道最小间距的近似方法，并在某工程中予以应用，得到了满意的结果。本应力分析方法在平行圆形隧道的设计和施工中供作参考。

The internal force produced in live load is calculated by manual loading method.

活载产生的内力采用手工加载的方法计算。

The theory basis is applied for understanding the inner load, displacement, and its varying regulation of the structure.

所述方法基本也适用于密肋楼盖，也为深入理解该类结构的内力、位移及其变化规律提供了一些理论依据。

The objective is to subjugate and discourage the people, because that allows the elite to continue to rule unopposed.

其目的是压制和打击人民的积极性，因为这可以让实权派继续统治不会沦为反对派。

GOD,this is the second time you vanquished me!

天啊，这是第二次你打败了我！