内

Results: Immature cysticerci were found in liver, heart, brain, lungs, tongue, and muscles of limbs and body on the 40 day. On the 80 day, cysticerci were bigger and matured. On the 120 and 150 days, large quantity of mature and alive cysticerci were found in all infected organs except liver in which the cysticerci gradually died. Cysticerci were not found to grow in kidney or spleen all the time.

结果：感染后第40天剖杀家猪，多数脏器和组织，如肝脏、心脏、脑、肺、舌、四肢及驱干肌肉内有未成熟囊尾蚴寄生；感染第80天时各器官及组织内囊尾蚴先后发育成熟，囊尾蚴随感染时间增加而逐渐增大；感染第120天或第150天时，除肝脏外各器官及组织内仍可见大量成熟囊尾蚴，且无死亡和钙化现象，而此时肝脏内囊尾蚴几乎全部死亡和钙化；在实验全过程中，肾脏和脾脏未见囊尾蚴寄生。

Significantly increased MD in right frontal lobe, significantly reduced FA in right external capsule, right caudamen and both thalamus were demonstrated in patients.

左侧内囊膝部、内囊后肢和丘脑MD值与MMSE呈负相关；双侧内囊前肢、左侧外囊、额叶、枕叶相应白质内FA值与MMSE呈正相关。

Feed aprons and stock guide plates with different angles and spacing are being equipped inside the cylinder, the structure can ensure that the material being dried runes along the direction of screwing under the impact of gravitation and keeps for a sufficient maintaining times and dispersity in the cylinder to make the material has sufficient heat exchange with the heat airflow from air heating furnace inside of the cylinder.

三筒烘干机是引进欧洲先进技术，由三个不同直径的同心圆筒彼此相嵌组合而成的。筒内装有不同角度和间距的扬料板和导料板，这种结构能够保证被烘干物料在重力作用下沿着螺旋的运动方向运动，在筒内保持足够的停留时间和充分的分散度，使被烘干物料在筒内与来自热风炉内的热气流进行充分的热交换。

Material is one-time 30~50ml injector 1 pair, one-time glove 1 pair, rubber cap 1 (one-time infusion implement the rubber cap) that go up, the 100~150ml of nose raise fluid that already had had is filled inside clean container, temperature 38~40 ℃. 2 methods little patient takes right skew slope, handlers is abluent both hands wears a glove, open one-time injector, the 50ml injector piston after deciding gastric canal is inside the stomach is abandoned, the tit joins the stomach is in charge of, nose raise fluid is slow enter injector inside, raise gastric canal to come fore-tooth 10~20cm height, have the aid of of fluid of raise letting bazoo is gravitational slowly flow into a stomach inside, warm boiled water rinses conduit after the end, cover with rubber cap finally on the stomach provides terminal. 3 advantages (1) operation goes to the lavatory simply.

为减少误吸的发生，将传统的鼻饲法进行了改良，经临床应用效果满足，现报告如下。1材料一次性30~50ml注射器1副，一次性手套1副，橡皮帽1只(一次性输液器上的橡皮帽)，清洁容器内盛已备好的鼻饲液100~150ml，温度38~40℃。2方法患儿取右侧斜坡位，操作者洗净双手戴上手套，打开一次性注射器，确定胃管在胃内后将50ml注射器的活塞弃去，乳头连接胃管，鼻饲液缓慢倒入注射器内，提高胃管至门齿10~20cm高度，让鼻饲液借助重力缓缓流入胃内，结束后温开水冲洗管道，最后用橡皮帽套上胃管末端。3优点(1)操作简单方便。

Additionally, the growth of the pathogen was obviously affected by cultural media. The morphological characters such as colony color and diameter, and production of fruit body of the fungus growing on PDA, 10% V8, apple leaves dextrose agar and apple leaves extraction dextrose agar media were different. The fungus formed colonies of about 8mm in diameter and did not produce fruit bodies and aerial hyphae in 1 month incubation on PDA. However it formed the similar size colonies as on PDA and produced fruit bodies and aerial hyphae on 10% V8 and LDA media in the same incubation period. Very small colonies (2mm in diameter) and fruit bodies were found on LEDA media in the same incubation condition. These results indicated that successful isolation of M. coronaria from apple leaves depended on suitable isolation method and cultural media as well as fresh samples.

不同培养基上菌落形态、大小和产孢情况差异也很大，培养1个月（25℃）后PDA上菌落黑褐色隆起，表面蚯蚓粪状，无气生菌丝，无子实体和基内菌丝；10% V8培养基上菌落中央隆起，黑褐色，表面生少量气生菌丝，边缘放射状，基内菌丝深褐色，有子实体；苹果叶片葡萄糖琼脂培养基上菌落平坦，黄褐色，表面生茂密的金黄色气生菌丝，基内菌丝深褐色，有子实体；苹果叶片煎汁葡萄糖琼脂培养基上菌落有明显的不规则隆起，黄褐色至黑褐色，表面生少许气生菌丝，菌落生长缓慢，无基内菌丝，分生孢子盘菌落表面生，菌落直径仅2mm左右，而在其他培养基上的菌落直径可达6－8mm，说明培养基质、分离方法均对苹果盘二孢的分离培养和生长发育有明显的影响。

The experimental investigation demonstratesthat (1) the critical perforation energy of pressure pipelines (D/H=15) with pressure OMPa under lateral impact of flat-nose and spherical-nose indenters ranges from 2~3%,the critical perforation energy of empty pipelines is higher 1 ~2% than pipelines filled in water without pressure.

实验研究结果表明：(1)当管梁内注满水，预加工作内压P=0MPa时，对于径厚比D／H=15的厚壁圆管，在平头弹体和球形弹体两种弹体冲击作用下临界穿透破坏能量的降幅在2～3％之间：锥头弹体冲击厚壁空管的临界穿透能量比充水预加内压为P=0MPa的圆管高1～2％：(2)充水管道的预加内压提高，临界穿透能量有一定降低。

The optimal entrance point mostly locate at the root of accessoryprocess which adjacent to the mamillary process from L1 to L4, Theadjustable range of entrance points of the 4 segments almost cover theaccessory process, But at L5, The optimal entrance point is much moreoutside away from the accessory process, just at the middle of thetransverse process and the adjustable range of entrance points islimited.

这与钉尾间距的明显变化相一致，手术时应注意调整螺钉钉尖内偏角度观察椎弓根螺钉进钉点发现内外侧螺钉进钉点与内上、外上螺钉进钉点构成接近矩形的梯形区域，最佳进钉点居于内外进钉点中部。L1到L4最佳进钉点位于副突根部靠近乳突处，随着椎体节段下降，进钉点逐渐移向外侧，L1最佳进钉点基本在副突根部骨嵴内侧缘，L2、L3最佳进钉点基本在副突根部骨嵴上，L4最佳进钉点基本在副突根部骨嵴外侧缘。L1到L4可选进钉点范围几乎均包含副突骨嵴。L5最佳进钉点则明显偏外，多数位于副突根部与横突外端连线的中内1／3。

This research started from the summarizing of former studies about corporate entrepreneurship and intrapreneurship, and then combined it with the practical characteristic of small and medium-sized enterprises to put forward a two-dimensional matrice to classify three types of intrapreneurship practices in small and medium-sized enterprises.

本文研究从以往国内外有关公司创业和内创业的研究综述出发，有效地结合我国中小企业内创业实践特征，提出了划分中小企业内创业类型的二维矩阵，将广大中小企业内创业实践归入了三种常见的类型。

OBJECTIVE: To study the effects of coated and uncoated materials made by elastic nickel-titanium alloy internal fixator on fracture healing and to compare the effects of continuous compressive stress after internal fixator of different types on fracture healing by setting up control group of bone nail internal fixation.

目的：观察表面改性及未改性的弹性镍钛合金内固定材料对骨折愈合的影响。同时设置髓内钉内固定材料做对照，比较弹性内固定材料在持续应压力下对骨折愈合的影响。

Water inside vacuum heat- collection tubes; since the hot medium inside vacuum tubes floats up and cold one goes down due to respective specific gravity, hot and cold mediums convections up and down to cause the heat conduction, furthermore transfer the heat to the related working medium in the heat tubes, the working medium sorbs the potential heat and becomes steam to rise up to the condensing section from the tube heat evaporating section; it emits the heat in condensing section to change again into liquid working medium; it flows back to evaporating section under the gravity action, the emitted heat is transferred into the water inside water tank or tube group by means of the heat-conduction through heat tubes condensing section; it makes the cold water in water tank into hot water in the repeated way.

阳光透过全玻璃真空集热管的外玻璃，照射到涂覆在内玻璃管外表面的选择性吸收涂层上，涂层将太阳的辐射能吸收并转化为热能，通过内玻璃管壁导热，传递给真空集热管内其液态传热介质，由于真空集热管内热的介质因比重小而上浮，冷的介质因比重大而下沉，冷热介质上下对流传热和导热，再通过热管的金属壁导热，将热量传递给热管内其相变工质，工质吸收汽化潜热而变成蒸汽，由热管蒸发段上升到冷凝段，在冷凝段放热冷凝，又变成液态工质，在重力作用下流回蒸发段，所放出的热量通过热管冷凝段金属管壁导热，传递给水箱或联集管内的冷水，周而复始，于是便将水箱内的冷水全部加热成热水。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。