关节的

The intensity of sensory block of the radial, median, ulnar, musculocutaneous and cutaneous nerve of forearm were measured. The intensity of motor blockade of wrist,elbow and shoulder joint and the quality of anesthesia during operation were assessed. the complications were recorded.

观察桡神经、正中神经、尺神经、肌皮神经、前臂内侧皮神经感觉阻滞效果和肩关节、肘关节和腕关节运动阻滞程度，评定手术全程的麻醉效果，记录并发症。

After scanning, signals of tissues from the images of plain and enhancement scannings around the articular cavity in cavity are measured.

扫描结束后，对平扫和增强图像中的关节腔周围组织及关节腔内信号进行测量。

Function restoration between two groups with or without wrist joint instability was compared.

桡骨远端骨折类型、关节面弧度和掌倾角对腕关节不稳定的发生及类型有显著影响。

There are significant anatomical differences between the radio-capitate joint and the normal wrist joint.

头状骨近端和桡尺骨远端形成的关节面其解剖学上明显不同于正常腕关节。

Thejoint mechnism has not singular phenomenon and can be usedfor the shoulder or wrist joint of robot quasi-man-arm.

该关节机构无奇异现象，可用于机器人拟人臂的肩、腕关节。

Objective To observe the distribution in range,size and the regulation of change.Methods Use the finite element method to research the knee joint surface stress and strain of the process of human walking.

目的 观察膝关节关节面在整运动过程中的应力、应变分布范围、小及变化规律方法利用有限元数值模拟方法对行走过程中膝关节关节面应力、应变情况进行分析。

Five patients had remaining joint step-off (1–2 mm) after reduction, but only one developed mild osteoarthritis.

腕关节活动度的恢复较手握力恢复快。60岁以上患者关节活动度与握力均恢复较慢。

The following total hip arthroplasty is difficult due to the residual fractures and the screw holes in the proximal femur which correspond to structure weakness, possible loosening of the femoral implant and artificial stem break through.

而若使用DHS治疗失败后，通常后续治疗以置换人工髋关节为主，然而此类患者却因DHS移除后会在股骨残留螺钉固定洞口，使得股骨结构强度减弱并导致人工关节长度的选用不易，使用不当则会造成骨干骨折、人工关节穿刺等。

The front and rear suspension layout also allows the various joints, including the steering arm joints, to yield in a calibrated manner without this affecting driving precision.

前后悬挂布局也允许各种关节，包括转向臂关节，在经过校准的方式产生影响驾驶没有这个精度。

Description: This project shall adopt the double-mixing-shaft reciprocal rotary distribution design, with the vibration excitation/isolation system to be floating-connected by double-seated spring and hydraulic system adopting highly-dynamic performance proportion, making unnecessary a separate motor for driving and ensuring high compactness of blocks. The machine should make less noise than similar products, operate quickly, reduce the impact upon change of direction and save energy. Each joint should be linked with knuckle bearing and provided with lubricating device to prevent wear and tear. The automatic control system should use PLC and HMI display of operation, providing accurate and explicit detection of faults.

内容说明：本项目采用双搅拌轴往复旋转布料设计，激振隔振系统采用双座双弹簧浮动连接，液压系统采用高动态性能比例，可使砌块成型机不需要单独电机驱动，能保证砌块密实度大；机台噪声比同类机台小，运行快速，降低变向时的冲击配备，节约能源；各关节部位均用关节轴承联结，具备润滑装置不易磨损；自控制系统选用PLC编制控制器，操作人机界面显示，故障准确明确。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。