全尺寸的

Base on the threshold voltage model presented, an intrinsic drain current model in strong inversion region is developed, which can describe the short-channel effects such as DIBL and charge-sharing effect well, and give special considerations for mobility, velocity saturation, channel length modulation and quantum effect. Based on the front interface surface potential model, a formula of unified inversion charge is derived, and an intrinsic drain current model in middle inversion region is developed.

利用所提出的深亚微米FD器件正、背界面表面势模型，建立了一个能够完整描述深亚微米FD器件本征亚阈漏电流特性的模型，能够准确地描述DIBL效应和背沟道漏电效应；利用所提出的阈值电压模型，建立了深亚微米全耗尽器件的本征强反型电流模型，很好地描述包括DIBL效应、电荷分配效应在内的小尺寸效应，对迁移率、速度饱和效应、沟道长度调制效应和量子效应进行了特别的考虑；利用所提出的深亚微米FD器件正界面表面势模型，推导了统一反型层电荷公式，建立了深亚微米FD器件的本征中反型漏电流模型。

The prestressed concrete simple beam compares reinforced concrete beam to compare, the merit includes: Uses the high marking concrete, section minification, the dead weight reduces, may increase the spanning ability; Uses the high strength steel bar, may save the steel products; But raises the sorghum body large scale the crack resistance, increases beam's durability, the concrete total cross-section bearing, has fully displayed the concrete resistant to compression performance superiority, also enhanced Liang's rigidity.

预应力混凝土简支梁较钢筋混凝土梁相比，优点有：采用高标号混凝土，截面尺寸减小，梁体自重减轻，可以增大跨越能力；采用高强度的钢筋，可节约钢材；可大幅度提高梁体的抗裂性，增加梁的耐久性，混凝土全截面受压，充分发挥了混凝土抗压性能的优势，也提高了梁的刚度。

The results show, when polar distance is bigger than the size of cross section of tunnel, the difference of anomalous feature between the corner-sections and wall-sections in tunnel is very small. The apparent resistivity is only related to the distance between section and bodies. The shielding effect of the tunnel is not so evident that the character and value of anomalous are similar with those in full space.

计算结果表明，当坑道内偶极测深的极距大于坑道截面尺寸时，坑道角与坑道面断面异常形态差异不大；视电阻率值只与断面和地质体间的距离有关；坑道空腔的屏蔽效应并不明显，坑道内各个测深断面的异常幅值和形态与全空间中观测结果非常相似。

First backward simulation was made by using population parameter method to quickly get an approximate workblank,and then forward simulation was made by using incremental method to modify the workblank outline for the purpose of getting comparatively accurate outline dimension.

介绍了一种用于冲压毛坯设计的新方法——基于正、反向模拟的毛坯外形设计技术，即先用全量法进行反向模拟，快速得出近似的坯料，再用增量法进行正向模拟修正毛坯的外轮廓，从而得到比较精确的坯料尺寸。

And the paper discuss the effect of wall rock by several different models.

依据实际尺寸和形状对厂房的主要结构部分进行了全三维模拟，并通过建立若干不同的简化模型对围岩的影响进行了探讨。

From theperformance analysis of plastic materials, plastic parts inaccordance with the basic shape and size to start, the wholerationale for choice of methods of injection molding.

从塑料材料的性能分析，根据塑件的基本形状和尺寸入手，全理选择注射的成型方法。

Base Station type Software versionTypes of carrier frequency board adoptedTypes of combiner adoptedWhether had obtained the network license or notIndoor type or outdoor type Whether the master port is separated from the remote-port The maximum carrier frequency capacity of single cabinet The maximum supportable sector numbers of single cabinetWhether it is dual-carrier frequency board or notMust it be paired configuration if it's dual-carrier frequency board (namely, the type of single carrier frequency station could only configure the dual-carrier frequency on hardware) The maximum achievable configuration of a single station of the single cabinetReceiver sensitivity The maximum expand capacity of a single base station (the maximum number of TRX in configuration / the number of cabinets which is required)(fill in according with the three sectors) Top box transmitted power (given separately a grade one combine and a grade two combine) The maximum output power of amplifier (voice, a single logical carrier frequency) The maximum output power of amplifier (EGPRS, a single logical carrier frequency)Whether it has tower-interfaceWhether it has built-in lightning protectionWhether it support the ultra-long cover / whether it need for software support (give simple description that how hardware and software could achieve this) The supporting condition of EGSM (it should be supported including by the carrier frequency, combiner) Dual-band carrier wave (whether it supports the mixed use of 900 M/1800M in the same cabinet) The commonality of duplicate parts Whether it can built-in transmission unitThe single cabinet size (high × width × deep) Installation method Whether it can place against the wallThe basic frame full-configured weight and the supportable number of carrier frequencyThe expansion frame full-configured weight and the supportable number of carrier frequency

基站型号软件版本号采用载频板型号采用合路器型号是否已取得入网许可室内型or室外型是否是主远端分离单机柜最大载频容量单机柜最大支持的扇区数是否是双载频板如是双载频板，是否必须成对配置(即单载频站型只能硬件配置双载频)单机柜可达到的单站最大配置接收机灵敏度单基站最大扩展能力(最大配置TRX数/需机柜数)(按3扇区填写)机顶发射功率(分别给出一级合路与两级合路)功放最大输出功率功放最大输出功率(EGPRS，单个逻辑载频)有无塔放接口有无内置避雷装置是否支持超远覆盖/是否需要软件支持(简单描述软硬件如何实现)EGSM支持情况(包括载频、合路器均应支持)双频段载波（是否支持900M/1800M在同一机柜内混合使用）备件通用性是否可以内置传输单元单机柜尺寸安装方式可否靠墙放置基本架满配重量及支持载频数扩容架满配重量及支持载频数是否支持基本架与扩容架跨扇区满配功耗满配时重量供电方式机柜进出线方式合路器损耗合路能力：几合一单扇区最大支持几载频合路到一副天线/采用几个合路器单扇区载频达到需要增加一副天线时，是否支持两级合路换以不增加天线如两级合路插损为是否支持基带跳频和合成跳频每单个合路器在从低载频数向高载频数扩容时，是否还需要增加硬件可用性指标MTBFMTTR系统中断服务时间硬件是否支持EGPRS本次报价软件版本号开始支持EGPRS的软件版本号其他特点注： 1 应分别填写出来按照本次报价要求所采用的全部BTS型号和采用的合路器型号 2 列出本报价要求的全部室外型基站与高功放单元

Four 8-bit I/O Ports C Three 16-bit Timer/Counters C 256 Bytes Scratch Pad RAM C 8 Interrupt Sources with 4 Priority Levels C Dual Data Pointer Variable Length MOVX for Slow RAM/Peripherals High-speed Architecture C 10 to 40 MHz in Standard Mode 16K/32K Bytes On-Chip ROM Program T80C51RD2 ROMless Versions On-Chip 1024 bytes Expanded RAM C Software Selectable Size (0, 256, 512, 768, 1024 bytes) C 256 Bytes Selected at Reset for AT87C51RB2/RC2 Compatibility Keyboard Interrupt Interface on Port P1 8-bit Clock Prescaler 64K Program and Data Memory Spaces Improved X2 Mode with Independant Selection for CPU and Each Peripheral Programmable Counter Array 5 Channels with: C High-speed Output C Compare/Capture C Pulse Width Modulator C Watchdog Timer Capabilities Asynchronous Port Reset Full Duplex Enhanced UART Dedicated Baud Rate Generator for UART Low EMI Hardware Watchdog Timer (One-time Enabled with Reset-out) Power Control Modes C Idle Mode C Power-down Mode C Power-off Flag Power Supply: 2.7V to 5.5V or 2.7V to 3.6V Temperature Ranges: Commercial (0 to +70C) and Industrial (-40C to +85C) Packages: PDIL40, PLCC44, VQFP44

四8位I / O端口C款三16位定时器/计数器 256字节RAM的便笺簿 8中断源4优先级和C双数据指针MOVX在缓变长内存/外设高速架构为C 10至40 MHz的标准模式16K/32K字节的片上ROM程序T80C51RD2无ROM版本片1024字节扩展RAMC软件可选尺寸（0，256， 512，768，1024字节）C选取在重置为AT87C51RB2/RC2兼容键盘中断接口与独立的选择港口小一8位时钟分频器64K的程序和数据存储器空间的改进X2模式的CPU和256字节每个外设可编程计数器5通道的阵列：C型高速输出C比较/脉宽调制器捕获看门狗定时器复位功能异步端口全双工增强型UART的波特率发生器的UART低EMI硬件看门狗定时器电源控制模式空闲模式C掉电模式C断电旗电源：2.7V至5.5V或2.7V至3.6V温度范围：商业（0到+70 C）和工业（- 40C至+85℃）封装：PDIL40，PLCC44，VQFP44

House selling quite popular, such as Han Fei Youth City ping small double-layer than its small size getting more fierce, the sandwich structure lishui Jiayuan only count only 90 square meters floor area, set up before each duplex structure 150 square meters or so, met the needs of a compact double, and Golden Harbor of slope roof structure will also be thoroughly double-space use, sales rose steadily …… These duplex structure is not sufficient to show there is no market, but positioning is not accurate enough, the most critical or in the area and the total price.

事实上，有相当一部分的市场就像生活在全双工，我们可以看到在市场上，许多小面积的复式楼楼顶楼或变相和坡屋面结构设计等房屋销售很受欢迎，如韩妃小青年城平双层比其小尺寸变得更加激烈，夹心结构丽水佳园唯一指望只有九〇平方米楼面面积，建立在每个复式结构150平方米左右，满足需要的紧凑型双，而黄金港坡屋顶结构也将进行彻底的双空间使用，销售稳步上升……这些复式结构不足以表明没有市场，但定位是不准确的不足，最关键的，或在该地区的总价格。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。