光量

Methods Fourty subjects, 20 anisometrope and 20 emmetrope, the AMP accommodation lag and NRA/PRA were measured after the distance refractive correction.

选取40位受试者，正视者右眼20只，屈光参差者20位，其中屈光参差者高度数眼20只，屈光参差者低度数眼20只，在屈光完全矫正的基础上用主观的测量方法测量其调节幅度、正负相对调节和调节滞后量。

The influence of the signal power, the signal ER, the probe power, the probe wavelength and the drive current of the SOA on λ pk,s and the improvement of the ER is studied in detail by using the multisection model, and considering the nonsymmetry of the gain profile and the shift of the gain peak wavelength along with the carrier density.

采用分段模型，考虑了SOA中增益谱的不对称性以及增益峰值波长随载流子密度的漂移，深入研究了信号光功率，ER，参考光功率，波长以及SOA注入电流对选择信号光波长λpk，s以及消光比改善量的影响。

The results show that the maximum resultant displacement of the Fresnel lens occurred at the corners of the arrays of photovoltaic concentrators for the given HCPV system at all elevation angles.

模拟分析结果显示，对於给定之聚光型太阳能发电系统在任何仰角中，聚光透镜最大之位移量将发生於各个集光器角落之聚光透镜上，并随著风速的增加而增加。

In order to analyze the airborne LiDAR data corresponding to single trees and stand heights in the forestry area, we set up samples to measure tree heights of Alnus formosana, Cryptomeria japonica, and Chamaecyparis formosensis in the Alishan area. We build the Canopy Height Model based on the data from the airborne laser scanning system. Single Tree heights were estimated by averaging the CHM values within a 0.5m radius, and six different sizes of sample stands (5×5, 10×10, 12.5×12.5, 15×15, 17.5×17.5, and 20×20) were set up to extract the average heights within the area as the calculated value.

本研究於阿里山地区设置样区，针对台湾赤杨、柳杉、红桧等树种进行立木树高之量测，配合该样区之空载光达影像资料，建立树冠高度模型(Canopy height model， CHM)，探讨空载LiDAR在森林地区对於单木树高与林分高的量测情形；单株立木高系以样区立木位置为中心，萃取0.5 m 圆形环框范围内之CHM平均值为其推估值；光达林分高则以6种林分面积(5 m×5 m、10 m×10 m、12.5 m×12.5 m、15 m×15 m、17.5 m×17.5 m、20 m×20 m)萃取范围内之CHM平均值为其推估值。

And TM was carefully added to the solution of photo-PAE to form a PSPI solution containing TM. The composite filmcast from PSPI-TM can be developed using NMP. When the content of Ti〓 incomposite film was beyond 3%, a heateddeveloper had to be used for the successful development of the composite film.Compared with corresponding ester-type PSPI, D〓 of PSPI-TM increasedrapidly with the content of TM in the composite.

光刻实验发现这种含TM的PSPI光刻胶膜比相应的酯型PSPI光刻胶膜难显影，一般需NMP这样的强溶解性能的溶剂作为显影液，才能顺利显影，当Ti〓含量大于3％(基于酰亚胺化后PI的量)，必须升高温度才能顺利显影；这种含 Ti的PSPI光刻胶在感光性能上也比相应的酯型PSPI光刻胶低很多倍，形成50％留膜率所需的曝光剂量随TM含量的增加，而大幅度地增加。

Compared with plant density of 150×10^4 planta/hm^2, photosynthesis attenuation rate of traditional plant density of 450×10^4 plants/hm^2 increased by 25.2~43.5 percent point, photosynthesis yield and relative electron transport rate of them decreased 2.95%~20.68% and 10.66%~18.32%, respectively, and the proportion of the reception of photosynthesis active radiation increased upper the layer of flag leaf, and decreased the proportion received lower the layer of flag leaf.

播量为450万株／hm^2处理比150万株／hm^2处理旗叶的光合衰减率提高25.2~43.5个百分点，光合量子产量和相对电子传递速率分别降低2.95%~20.68%和10.66%~18.32%，群体上层的光截获量增加，中下部受光条件较差。

Zincic content (often a 10% to 30%) of the different results from different colored powder, such as zincic of 8% to 2% 1, color cast, commonly known as hongguang powdered gold or red gold; 20% to 30%, color cast, commonly known as green light powder or green gold.

含锌量(一般为10%～30%)的不同可产生不同颜色的金粉，如含锌量8 %～1 2 %，色偏红，俗称红光金粉或红金；20%～30%，色偏青，俗称青光金粉或青金。

To match the boundary conditions, the modified Bessel functions are expanded to the planar wave in the interface. Then the eigenvalue equations of different polarizations are obtained by scalar approximation. At last, the relations between propagation losses and the states of polarizations, the geometric structures of the fiber, the refractive index and thickness of the polymer are calculated.

论文首先给出其等效折射率数学模型，在纤芯和包层中，光场用贝塞尔函数及虚宗量贝塞尔函数的求和表示，在聚合物和金属中用指数函数的求和表示，交界面上采用将虚宗量贝塞尔函数用平面波展开的方法匹配边界条件，然后利用标量近似求出极化D型光纤不同偏振态光场模式的本征值方程，最后通过数值计算得到光纤的传输损耗与抛磨平面和纤芯之间的距离，聚合物粘接材料的折射率和厚度，以及偏振态之间的关系。

The result show that the N elements curbed the transition from anatase phase to rutile phase , Doped-N was in the structure of the TiO2 as the form of Ti-O-N and formed a new bond energy level;N-doped changed the paramagnetic of the characteristics. The paramagnetic resonance spectrum of TiO2 showed anisotropic and showed hyperfine splitting, The Lande factor of Ti3 + combined with the N is 1.956. UV-Vis absorption spectra showed that the photocatalytic ability of photocatalyst TiO2-xNx to expand to the visible region, the sample (3.84wt %) has the highest photo catalytic activity, the adsorption edge extend to 520nm and degradation is 55.54% under the visible light for 1.5h.

研究结果显示，N元素抑制了锐钛矿相向金红石相的转变，阻止了晶粒的长大，掺杂的N元素以O-Ti-N的形式存在于光催化剂结构中，形成了新的能级结构；N掺杂改变了催化剂的顺磁特征，使TiO2的顺磁共振谱线呈现各向异性，发生了超精细分裂，其中g2=1.956，是与N结合的Ti3+的朗德因子；紫外可见光吸收谱表明，催化剂TiO2-xNx的光响应能力拓展到可见光区，光吸收带发生红移；光催化测试结果显示，掺杂量为3.84的TiO2-xNx在可见光区的响应能力最高，吸收波长延伸至520nm，其光催化活性最大，1.5h降解率达到55.54%。

The degradation of methyl orange in a photocatalysis reactor using TiO2-photocatalyst is studied in terms of methyl orange concentration.

确定影响甲基橙光催化氧化的主要影响因素为TiO2光催化剂投加量、氧化剂投加量。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。