光电

Some use of assembly language software, the use of methods todetect interrupt the user requests the key information, accordingto the lift operation to the appropriate floor, a photoelectricsensor-level changes to the SCM count to determine the number offloors, and sent to the digital display.

软件部分使用汇编语言，利用中断方式来检测用户请求的按键信息，根据电梯运行到相应楼层时，光电传感器产生电平变化，送到单片机计数来确定楼层数，并送到数码管进行显示。

This indicates that the novel PS holds a potential to be exploited as the ionizer with low discharge voltage and the special photounit at ambient condition.

结果表明，这种新型多孔硅具有空气环境下低电压离子源和光电响应器件的开发潜力。

Except for plentifully equipped laser telemeter, laser radar, and laser irradiator, multifarious tactical laser weapon s used to attack optoelectronic sensor is plentifully applied in many martial great powers of the world.

抛开已大量装备部队的激光测距机、激光雷达、激光照射器等不谈，用于攻击光电传感器的各类战术激光武器已大量装备于各军事强国。

According to the conclusion,the irrotational displacement isolator which can converse angular vibration to linear vibration is designed.

通过分析振动因素对光电设备成像质量的影响，揭示了振动与成像质量降低之间的关系，得到角振动对成像质量的影响大于线振动的结论；根据结论设计了将角振动转化为线振动的无角位移减振机构。

Kinetic of Irrotational Displacement Isolator for Optoelectronic Platform .

光电平台无角位移减振机构运动分析。

Reference grating formed by electronic oscillating signal and photoelectric conjunction Moire contouring of isohypse fringe based on electronic signal beat freguency principle are reported in the paper.

本文报导用电子振荡信号形成"参考光栅"，基于电信号拍频原理产生等高线条纹的光电结合型莫尔轮廓术。

It is revealed by the related research that human vision system is not only a photoelectric transformer, but also of some ability of preprocess of visual information.

对人类视觉的研究表明，人眼不仅是一个进行光电转换的传感器，而且具有一定的信息加工能力。

The method how to separate the radial jumpiness of the large shaft by three-point method to gain the round error in high precision is showed particularly. In the part of diameter measurement, this paper indicates how to standardize the photomicrosensor and shows the way how to use correction signal correct the measure error of the grating system which is used to measure the rotated angle of the wheel in detail.

文中详细论述了在圆度误差测量中，利用三点法分离大轴支承径向跳动引起的测量误差而获得高精度的圆度误差测量值的方法以及直径测量系统中，光电开关测量精度的标定方法和通过构建误差修正函数对实现滚轮转角测量的圆光栅系统的测量误差进行实时修正的方法。

At the same time, considering the jumpiness or incline caused inaccuracy and pretermission when the capsule moving ahead, two couples of infrared ray and electron transducer were designed to detect the light signal of the corresponding parts of the capsule. After the addition operation compensation and differential coefficient, turning the little different simulation signals of the body and cap of the capsule into digital signals for detection. It is more accurate for detection and stable to the disturbance. Step electromotor was used for the capsules direction turning which solved this problem efficiently. The capsules were ranged in order according to their colors with the cap at the same direction.

同时考虑到胶囊行进过程中跳动、倾斜及随机干扰造成的误判、漏判，设计了两对红外光电传感器用以同时检测胶囊上下两个边缘部位的光信号，两个检测信号经加法运算补偿、微分运算处理，将体现胶囊的帽、体微小几何尺寸差别特征的弱模拟信号直接转变成数字量检测，提高了检测的准确率及抗干扰能力，并由步进电机控制胶囊掉头，有效地解决了胶囊体、帽的位置调整，分色调头排列，达到帽、体一致。

The thermal distributionand an expression of the maximum temperature have been obtained or the first time whenthe Q -switched Nd:YAG laser irradiates upon the PIN junction optoelectronic diode.

得到了Q开关YAG激光与PIN结光电二极管器件相互作用时的热分布、最高温度表达式和对应的实验结果。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。