光

Arc-glow plasma depositing technique is a new surface coating method. With the help of vacuum arc discharge, a cold cathode arc source continually emits ion beams of coating elements with high currency density and high ionizing ratio.Upon the ion bombard and diffusion work on, the surfaces of the parts form deposited layers, diffusion layers. In this study, a commercial magnesium alloy AZ91 was coated with Ti film layer.

加弧辉光离子渗镀技术将辉光放电与弧光放电有机地结合起来，利用辉光放电空心阴极效应使工件迅速升温，同时在真空容器壁上设置一个或多个金属阴极电弧靶源，利用真空电弧放电而不断地发射出高能量、高电流密度、高离化率的欲渗金属离子流，依靠扩散和离子轰击作用快速渗入工件表面层，在工件表面可以形成渗层、镀层、渗镀结合层。

For different surface roughness of electrodes and glycol concentration of glycol/water mixture, pressurized water breakdown experiments are carried out. Experimental results suggest that Mirza's formula is valid and independent of surface roughness and glycol concentration, and it is accumulative for surface polish, glycol additive, and pressurization for the capability to improve electrical breakdown strength. Moreover, the increase of electrical breakdown strength of water dielectric for surface polish is explained with bubble breakdown. Especially, highest stress of 235.5kV/cm observed in glycol/water mixture with a glycol concentration of 80% at a hydrostatic pressure of 12atm is about one time greater than that in pure water at constant pressure.

通过改变电极表面光滑程度和乙二醇浓度，分别进行了加压水介质击穿实验，证实了不同电极表面光滑程度和乙二醇浓度下Mirza关系式仍成立，抛光电极表面、添加乙二醇与加压在提高水介质电击穿能力方面具有可叠加性，将抛光电极表面、添加乙二醇与加压分别进行了比较，特别，在静压12atm、乙二醇浓度80%下，得到实测最高击穿场强为235.5kV/cm，其有效时间归一化后的击穿场强比常压下纯水的相应值提高了112.2%，运用气泡击穿模型对抛光提高水介质击穿场强进行了物理解释。

However, few vanadate has been developed,most of which being used in water splitting, only a few of which for the photocatalytic degradation of organic pollutants.

但目前研制的钒酸盐光催化剂种类较少，且大都应用于光分解水方面，少数用于光催化降解有机污染物。

The dimmer control circuit comprises: three-end bidirectional controllable silicon switch element, comprising grid and turned on by trigger signal of the grid, connecting to AC power supply through lamp load; and a first variable resistor, possessing adjustable resistance and regulating lamp brightness by following modes: changing resistance value of the first variable resistor, changing phase of the trigger signal corresponding to AC voltage waveform, prolonging or shortening turning-on time bucket of three-end bidirectional controllable silicon switch element, thereby changing current provided to the lamp load.

一种调光器及调光控制电路，该调光控制电路包括：三端双向可控硅开关元件，其通过灯负载连接到交流电源，其中，三端双向可控硅开关元件具有栅极，并且由输入到所述栅极的触发信号开启；以及第一可变电阻器，其具有可调节的电阻值，其中，通过以下方式来调节灯负载的亮度：改变第一可变电阻器的电阻值，改变所述触发信号相对于交流电压波形的相位，延长或缩短所述三端双向可控硅开关元件的开启时间段，从而改变了提供给所述灯负载的电流。

Human origins the study of light early, but the understanding of the nature of light has gone through a more lengthy process, the light is actually the wave or the granule, the struggle of the light wave theory and the micellar theory started from the early 17th century,and comes to an end by the light wave-particle duality to the early 20th century.

人类对光的研究起源很早，但对光的本质认识经历了一个较漫长的过程，光究竟是波还是粒子，光的波动说和粒子学说之争从17世纪初开始，至20世纪初以光的波粒二象性告终。

In this dissertation, InGaAs/InGaAsP/InP MQW microdisk laser and its characterization were presented. Some conclusions are as following: the characteristics of lasing threshold was discussed by using rate equation. The dependent relations between threshold and cavity volume, spontaneous emission coupling efficiency β were investigated. The whispering gallery mode and spontaneous emission in a microdisk geometry were then studied. Almost all spontaneous emission was coupled into the lowest order TE mode when the normalized thickness of photonics well was between 0.15 and 0.5. The design principle and device process of InGaAs/InGaAsP/InP MQW microdisk laser were presented. The microdisk lasers with the diameter of 8μm, 4. 5μm and 2μm were succesfully fabricated by using etching techniques. The pulse lasing thresholds for the microdisk with the diameter of 8μm and 4. 5μm were 170μW and 15μW, a record results compared with the published in the literature. The cw lasing threshold for a 2-μm-diameter microdisk was only a few μW. We haven't found similar report up to now. To solve the problem of directional output in a microdisk laser, the power coupling efficiency in a double disk geometry was investigated with the theory of waveguide mode couple. A new structure of electrically pumped microdisk laser with output waveguide was designed, making a foundation for the practical use of microdisk laser.

本文主要研究InGaAs/InGaAsP/InP多量子阱半导体碟型激光器的研制和特性表征，并取得如下结果：利用速率方程理论讨论了激光器激射阈值的特性，分析了阈值与腔体积和自发发射耦合系数β之间的关系；讨论了微碟光子阱结构中的自发发射特性和微碟中WGM模式特性；光子阱结构在其归一化厚度在0.15-0.5之间时，几乎全部自发发射进入到最低阶TE模式中；研究了InGaAs/InGaAsP/InP多量子阱微碟激光器的结构设计原理和器件的制备工艺；利用刻蚀方法成功制备出直径分别为8μm、4.5μm、2μm的碟型微腔激光器；直径8μm和4.5μm的微碟脉冲光泵浦激射阈值分别为170μW、15μW，是目前所见文献报导中比较低的；直径2μm的微碟连续光泵浦激射阈值仅几μW，目前尚未见到达到类似结果的研究报导；为解决微碟激光器激射光定向引出的问题，通过波导耦合模理论分析了双层碟之间功率耦合效率；据此设计了新型带耦合输出波导的电泵浦微腔激光器，为进一步研制可实用的电泵浦微腔激光器打下基础。

The produce conditions are optimized. Using spinning pressure 11~13 MPa, spinning temperature 290 ℃, cooling rate of side blowing 0.55 m/s, relative humidity of side blowing 75 %, cooling temperature of side blowing 22±1℃, wingding angle 7 °, ply process before interlacing jet and after GR2, the good filament for boxes and bags can be produced. FDY, PET, dye, process

本工作研究了影响有光PET纤维染色均匀性的主要因素，找出了生产箱包布专用丝的最佳工艺路线和最佳工艺条件，克服了在普通FDY设备上生产粗旦有光PET长丝的困难。1实验部分1.1原料及其规格、性能聚酯切片：仪化涤纶一厂生产超有光聚酯切片，特性黏度0.68dL/g；纺丝油剂：日本竹本产F-113油剂、常州产FD-1048油剂。1.2主要生产设备干燥机：BM

On entering Wollaston prism lidar backscattering light divides into o-ray and e-ray, which polarization is affected by voltage of Pocksels cell, transmission rate of optical system can be modulated by voltage because of correlation between transmission rate of optical system and polarization direction of light.

激光雷达的后向散射光经Wollastom棱镜分成o光和e光，它们的偏振状态受到Pocksels盒上的电压大小的控制，而整个系统的光学透光与偏振光的偏振角度相关，从而使得系统透过率受到电压的控制。

If the surface is polish firstly use 800-1200 sandpaper to polish and the use the wax and wool polish disk to polish it by 1500-2000rpm low speed.

如果台面光洁度是镜面，先用800-1200目砂纸磨光，然后使用抛光蜡和羊毛抛光圈以1500-2000rpm低速抛光机抛光，再用干净的棉布清洁台面。

A dye recycled photosensitization system has been designed. As a result of studies in the mechanism of electron transfer reaction of xanthene iodonium salt, it is proposed that the dye-recycled process consists of three-step reactions during the photosensitization: The oxidative fading product of dye is formed through electron transfer under irradiation; In the presence of H-donor, product changes into acidic leuco dye product; Product undergoes deprotonization under action of base to regenerate initial dye.

本文设计了染料循环再生的光敏反应体系，通过对占吨碘翁盐电子反应机制的深入研究，提出了占吨染料在光敏反应过程中的染料再生循环，它依次由三个反应过程组成：在光作用下，通过电子转移反应，产生染料氧化褪色体；在H给体存在下，通过H转移反应，使产物转化为染料酸式隐色体；在碱作用下，发生去质子反应，染料再生回复到染料的起始结构。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。